1
User Manual
Product Information
Product model name: C76N8S
Safety and Compliance Information
Using Your Device Around Other Electronic Devices
The Device, uses, and can radiate radio frequency (RF) energy and, if not used in
accordance with its instructions, may cause interference to radio communications and
electronic equipment. External RF signals may affect improperly installed or inadequately
shielded electronic operating systems, entertainment systems, and personal medical
devices.
While most modern electronic equipment is shielded from external RF signals, if in doubt,
check with the manufacturer. For personal medical devices (such as pacemakers and
hearing aids), consult with your physician or the manufacturer to determine if they are
adequately shielded from external RF signals.
There are some places where RF signals could constitute a hazard, such as health care
facilities, and construction sites. If you are not sure, look around for signs indicating that two-
way radios or mobile phones should be turned off.
Other Safety Considerations
• Do not touch your Device or any wires connected to your Device during a lightning storm.
• Small parts contained in your device and its accessories may present a choking
hazard to small children.
• Your device is shipped with an AC adaptor. Power adapter designed only for use
with your device.
FCC Compliance Information
Radio Frequency Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
2
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications that are not expressly approved by the party responsible for
compliance could make the device no longer comply with the FCC Rules.
Information on your device is on file with the FCC and can be found by inputting your device’s FCC
ID, which can be found on the back of Device, into the FCC ID Search form available at
transition.fcc.gov/oet/ea/fccid.
Information Regarding Exposure to Radio Frequency Energy
The output power of the radio technology used in the Device is below the radio frequency
exposure limits set by the FCC. This device should be installed and operated with a
minimum distance of 20cm between the radiator and your body.
IC Compliance Information
Radio Frequency
Information
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement."
The device is restricted to indoor use only when operating in the 5150 to 5350 MHz frequency
range.
Les dispositifs fonctionnant dans la bande de 5 150 à 5 250 MHz sont réservés uniquement pour
3
une utilisation à l'intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de
satellites mobiles utilisant les mêmes canaux.
This equipment complies with IC RSS-102 RF exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20 cm
between the radiator & your body.
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20
cm de distance entre la source de rayonnement et votre corps.
Recycling Product Properly
In some areas, the disposal of certain electronic devices is regulated. Make sure you
dispose of or recycle the Products in accordance with your local laws and regulations.
Product Specifications
Model Number: C76N8S
Electrical Rating: 12VDC, 1.25A output power adapter
(in-box) Operating temperature: 0°C to 35°C
Connectivity: 2.4 & 5GHz Wifi, BT/BLE 5.0
-
1
-
2
-
3
dans d''autres langues
- English: Amazon C76N8S User manual
Documents connexes
Autres documents
-
TP-LINK CPE510 Guide d'installation
-
Netronix N605 Manuel utilisateur
-
Datalogic JOYA Touch 22 Multi Purpose Device for Retail Manuel utilisateur
-
TP-LINK tp-link EAP660 HD Omada Ceiling Mount Access Point Le manuel du propriétaire
-
-
TP-LINK tp-link EAP660 HD Ceiling Mount EAP Mode d'emploi
-
TP-LINK tp-link Omada EAP660 HD V1 Ceiling Mount Access Point Le manuel du propriétaire
-
Abyssal Plain T76N2B Android Smart Tablet Manuel utilisateur
