Eufy S320 Mode d'emploi

Catégorie
Réveils
Taper
Mode d'emploi
QUICK START GUIDE
S320 Smart Sock
Anker Innovations Limited. All rights reserved. eufy CARE and the eufy CARE Logo are
trademarks of Anker Innovations Limited, registered in the United States and other countries.
All other trademarks are the property of their respective owners.
51005002874 V04
01
WARNINGS / IMPORTANT SAFETY INSTRUCTIONS
WARNING
This product is not a medical device. It is not intended for use as a medical
device or to replace a medical device. It is not intended to and can not be used
to diagnose, treat, cure, or prevent any disease or other condition, including
but not limited to, Sudden Infant Death Syndrome(SIDS).
Remember:
• This product is meant for use with healthy children up to 18 months of age. If your
children has a pre-existing medical condition, consult your doctor before use.
• This product is an aid, it is not a substitute or should not be substituted for the care
and oversight of an adult or consultation with medical professionals.
• This product is designed and intended for tracking a baby's sleep patterns, sleep
training, and general wellness purposes. False positive or false negative readings
about your baby's heart rate are a potential risk of this product.
• Do not use this product as a diagnostic tool.
• Do not use this product as an excuse for unsafe sleep habits.
SAFETY INSTRUCTIONS
FOR YOUR SAFETY AND THE SAFETY OF THE BABY.
RESPOND IMMEDIATELY WHENEVER A NOTIFICATION SOUNDS.
Always read and obey all important safety messages or instructions mentioned in this
manual and the eufy Baby App.
Strangulation Hazard:
Children get STRANGLED in cords. Keep cords out of the reach of children (more
than 1m / 3ft away). Never use extension cords with AC adapters. Only use the AC
adapters provided.
• Keep sock sensor out of children's mouths.
• For babies with sensitive skin, frequently switch between feet. Take off the sock
immediately in case of redness, swelling, or skin irritation.
• Tear off the protective film on the sock sensor before use.
02 03
System Indicator
Magnetic Charging Pin
SYNC Button
Power Port
Alarm ON/OFF
Icon Indicator Description
Sock Battery Flashing: Low Battery
ON: Charging
Bluetooth Flashing: Disconnected
Baby
Uncomfortable Flashing: Check on Your Baby
Sock Misaligned Flashing: Sock Has Fallen Off
Baby Movement Flashing: Baby is Moving
Ring Light
Working Properly
Low Battery, Disconnected Bluetooth, Sock Has Fallen Off
Check on Your Baby
Snooze Button
AT A GLANCE
Sock Base
04 05
Smart Sock
Sensor Status Indicator
Waiting to Connect
Charging and Connected
Fully Charged and Connected
Sock Sensor
Sock Wrap
HOW THE PRODUCT WORKS
The Smart Sock wraps comfortably on the baby's foot to monitor your
baby's sleep, including real-time sleep status, sleep time, movements
and heart rate, then gives you comprehensive insights of each sleep
session.
06 07
SOCK BASE ALARMS
The Sock Base sends you prompts with sound and light to keep
you aware of your baby's sleep status and when they might be
uncomfortable and require your assistance. You will also get
notifications on your phone via the eufy Baby app.
Snooze the Alarms
To snooze the alarms, pat the Sock Base when the alarm goes off. You
will not receive any alerts or phone notifications for 10 minutes while
Sock Base is snoozed. If there is still an abnormal reading after 10
minutes, you will receive alerts and phone notifications again.
.
Turn Off the Alarms
To turn off the alarms, slide the switch to OFF. Slide the switch back to
ON if you want to receive alerts from Sock Base again.
ON OFF
To turn the phone notifications on or off, go to My Device > Smart
Sock > Notification setting in the eufy Baby app.
08 09
STEP 1. POWER ON SOCK BASE
1. Power on the Sock Base.
Connect the Sock Base to a power outlet, then wait for a few seconds
until the bottom ring light turns green.
2. Charge the Smart Sock.
Place the Smart Sock on the Sock Base. The sensor status indicator will
flash red.
STEP 2. LINK SOCK BASE TO THE EUFY BABY APP
1. Download the eufy Baby app from App Store or Google Play.
2. Scan the QR code on the bottom of Sock Base.
3. Press and hold the SYNC button for 2 seconds, then follow the in-
app instructions to add the Sock Base.
SYNC 2s
Flashing white
Scan QR Code
Scan the QR code on the device.
Select Device Manually
9:4
9:4
eufy Baby
Add Device
10 11
STEP 3. LINK SMART SOCK TO THE EUFY BABY APP
1. Place the Smart Sock on the Sock Base.
2. Follow the in-app instructions to add the Smart Sock:
9:4
1
Add Sock
Next
STEP 4. CHOOSE A SOCK WRAP
Choose the size that provides the right fit — not too tight, not too
loose, and with room for your baby's skin to breathe. This keeps your
baby comfortable and makes the sensors more accurate.
Charging pins
facing the
straight edge.
Charging pins
facing the
wrong side
1. Push the sensor down.
3. Install the sensor on the
chosen wrap.
2. Take out the sensor.
4. Make sure the charging pins
are facing the correct side.
12 13
STEP 5. WEAR SOCK FOR BABY
Wear the sock on either foot of the baby.
• Do not wear the sock too tightly or loosely. Take off the sock
immediately in case of redness, swelling, or skin irritation.
• For babies with sensitive skin, frequently switch between feet.
• To charge the sock, place it on the Sock Base, and make sure the
sock battery indicator on the Sock Base turns red.
Straight edge
The eufy
logo facing
outwards
Inside out Upside down
NOTICE
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of
the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the
separation between the equipment and receiver. (3) Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected. (4) Consult the
dealer or an experienced radio/ TV technician for help.
FCC Radio Frequency Exposure Statement
T8340 has been evaluated and following general RF exposure requirement. The device
can be used in portable exposure condition without restriction. The min separation
distance is 0cm.
T8351 has been evaluated to meet general RF exposure requirements. The device can
be used in fixed/mobile exposure condition. The min separation distance is 20 cm.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables to
maintain compliance with FCC regulations.
The following importer is the responsible party
Company Name: POWER MOBILE LIFE, LLC
Address: 10900 NE 8TH ST, STE 501, BELLEVUE, WA 98004
Telephone: 1-800-988-7973
14 15
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device."
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement."
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
IC RF Statement:
T8340 has been evaluated and following general RF exposure requirement. The device
can be used in portable exposure condition without restriction. The min separation
distance is 0cm.
Le T8340 a été évalué et conforme aux exigences générales d'exposition aux RF.
L'appareil peut être utilisé dans des conditions d'exposition portable sans restriction. La
distance de séparation minimale est de 0 cm.
When using T8351, maintain a distance of 20cm from the body to ensure compliance
with RF exposure requirements.
Lors de l'utilisation du T8351, maintenez une distance de 20 cm du corps afin de vous
conformer aux exigences en matière d'exposition RF.
CUSTOMER SERVICE
Warranty
12-month limited warranty
Call Us
United States
+1 (800) 988 7973 Mon-Sat 6:15AM-6:45PM(PT)
Sun 6:15AM-5:45PM(PT)
United Kingdom
+44 (0) 1604 936 200 Mon-Sun 6:00-19:00
Germany
+49 (0) 69 9579 7960 Mo-Fr 8:00-16:00 Sa 9:00-16:00
Email Us
Customer Support: [email protected]
@EufyOfficial
@EufyOfficial
@EufyOfficial
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

Eufy S320 Mode d'emploi

Catégorie
Réveils
Taper
Mode d'emploi

dans d''autres langues