L19WD Series
3
Important Safeguards
In addition to the careful attention devoted to quality standards in the manufacturing process of your video
product, safety is a major factor in the design of every instrument. However, safety is your responsibility
too. This sheet lists important information that will help to assure your enjoyment and proper use of the
video product and accessory equipment. Please read them carefully before operating and using your
video product.
Installation
1. Read and Follow Instructions - All the safety
and operating instructions should be read
before the video product is operated. Follow all
operating instructions.
2. Retain Instructions - The safety and operating
instructions should be retained for future
reference.
3. Heed Warnings - Comply with all warnings on
the video product and in the operating
instructions.
4. Polarization - Do not defeat the safety purpose
of the polarized or grounding-type plug.
5. Power Sources - This video product should be
operated only from the type of power source
indicated on the marking label. If you are not
sure of the type of power supply to your
location, consult your video dealer or local
power company. For video products intended to
operate from battery power, or other sources,
refer to the operating instructions.
6. Overloading - Do not overload wall outlets of
extension cords as this can result in the risk of
fire or electric shock. Overloaded AC outlets,
extension cords, frayed power cords, damaged
or cracked wire insulation, and broken plugs are
dangerous. They may result in a shock or fire
hazard. Periodically examine the cord, and if its
appearance indicates damage or deteriorated
insulation, have it replaced by your service
technician.
7. Power-Cord Protection - Power supply cords
should be routed so that they are not likely to be
walked on or pinched by items placed upon or
against them, paying particular attention to
cords at plugs, convenience receptacles, and
the point where they exit from the video product.
8. Ventilation - Slots and openings in the case
are provided for ventilation to ensure reliable
operation of the video product and to protect
it from overheating. These openings must not
be blocked or covered. The openings should
never be blocked by placing the video
equipment on a bed, sofa, rug, or other
similar surface. This video product should
never be placed near or over a radiator or
heat register. This video product should not
be placed in a built-in installation such as a
bookcase or rack unless proper ventilation is
provided or the video product manufacturer’s
instructions have been followed.
9. Camera Extension Cables – Check the
rating of your extension cable(s) to verify
compliance with your local authority
regulations prior to installation.
10. Water and Moisture - Do not use this video
product near water. For example, near a bath
tub, wash bowl, kitchen sink or laundry tub, in
a wet basement, near a swimming pool and
the like.
Caution: Maintain electrical safety. Power line
operated equipment or accessories
connected to this unit should bear the UL
listing mark of CSA certification mark on the
accessory itself and should not be modified
so as to defeat the safety features. This will
help avoid any potential hazard from electrical
shock or fire. If in doubt, contact qualified
service personnel.
11. Accessories - Do not place this video
equipment on an unstable cart, stand, tripod,
or table.
Use this video product only with
a cart, stand, tripod, bracket, or
table recommended by the
manufacturer or sold with the
video product. Any mounting of
the product should follow the
manufacturer’s instructions and
use a mounting accessory
recommended by the
manufacturer
o A polarized plug has two blades with
one wider than the other.
o A grounding type plug has two
blades and a third grounding prong.
o The wide blade or the third prong is
provided for your safety.
o If the provided plug does not fit into
your outlet, consult an electrician for
re
lacement of the obsolete outlet