ROSIERES RCH6CX-ALG/1 Manuel utilisateur

ENGLISH

INSTALLATION AND USER’S MANUAL

FRENCH

NOTICE D’INSTALLATION ET D’UTILISATION

لﯾﻟد مدﺧﺗﺳﻣﻟاو بﯾﻛرﺗﻟا

30

INSTALLATION AND USER’S MANUAL

CONTENT

INTRODUCTION

SAFETY PRECAUTION

SPECIFICATION

INSTALLATION (VENT OUTSIDE)

INSTALLATION (VENT INSIDE)

DESCRIPTION OF COMPONENTS

OPERATION

MAINTENANCE

TROBULESHOOTING

CONFORMITY WITH DIRECTIVES

ENVIRONMENTAL PROTECTION

1

02

05

06

17

18

19

20

21

31

INTRODUCTION

Thank you for choosing this cooker hood.

This instruction manual is designed to provide you with all required

instructions related to the installation, use and maintenance of the appliance.

In order to operate the unit correctly and safety, please read this instruction

manual carefully before installation and usage.

The cooker hood uses high quality materials, and is made with a streamlined

design. Equipped with large power electric motor and centrifugal fan, it also

provides strong suction power, low noise operation, non-stick grease filter and

easy assembly installation.

SAFETY PRECAUTION

Never let the children operate the machine.

The cooker hood is for home use only, not suitable for barbecue, roast

shop and other commercial purpose.

The cooker hood and its filter should be clean regularly in order to

keep in good working condition.

Clean the cooker hood according to the instruction manual and keep

the unit from danger of burning.

Forbid the direct baking from the gas cooker.

Please keep the kitchen room a good convection.

Before connecting this appliance check that the power supply cord is

not damaged. A damage supply cord must be replaced by qualified

service personnel only.

There shall be adequate ventilation of the room when the range hood

is used at the same time as appliances burning gas or other fuels;

he air must not be discharged into a flue that is used for

exhausting fumes from appliances burning gas or other fuels;

Regulations concerning the discharge of air have to be fulfilled.

This appliance if not intended for use by persons(including children)

with reduced physical, sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a person slide for

their safety.

Children should be supervised to ensure that they do not play with the

appliance.

2

32

Do not flambé under the range hood.

CAUTION: Accessible parts may become hot when used with cooking

appliance

Electrical Shock Hazard

Only plug this unit into a properly earthed outlet. If in doubt seek

advice from a suitably qualified engineer.

Failure to follow these instructions can result in death, fire, or

electrical shock.

- These shall be adequate ventilation of the room when the

range hood is used at the same time as appliances burning

gas or other fuels(not applicable to appliances that only

discharge the air back into the room);

- the details concerning the method and frequency of cleaning.

- there is a fire risk if cleaning is not carried out in accordance

with the instructions; - do not flame under the range hood;

- CAUTION:Accessible parts may become hot when used with

cooking appliances.

The lamp used in this product is not suitable for use

in the lighting of a room.

The purpose of this lamp is to provide illumination for using the product.

3

32

Direct Connection

The appliance must be connected directly to the mains using an

omnipolar circuit breaker with a minimum opening of 3mm between

the contacts.

The installer must ensure that the correct electrical connection has

been made and that it complies with the wiring diagram.

The cable must not be bent or compressed.

Regularly check the power plug and power cord for damage. If the

supply cord is damaged, it must be replaced by a special cord or

assembly available from the manufacturer or its service agent.

WARNING: This is a Class I appliance and MUST be earthed

This appliance is supplied with a 3 core mains cable coloured as

follows:

Brown = L or Live

Blue = N or Neutral

Green and Yellow = E or Earth

The fuse must be rated at 3 Amps.

Electrical Installation

All installation must be carried out by a competent person or qualified

electrician. Before connecting the mains supply ensure that the mains

voltage corresponds to the voltage on the rating plate.

4

33

Standard Installation Accessories List

Spec.

