AUDI SCON2
Installation:
SCON2 is placed in the cars like in bellow picture
Description:
SCON2 is a Rear Seat Remote that can be used to control convenience and
infotainment functions: air conditioner parameters or media playback, from
the rear cabin.
CAUTION
– Prevent the Rear Seat Remote from coming into contact with liquids.
Note
– Please note that the Rear Seat Remote can only be used when the
ignition is switched
on and within range of the vehicle’s active Wi-Fi hotspot.
– Please note that the Wi-Fi connection does not enable you to use the
Internet.
– Signals from Bluetooth devices and Wi-Fi hotspots within range of the
vehicle can interfere with the in-car Wi-Fi services. If several Bluetooth
devices and Wi-Fi hotspots
are within range of the vehicle, the data transmission rates may be reduced,
the connection may be lost and there may be restrictions to media
broadcasts.
Overview
Rear Seat Remote: Overview
Bellow you can find Menus available for SCON2
’
CERTIFICATION INFORMATION
For EU / EFTA countries:
Radio Equipment Directive – Declaration of Conformity
Hereby, Harman Becker Automotive Systems GmbH declares that the radio
Equipment types SCON2 is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet
Address: (*1)
(*1) http://www.harman.com/compliance
WLAN: 2400 - 2483,5 MHz <20 dBm
WLAN: 5170 - 5835 MHz <20 dBm
Manufacturer:
Harman Becker Automotive Systems GmbH
Becker-Goering-Strasse 16
76307 Karlsbad,
Germany
FCC / ISED statement
Model: SCON2
FCC ID: T8GSCON2
IC: 6434A-SCON2
Modification statement
SCON2 has not approved any changes or modifications to this device by the user. Any changes
or modifications could void the user’s authority to operate the equipment.
SCON2 n’approuve aucune modification apportée à l’appareil par l’utilisateur, quelle qu’en soit la
nature. Tout changement ou modification peuvent annuler le droit d’utilisation de l’appareil par
l’utilisateur.
Interference statement
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Wireless notice:
This device complies with FCC/ISED radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS‐102 of
the ISED radio frequency (RF) Exposure rules. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
WARNING! This device must be installed and used at a distance >5 cm from the body.
Le présent appareil est conforme à l'exposition aux radiations FCC / ISED définies pour un
environnement non contrôlé et répond aux directives d'exposition de la fréquence de la FCC
radiofréquence (RF) et RSS‐102 de la fréquence radio (RF) ISED règles d'exposition.
L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne ou
autre émetteur.
ATTENTION! Ce produit doit être installé de façon à garantir une distance minimale de séparation de
5 cm ou plus de tout corps humain
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme canadienne ICES-003.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
dans d''autres langues
- English: Audi Scon2 Operating instructions
Autres documents
-
Harman NTG7 Manuel utilisateur
-
-
LG NDHKANBN0A2 Manuel utilisateur
-
Eurotech DynaGATE 20-30 Le manuel du propriétaire
-
-
-
BMW IDC23H Manuel utilisateur
-
-
-