TECHNICAL FILE
R03.001_10/09/2012
Novolistel® 3 Stainless steel
Cleaning and maintenance
Page 3 of 4
1 2 3 4 5
As a ooring separator
Como remate de
peldaño o encimera
1 2 3 4 5
1. Spread a big amount of thin-set mortar on the surface to be tiled.
2. Then, place the prole and press it so the thin-set mortar passes through the holes of the anchoring
wing.
3. Place a tile on the anchoring wing and press it to get an optimal contact with the thin-set mortar.
4. Repeat the the previous step by placing tiles both sides the prole until the installation is complete.
5. Finally, clean the leftover material, remove the protective lm if necessary and let dry.
* If you are planning on polishing the oor, install the prole slightly below the tile.
To see the video, capture this
image with your mobile phone
(QR code reader software is ne-
cessary) or click on it.
1. Spread a big amount of thin-set mortar on the riser
2. Tile the riser.
3. Then, spread a big amount of thin-set mortar on the tread and align the prole on its vertex (Do not
let overhang, the leverage may remove the step and the tiles). Then press it so the thin-set mortar
passes through the holes of the anchoring wing
4. Place a tile on the tread, align it to the prole and press it to ensure a perfect adhesion. Continue
tiling.
5. Clean the leftover material, remove the protective lm if necessary and let dry
It’s necessary the immediate cleaning of the material after its installation to avoid that remainings of
mortar, concrete or iron particles from wool or tool could cause corrosion.
For outdoor applications, such as facades, the rain is an efcient cleaner. Pay special attention to
difcult access areas and be sure you remove all the remainings of dust and the rest of elements. You
can do this cleaning once per month.
For indoor applications, you can use water with detergent or liquid soap to remove dirtiness and
possible ngerprints marked on the surface. In highly brilliant nishes, you can use a glass cleaner.
There are specic cleaners in the markets for stainless steel which clean the material and reduce
possible stains. Whenever you clean stainless steel, ensure you rinse it well and dry totally to prevent
fogging.
Steel wool or similar products, are not recommended because they could scratch the surface and
create pitting corrosion. Pay special attention while using materials containing chlorides, they are not
indicated because could oxidize the material. Hydrochloric acid or iron products in a long contact with
the material are neither recommended. Do not use cleaners for common steel for the cleaning of
stainless steel.