VTech DJ Beat Boxer™ Manuel utilisateur

Marque: VTech

Modèle: DJ Beat Boxer™

Catégorie: Jouets

Taper: Manuel utilisateur

Instruction Manual

INTRODUCTION

Thank you for purchasing the DJ Beat BoxerTM!

I’m a music-mixing pupper. Start the music mixing by pressing my

headphones. Scratch my head, boop my nose and pat my paw for

more incredible sounds. It’s time to party!

Forehead Touch Pad

Nose Button

Right Headphone

Button

Recording

Button

Mic

Left Headphone

Button

Paw Touch Pad

Off/Low/High

Volume Switch

INCLUDED IN THE PACKAGE

• DJ Beat BoxerTM

• Quick Start Guide

WARNING

All packing materials such as tape, plastic sheets, packaging locks,

removable tags, cable ties, cords and packaging screws are not part

of this toy, and should be discarded for your child’s safety.

NOTE

Please keep the guide as it contains important information.

ATTENTION

Pour la sécurité de votre enfant, débarrassez- vous de tous les

produits d’emballage tels que rubans adhésifs, feuilles de plastique,

attaches, étiquettes et vis d’emballage. Ils ne font pas partie du

jouet.

NOTE

Il est conseillé de conserver ce guide des parents car il comporte

des informations importantes.

Rotate the packaging lock counterclockwise

for 90 degrees.

Pull out the packaging lock.

Unlock the Packaging Locks

GETTING STARTED

How to Exit Try-Me Mode

DJ Beat Boxer™ is in Try-Me mode in the packaging.

Slide the Off/Low/High Volume Switch to the Off position to turn

the unit Off. Then, turn the unit On again to exit Try-Me mode.

Battery Removal and Installation

1. Make sure the unit is turned Off.

2. Find the battery cover on the back of the

unit, use a screwdriver to loosen the screw

and then open the battery box.

3. Remove old batteries by pulling up on one

end of each battery.

4. Install 4 new AA (AM-3/LR6) batteries following the diagram

inside the battery box. (For best performance, alkaline

batteries or fully charged Ni-MH rechargeable batteries are

recommended).

5. Replace the battery cover and tighten the screw to secure.

WARNING:

Adult assembly required for battery installation.

Keep batteries out of reach of children.

ATTENTION :

Les piles ou accumulateurs doivent être installés par un adulte.

Tenir les piles ou accumulateurs hors de portée des enfants.

IMPORTANT: BATTERY INFORMATION

• Insert batteries with the correct polarity (+ and -).

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.

• Only batteries of the same or equivalent type as recommended

are to be used.

• Do not short-circuit the supply terminals.

• Remove batteries during long periods of non-use.

• Remove exhausted batteries from the toy.

• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.

RECHARGEABLE BATTERIES

• Remove rechargeable batteries (if removable) from the toy before

charging.

• Rechargeable batteries are only to be charged under

adult supervision.

• Do not charge non-rechargeable batteries.

IMPORTANT : INFORMATIONS CONCERNANT LES PILES

Les piles fournies avec le produit permettent de tester le jouet en

magasin mais ne sont pas des piles longue durée.

• Mettre en place les piles ou les accumulateurs en respectant les

polarités + et –.

• Ne pas mélanger des piles ou des accumulateurs neufs avec des

usagés.

• Ne pas mélanger différents types de piles : alcalines, zinc-carbone

et rechargeables.

• Seules des piles du type recommandé doivent être utilisées.

• Ne pas mettre les bornes d’une pile ou d’un accumulateur en

court-circuit (en reliant directement le + et le –).

• Retirer les piles ou les accumulateurs en cas de non-utilisation

prolongée.

• Enlever les piles ou les accumulateurs usagés du jouet.

• Ne les jeter ni au feu ni dans la nature.

PILES RECHARGEABLES

• Enlever, lorsque c’est possible, les accumulateurs du jouet pour

les recharger.

• Les accumulateurs ne doivent être chargés que sous la surveil-

lance d’un adulte.

