Approx. 15.5 mph (25 km/h)
Approx. 18.6 miles (30 km)
Approx. 15%
Asphalt/flat pavement; obstacles < 0.4 in (1 cm); gaps < 1.2 in (3 cm)
14–104°F (-10–40°C)
14–122°F (-10–50°C)
IPX5
Approx. 5 h
Approx. 45 × 18.9 × 45.7 in (1143 × 480 × 1160 mm)
Approx. 45 × 18.9 × 19.5 in (1143 × 480 × 495 mm)
Approx. 33.3 lbs (15.1 kg)
Product
Rider
Machine
Battery
Motor
Charger
Features
Tire
Ninebot KickScooter
F30
Item Parameter
Name
Model
Length × Width × Height
Folded: Length × Width × Height
Net Weight
Payload
Recommended Age
Required Height
Max. Speed
Typical Range[1]
Max. Slope
Traversable Terrain
Operating Temperature
Storage Temperature
IP Rating
Duration of Charging
Nominal Voltage
Max. Charging Voltage
Charging Temperature
Nominal Capacity
Nominal Energy
Battery Management System
Output Power
Input Voltage
Max. Output Voltage
Rated Output
Brake Light
Riding Modes
Tire Pressure
Tires
40–45 psi
10-inch pneumatic tires.
LED Rear Light
Energy-saving mode, Standard mode and Sport mode
0.07 kW, 70 W
100–240 V~
42 V
41 V , 1.7 A
Nominal Power 0.3 kW, 300 W
36 V
42 V
32–104°F (0–40°C)
7650 mAh
275 Wh
Over-heating, short circuit, over-current, over-discharge and
over-charge protection
66–265 lbs (30–120 kg)
14+ years
3’11”–6’6” (120–200 cm)
Approx. 34.8 lbs (15.8 kg)
Approx. 18.6 mph (30 km/h)
Approx. 24.9 miles (40 km)
Approx. 20%
Approx. 6.5 h
0.35 kW, 350 W
10200 mAh
367 Wh
F40F30S
[1] Typical Range: tested while riding under full power, 165 lbs (75 kg) load, 77°F (25°C), 60% of max. speed on average on pavement.
* Some of the factors that affect range include speed, number of starts and stops, ambient temperature, etc.
This product is certified to ANSI/CAN/UL-2272 by TUV Rheinland.
The battery complies with UN/DOT 38.3.
The battery complies with ANSI/CAN/UL-2271.
Federal Communications Commission (FCC) Compliance Statement for USA
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolledenvironment.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Cet équipement est conforme aux limites d'exposition aux radiations de la IC définies pour un environnement non contrôlé.
Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le radiateur et votre corps.
Industry Canada (IC) Compliance Statement for Canada
This device complies with Industry Canada license-exempt RSS standard (s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
CAN ICES-3 (B)/NMB-3(B)
Neither Segway Inc. nor Ninebot is responsible for any changes or modifications not expressly approved by Segway Inc. or
Ninebot. Such modifications could void the user's authority to operate the equipment.
Certifications
3
Model: F25 / F30 / F30S / F40
FCC ID: 2ALS8-KS0005
IC: 22636-KS0005
04 05