Buffalo CU485 Manuel utilisateur

Taper
Manuel utilisateur
Model • Modèle • Modell • Modello • Modelo • Malli:
CU485 / CU486
Induction
food warmer
Instruction manual
2
EN Telephone Helpline: 0845 146 2887
Safety Instructions
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your Buffalo product.
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
• Not suitable for outdoor use.
Caution! Hot surface!
• DO NOT immerse the appliance in water.
• DO NOT clean with jet/pressure washers.
• DO NOT leave the appliance unattended during operation.
• DO NOT move the appliance during cooking or with hot
cookware on top of it.
• DO NOT place empty cookware on the appliance.
• Do NOT place the appliance near objects that may be affected
by a magnetic field such as TVs, radios, bank cards, etc.
DO NOT place any magnetic objects, aluminium foil and plastic
vessels on the glass surface during operation.
• DO NOT place metal objects such as knives, forks, and spoons
on the surface as they may become hot during use.
• People with a pacemaker fitted should not use the appliance
and keep a minimum of 60cm from the appliance during
operation.
3
EN
Telephone Helpline: 0845 146 2887
• If the glass surface is cracked disconnect from the power
supply and consult your Buffalo agent or recommended
qualified technician.
• Always switch off and disconnect the power supply to the
appliance when not in use.
• Keep all packaging away from children. Dispose of the
packaging in accordance to the regulations of local authorities.
If the power cord is damaged, it must be replaced by a Buffalo
agent or a recommended qualified technician in order to avoid
a hazard.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play
with the appliance.
• This appliance is not intended to be operated by means of an
external timer or separate remote-control system.
BUFFALO recommend that this appliance should be periodically
tested (at least annually) by a Competent Person. Testing
should include, but not be limited to: Visual Inspection,
Polarity Test, Earth Continuity, Insulation Continuity and
Functional Testing.
• BUFFALO recommend that this product is connected to a
circuit protected by an appropriate RCD (Residual Current
Device).
Induction Cooking
Induction cooking is a very efficient method of cooking as it reduces heat loss between the pan and the
atmosphere by as much as 40%. This makes it extremely energy efficient, as well as offering immediate
heat-up, unlike traditional heating methods which require time to get to temperature.
The Induction cooker works by creating a magnetic field within suitable cookware, which causes an
instant build-up of heat to cook the food.
4
EN Telephone Helpline: 0845 146 2887
Pack Contents
The following is included:
Induction food warmer Instruction manual
Buffalo prides itself on quality and service, ensuring that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your Buffalo dealer immediately.
Installation
Place the unit on a heat-resistant surface. Avoid placing it on or close to easily flammable materials.
Maintain a distance of 20cm (7 inches) between the appliance and walls or other objects for ventilation.
Keep all ventilation openings in the appliance clear of obstruction.
Cookware
Suitable cookware includes:
All magnetic pans such as Vogue Stainless Steel or
Triwall pans.
Mild steel or plain steel (black iron) pans
Enamelled/non-enamelled cast iron and iron pans
Cookware diameter: 12cm - 26cm
Unsuitable cookware includes:
Cookware with a diameter less than 12cm
Ceramic or glass cookware
Stainless steel with no/weak magnetism, aluminium,
bronze or copper cookware unless marked as
suitable for induction cooking
Cookware with feet
Cookware with a rounded bottom (e.g. wok)
Operation
This appliance is intended for heating and keeping food warm in suitable chafing dishes or directly via
cookware. Any other use may lead to damage of the appliance or personal injury.
This appliance is also designed to suit with the Olympia induction chafer (Model FT038 matches Model
CU485; Model FT037 matches Model CU486).
1. Place suitable cookware on to the centre of the glass plate.
2. Connect the appliance to the mains power supply.
3. Turn the thermostat to select temperature. The temperature will appear on the display.
4. After use, turn the thermostat to “0” to switch off.
Auto shut-off: The appliance will shut off automatically when left idle for about 4 hours.
Note: If unsuitable cookware or no cookware is present the appliance will beep constantly and the
display will show “E0”.
Note: During operation, take care of your rings, watches and similar objects as they may become hot.
5
EN
Telephone Helpline: 0845 146 2887
Overheat protection function
If the pan becomes too hot the appliance will switch off, a buzzer will sound and the display will show “E2”.
Should this happen, allow the appliance to cool before restarting.
Cleaning, Care & Maintenance
Disconnect from the power supply and allow the appliance to cool before cleaning and maintenance.
Use warm, soapy water and a damp cloth to clean the appliance.
DO NOT use abrasive cleaners or pads.
Dry thoroughly after cleaning.
Do not use the glass surface for storage purposes.
Troubleshooting
A qualified technician should carry out repairs if required.
