La page est en cours de chargement...
SPECIFICATIONS
HAZARD DEFINITIONS
INTRODUCTION
SAFETY
WARNING! Read and understand all instructions before
using this tool. The operator must follow basic
precautions to reduce the risk of personal injury
and/or damage to the equipment.
WORK AREA
PERSONAL SAFETY
WARNING! Wear personal protective equipment
approved by the Canadian Standards Association (CSA)
or American National Standards Institute (ANSI).
PERSONAL PROTECTIVE EQUIPMENT
PERSONAL PRECAUTIONS
SPECIFIC SAFETY PRECAUTIONS
WARNING! DO NOT let comfort or familiarity with
product (gained from repeated use) replace strict
adherence to the tool safety rules. If you use this tool
unsafely or incorrectly, you can suffer serious personal
injury.
HYDRAULIC PRECAUTIONS
DANGER! Seek immediate medical attention if
hydraulic fluid under pressure penetrates your skin.
See Injection Injury precautions for instructions before
using a pressurized hydraulic system.
INJECTION INJURY
DANGER! Seek immediate, professional medical
treatment if fluid penetrates your skin. It may feel like
a pricking or sting. Do not wait for the appearance of
symptoms. A toxic reaction can occur from the
exposure. Delay in treatment can lead to amputation
or death.
INJECTION PRECAUTIONS
ELECTRICAL SAFETY
WARNING! Do not touch or handle a live tool with any
part of your body that is wet or damp. Wet skin
reduces resistance to electrical current, increasing
the danger of a serious or fatal shock.
WARNING! To reduce risk of electric shock, be certain
that the plug is connected to a properly grounded
receptacle.
WARNING! All wiring should be performed by a
qualified electrician.
POWER TOOL PRECAUTIONS
POWER CORD
LOW VOLTAGE
UNPACKING
WARNING! Do not operate the tool if any part is
missing. Replace the missing part before operating.
Failure to do so could result in a malfunction and
personal injury.
IDENTIFICATION KEY
ASSEMBLY & INSTALLATION
ADJUSTING THE CYLINDER STROKE
OPERATION
CAUTION! Do not force the log splitter to split hard
wood for more than 5 seconds. This may damage the
tool. Rotate the log 90 degrees and attempt again.
Discard the log if unable to split, as it exceeds this
tool’s splitting force capacity.
CAUTION! The wheels are designed for repositioning
or moving the log splitter a short distance by hand.
Towing the log splitter behind a vehicle will damage
the unit and may pose a hazard to bystanders.
FREEING A JAMMED LOG
WARNING! Do not attempt to remove a jammed log
with your hands or with hammer blows. The wood is
under pressure and could separate and launch without
warning, causing an injury to you or a bystander.
EXTENSION CORD
Minimum Wire Gauge For Extension Cords
(120 Volts with 5% voltage drop)
CARE & MAINTENANCE
WARNING! Only qualified service personnel should
repair the tool. An improperly repaired tool may
present a hazard to the user and/or others.
HYDRAULIC RAM MAINTENANCE
REPLACING HYDRAULIC OIL
SHARPENING THE WEDGE
LUBRICATION
NOTICE! NEVER use a penetrating oil to lubricate the
tool. Penetrating oil may act as a solvent that will
break down the grease and cause the tool to seize up.
DISPOSAL
IMPORTANT! DO NOT pollute the environment by
allowing uncontrolled discharge of waste oil.
HYDRAULIC FLUID
TROUBLESHOOTING
Problem(s)
Possible
Cause(s)
Suggested Solution(s)
PARTS BREAKDOWN
/