ADEPT INDUSTRIES V2 Manuel utilisateur

V2
Marque
ADEPT INDUSTRIES
Modèle
V2
Taper
Manuel utilisateur
eWheels V2 user manual
1. Power on: EWheels will display the current battery level and automatically enter the braking
state.
2. Press the SPEED_UP button on the remote control and the eWheels begins to move. As you
advance, press the buttons SPEED_UP and
SPEED_DOWN on the remote control to speed up or slow down. Whenever the STOP button on
the remote control is pressed, eWheels
STOP.
3. Pressing the STOP button on the remote control for more than three seconds causes eWheels
to unbrake and be in a free state.
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:This device may not cause harmful interference, and
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
eceiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
- English: "
This device complies with Industry Canada licence-exempt RSS standard(
s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device."
- French:"
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée
aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement."
  • Page 1 1
  • Page 2 2

ADEPT INDUSTRIES V2 Manuel utilisateur

V2
Marque
ADEPT INDUSTRIES
Modèle
V2
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents