AIAIAI UNIT-4 WIRELESS Mode d'emploi

AIAIAI
Marque
AIAIAI
Modèle
UNIT-4 WIRELESS
Taper
Mode d'emploi
WIRELESS
STUDIO
MONITOR
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
This device contains licence-exempt transmitter(s)/receiv-
er(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
L’émetteur/récepteur exempt de licence contenu dans le
présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d' en
compromettre le fonctionnement.
Company name:
Address:
Tel:
E-mail:
CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.
(Cet appareil numérique de la Classe B conforme à la norme
NMB-003 du Canada)
FCC ID: 2AKSOUNIT-4
IC: 23880-UNIT4
CMIIT ID: XXXXXXXXXX
Battery mode
Adaptor mode
Disposal of a battery into fire or a hot oven, or mechanically crushing
or cutting of a battery that can result in an explosion.
Leaving a battery in an extremely high temperature surrounding
environment that can result in an explosion or the leakage of
flammable liquid or gas.A battery subjected to extremely low air
pressure that may result in an explosion or the leakage of flammable
liquid or gas. Do not used in high or low extreme temperatures.
Do not used in low air pressure at high altitude condition.
WARNING[OR CA WARNING OR CALIFORNIA WARNING]:
Risk of reproductive harm from exposure to [name of chemical]-
www.P65Warnings.ca.gov
  • Page 1 1
  • Page 2 2

AIAIAI UNIT-4 WIRELESS Mode d'emploi

AIAIAI
Marque
AIAIAI
Modèle
UNIT-4 WIRELESS
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Autres documents