• Ne pas tenter de recharger des piles non rechargeables.

PRODUCT FEATURES

1. Off/Low/High Volume Switch

Slide the Off/Low/High Volume Switch to either

Low or High to turn the unit On. To turn the unit

Off, slide the switch to Off.

2. Change Modes with the Nose Button

Press and hold the Nose Button to choose

different play modes.

Press and release the Nose Button to hear

cool sounds in each mode.

3. Making Recordings

Press and hold the Record Button in DJ’s ear to record and

the headphones will light up red. DJ will start recording when

she detects sound, and the headphones will light up green. The

recording will play when you finish recording.

Press and release the Record Button to hear your recording

and add it to the music.

4. Automatic Shut-Off

To preserve battery life, the unit will automatically power off after

several seconds without input. The unit can be turned on again

by pressing the Nose Button, Left Headphone Button and

Right Headphone Button.

If the unit repeatedly shut off or has abnormal responses, please

insert new batteries and try again.

ACTIVITIES

1. Beatbox Mode

Pick and pause a melody

Add beatbox sound effects

Tap to the beat Record voice or sounds

Add cool sound effects

Layer on and pause an

extra beat, add your

recorded sound/voice

2. Music Mixing Mode

Pick and pause a tune Layer on and pause some

harmony, add your recorded

sound/voice

Add music sound effects Add cool sound effects

Tap to the beat Record voice or sounds

3. Nurturing Mode

Play some funny sounds Hear your recorded sound/

voice

Play cute puppy responses Play cute and funny sounds

Play cute puppy responses Record voice or sounds

CARE & MAINTENANCE

1. Keep the unit clean by wiping it with a slightly damp cloth.

2. Keep the unit out of direct sunlight and away from any direct heat

sources.

3. Remove the batteries if the unit will not be in use for an extended

period of time.

4. Do not drop the unit on hard surfaces and do not expose the unit

to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please

follow these steps:

1. Turn the unit Off.

2. Interrupt the power supply by removing the batteries.

3. Let the unit stand for a few minutes, then replace the batteries.

4. Turn the unit On. The unit should now be ready to use again.

5. If the unit still does not work, install a brand new set of batteries.

IMPORTANT NOTE:

If the problem persists, please call our Consumer Services

Department at 1-800-521-2010 in the U.S. 1-877-352-8697

in Canada, or visit our website vtechkids.com and fill out our

Creating and developing VTech products is accompanied by a

responsibility that we take very seriously. We make every effort

to ensure the accuracy of the information, which forms the value

of our products. However, errors sometimes can occur. It is

important for you to know that we stand behind our products

and encourage you to contact us with any problems and/or

suggestions you might have. A service representative will be

happy to help you.

NOTE

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate

the equipment.

Supplier’s Declaration of Conformity

47 CFR § 2.1077 Compliance Information

Trade Name: VTech®

Model: 5515

Product Name: DJ Beat Boxer™

Responsible Party: VTech Electronics North America, L.L.C.

Address: 1156 W. Shure Drive, Suite 200

Arlington Heights, IL 60004

Website: vtechkids.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC

RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO

CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL

INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY

INTERFERENCE RECEIVED, INCLUDING INTERFERENCE

THAT MAY CAUSE UNDESIRED OPERATION.

CAN ICES-003(B)/NMB-003(B)

IM-551500-000

Version: 1

Visit our website for more

information about our products,

downloads, resources and more.

vtechkids.com

vtechkids.ca

Read our complete warranty policy online at

vtechkids.com/warranty

vtechkids.ca/warranty

VTech DJ Beat Boxer™ Manuel utilisateur

Marque: VTech

Modèle: DJ Beat Boxer™

Catégorie: Jouets

Taper: Manuel utilisateur

Télécharger le PDF

rapport

dans d''autres langues

English: VTech DJ Beat Boxer™ User manual

VTech DJ Beat Boxer™ Manuel utilisateur

VTech DJ Beat Boxer™ Manuel utilisateur

dans d''autres langues

Documents connexes