Fault Probable Cause Solution
The unit is not working The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug or lead is damaged Replace plug or lead
Fuse in the plug has blown Replace the fuse
Mains power supply fault Check mains power supply
Unsuitable cookware Replace with suitable cookware
“E0” on Display Unsuitable cookware / no
cookware
Replace with suitable cookware
“E1” on Display Appliance has overheated Check ventilation slots for blockage. Allow to
cool before attempting to use again
“E2” on Display Temperature of pan is too
high (Pan is dry or empty)
Remove cookware. Allow to cool before
attempting to use again
“E3” on Display Input voltage is too high/
low
Make sure the mains power supply is suitable
for the appliance
Technical Specifications
Note: Due to our continuing program of research and development, the specifications herein may be
subject to change without notice.
Model Voltage Power Current Operating
frequency
Dimensions
h x w x d (mm) Weight
CU485 220-240V~
50-60Hz 1000W 5A 21-24kHz 61 x 462 x 335 5.01kg
CU486 220-240V~
50-60Hz 1000W 5A 21-24kHz 61 x 530 x 325 6.81kg
6
EN Telephone Helpline: 0845 146 2887
Electrical Wiring
This appliance is supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
Live wire (coloured brown) to terminal marked L
Neutral wire (coloured blue) to terminal marked N
Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible for
waste disposal in your area.
Buffalo parts have undergone strict product testing in order to comply with
regulatory standards and specifications set by international, independent, and
federal authorities.
Buffalo products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of Buffalo.
Every effort is made to ensure all details are correct at the time of going to press, however, Buffalo reserves the right to
change specifications without notice.
DECLARATION OF CONFORMITY
Conformiteitsverklaring Déclaration de conformité Konformitätserklärung Dichiarazione di conformità
Declaración de conformidad
Equipment Type Uitrustingstype • Type d'équipement Gerätetyp
Tipo di apparecchiatura Tipo de equipo
Model Modèle Modell Modello
Modelo
Induction Food Warmer
Large Induction Food Warmer
CU485 (& -E)
CU486 (& -E)
Application of Territory Legislation &
Council Directives(s)
Toepassing van Europese Richtlijn(en)
• Application de la/des directive(s) du
Conseil Anwendbare EU-Richtlinie(n)
Applicazione delle Direttive
• Aplicación de la(s) directiva(s) del
consejo
Electrical Equipment (Safety) Regulations 2016
(BS) EN 60335-1:2012 + A11:2014 +A13:2017
(BS) EN 60335-2-36:2002 +A1:2004 +A2:2008
(BS) EN 62233:2008
Electro-Magnetic Compatibility (EMC) Directive 2014/30/EU - recast of 2004/108/EC
Electromagnetic Compatibility Regulations 2016 (S.I. 2016/1091)
(BS) EN 55014-1: 2017
(BS) EN 55014-2:2015
(BS) EN IEC 61000-3-2: 2019
(BS) EN 61000-3-3:2013
Restriction of Hazardous Substances Directive
(RoHS) 2015/863 amending Annex II to Directive 2011/65/EU
Restriction of the Use of Certain Hazardous
Substances in Electrical and Electronic
Equipment Regulations 2012 (S.I. 2012/3032)
Regulation (EC) 1275/2008 - Standby and off mode power consumption (2019)
(BS) EN 50564:2011
Producer Name Naam fabrikant Nom du producteur Name des Herstellers
Nome del produttore Nombre del fabricante
Buffalo
I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s)
and Standard(s).
Ik, de ondergetekende, verklaar hierbij dat de hierboven gespecificeerde uitrusting goedgekeurd is volgens de bovenstaande
Richtlijn(en) en Standaard(en).
Je soussigné, confirme la conformité de l'équipement cité dans la présente à la / aux Directive(s) et Norme(s) ci-dessus
Ich, der/die Unterzeichnende, erkläre hiermit, dass das oben angegebene Gerät der/den oben angeführten Richtlinie(n) und
Norm(en) entspricht.
Il sottoscritto dichiara che l'apparecchiatura di sopra specificata è conforme alle Direttive e agli Standard sopra riportati.
El abajo firmante declara por la presente que el equipo arriba especificado está en conformidad con la(s) directiva(s) y
estándar(es) arriba mencionadas.
Date • Data • Date • Datum • Data •
Fecha • Data
5th December 2022
Signature Handtekening • Signature
Unterschrift Firma • Firma
Full Name Volledige naam • Nom et
prénom Vollständiger Name • Nome
completo Nombre completo
Ashley Hooper
Eoghan Donnellan
Position Functie Fonction • Position
Qualifica Posición
Technical & Quality Manager
Commercial Manager/ Importer
Producer Address • Adres fabrikant •
Adresse du producteur • Anschrift des
Herstellers • Indirizzo del produttore •
Dirección del fabricante
Fourth Way,
Avonmouth,
Bristol,
BS11 8TB
United Kingdom
Unit 9003,
Blarney Business Park,
Blarney,
Co. Cork
Ireland
DocuSign Envelope ID: 258C6EF8-D4AD-4593-83AE-CD77DC95D7E1
CU485-CU486_EN_A5_v1_2022/12/15
http://www.buffalo-appliances.com/
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Buffalo CU485 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues