Nortel 1000E Regulatory And Safety Information
- Taper
- Regulatory And Safety Information
Regulatory and Safety Statements
The following Regulatory Statements, Safety Warnings and other information are with respect to
the Integrated Conference Bridge Professional known as the "ICB Professional".
WARNING: This equipment must not be connected to the PSTN.
WARNING: This equipment is intended to connect and operate only with the Nortel PABX
system, which in turn, may connect to the PSTN when following the relevant Nortel instructions
and guidelines.
WARNING: This equipment is not to have direct outside connections and is intended only for
internal connections to the PABX.
R&TTE Conformance Statement:
Hereby, Nortel declares that this ICB Professional is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC (R&TTE Directive).
A copy of the Declaration of Conformity can be obtained from Nortel Networks GmbH address:
Ingolstaedter Strasse 14-18, 80807 Munich Germany.
FCC Part 15 Statements:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications to the ICB Professional not expressly approved
by Nortel could void the user's authority to operate the equipment.
ICES-003 Statement:
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
-
1
-
2
Nortel 1000E Regulatory And Safety Information
- Taper
- Regulatory And Safety Information
dans d''autres langues
- English: Nortel 1000E