14 ENGLISH
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous
substances in electric and electronic equipment as well as their waste disposal. The symbol with the
crossed dustbin shown on the package indicates that the product at the end of its service life shall be
collected as separate waste. Therefore, any products that have reached the end of their useful life must
be given to waste disposal centres specialising in separate collection of waste electrical and electronic
equipment, or given back to the retailer at the time of purchasing new similar equipment, on a one for one
basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled,
treated and disposed of in an environmentally compatible way contributes to preventing possible nega-
tive effects on the environment and health and optimises the recycling and reuse of components making
up the apparatus. Abusive disposal of the product by the user involves application of the administrative
sanctions according to the laws.
failure of the warranty, and may cause damage to users or their properties.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The air conditioner does not
work.
There is no electricity. Turn it on after connecting it to a
socket with electricity.
The overflow indicator displays "FL". Discharge the water inside.
The ambient temperature is too
low or too high
Recommend to use the machine in at
the temperature of 7-35 0C (44-95 0F).
In cooling mode, the room
temperature is lower than the set
temperature; in heating mode,
the room temperature is higher
than the set temperature.
Change the set temperature.
In dehumidification mode, the
ambient temperature is low.
The machine is placed in a room with
an ambient temperature of greater
than 17 0C (62 0F).
The cooling effect is not good
There is direct sunlight. Pull the curtains.
Doors or windows are open; there
are a lot of people; or in cooling
mode, there are other sources
of heat.
Close doors and windows, and add
new air conditioner.
The filter screen is dirty. Clean or replace the filter screen.
The air inlet or outlet is blocked. Clear obstructions.
Big Noise The air conditioner is not placed
on a flat surface.
Put the air conditioner on a flat and
hard place (to reduce noise).
Compressor does not work. Overheat protection starts.
Wait for 3 minutes until the temper-
ature is lowered, and then restart
the machine.
The remote control does not
work.
The distance between the
machine and the remote control
is too far.
Let the remote control get close to
the air conditioner, and make sure
that the remote control directly
faces to the direction of the remote
control receiver.
The remote control is not aligned
with the direction of the remote
control receiver.
Batteries are dead. Replace batteries.
Displays 'E1'. The pipe temperature sensor is
abnormal.
Check the pipe temperature sensor
and related circuitry.
Displays 'E2' The room temperature sensor is
abnormal.
Check the room temperature sen-
sor and related circuitry.