Moshi Orbito Bluetooth TX Audio Adapter Mode d'emploi

Orbito Bluetooth TX Audio Adapter
Moshi
Marque
Moshi
Modèle
Orbito Bluetooth TX Audio Adapter
Taper
Mode d'emploi
Model name: Orbito,Bluetooth TX audio adapter
Brand Name : moshi
Product designation: Orbito
Pairing
The adapter is paired to the closest Bluetooth device in paring mode. To pair
the adapter, start paring mode on a Bluetooth headphone or speaker, then
activate pairing mode on the flight adapter.
To do this, start with the adapter Power OFF and press and hold the power
button for 4 seconds. When pairing is started, 12 LEDs keep flashing, when
you find the device and start to connect, it will display electronic marquee.
Battery & Charging
The adapter holds 24 hours battery on a full charge. Connect the charger or
powerbank to the USB-C port via the included USB-C cable
Single Socket
Duo Socket
USB-C port for charging
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Full Charged Status
Half Charged Status
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-
exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d' en compromettre le fonctionnement.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Moshi Orbito Bluetooth TX Audio Adapter Mode d'emploi

Orbito Bluetooth TX Audio Adapter
Moshi
Marque
Moshi
Modèle
Orbito Bluetooth TX Audio Adapter
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Autres documents