Illustration Picture

Qty

Casing

1

Upper Chimney

1

Lower Chimney

1

Lower chimney bracket

1

Upper chimney bracket

1

Hanging Board

1

φ8 rawl plugs

φ8×φ6 white color

9

Screws

ST4.0×30

9

φ7.2screws

ST4.0×8

2

5

34

INSTALLATION

（

wall mounting

）

If you have an outlet to the outside, your cooker hood can be connected as

below picture by means of an extraction duct (enamel, aluminum, flexible pipe or

inflammable material with an interior diameter of 150mm)

1. Before installation, turn the unit off and unplug it from the outlet.

2. The cooker hood should be placed at a distance of 65~75cm above

the cooking plane for best effect.

3. Drill 3 x 8mm holes to accommodate the bracket. Screw and tighten

the bracket onto the wall with the screws provided.

Wall plug

Wall bracket

107.5mm

Screw(4mm x 30mm)

6

eed to drill 2x8mm extra holes & fixing screws & screw plugs before

installation. Voor schuine modellen

For inclined panel Model

7

35

4. Leave up the cooker hood and hang onto the wall bracket hook.

Cooker hook

Wall

bracket

5. Fix the one-way-valve to the air outlet of the cooker hood. Then,

attached the exhaust pipe onto the one-way-valve as shown below.

Exhaust pipe

Cooker hood

8

36

6.

i. Place the glass in appropriate position on the top the cooker

hood.

ii. Fix with 4 screws and washer. In order to avoid the glass

cracking, please do not tighten the screws too strongly.

i. By Put the inner chimney into outer chimney .Then pulling out

the inner chimney upwards. Adjust to reach the height required.

ii. Sliding the chimney to adjust the chimney height. When the

height you required is reached, then hang the fixing hole to the fixing

screws as showed in below pictures.

Inner chimney

Outer chimney

9

37

8.

i. Drill 2 x 8mm holes to accommodate the plate II. Screw and

tighten the plate II onto the wall with 2 screws provided.

ii. Assembly the chimney onto the unit and fix it with 2 screws.

Plate II

Wall plug

Screw

4mm x 8mm

Screw

(4mm x 30mm)

10

Standard Installation Accessories List

Spec. Illustration Picture Qty

Air Deflector 1

Bracket 1

φ8 rawl plugs

φ8×φ6whitecolor

2

Screws

ST4.0×30

2

Screws

ST3.5×12

2

11

INSTALLATION(AIR DEFLECTOR FOR T-SHAPE,CURVED GLASS,FLAT

GLASS MODELS):

Air deflector is mentioned as included and not optional.

1.Before installation,curve both ends of the bracket as shown below:

2.Fix the bracket to the T-shaped plastic outlet with 2pcs ST3.5x12mm screws

provided.

3.Drill 2 holes to accommodate the wall plugs,then screw and tighten the

bracket onto the wall with 2pcs ST4x30mm screws provided.

12

4.Attach the exhaust pipe onto the air outlet of the cooker hood as shown

below:

5.Install the chimney to the unit and fix it.

o “Please kindly be noted: T-shaped plastic outlet and v-flaps can not be use

datthesametime.Youcanusethemintwoways:1)Addv-flaponexistingo

utlet; 2) Use T-shaped plastic outlet, no add v-flap.”

o “Note: The product is provided with v-flap accessory. This accessory is not

mandatory for installation, operation and use of the product.”

13

Standard Installation Accessories List

Spec. Illustration Picture Qty

Air Deflector 1

Bracket 1

φ8rawlplugs

φ8×φ6whitecolor

2

Screws

ST4.0×30

2

Screws

ST3.5×12

2

14

INSTALLATION（AIR DEFLECTOR FOR PYRAMID & SLANT MODELS):

Air deflector is mentioned as included and not optional.

1.Fix the bracket to the T-shaped plastic outlet with 2pcs ST3.5x12mm screws

provided as shown below:

2. Drill 2 holes on the wall to accommodate the wall plugs,then screw and

tighten the bracket onto the wall with 2pcs ST4x30mm screws provided.

3. Attach the exhaust pipe onto the air outlet of the cooker hood as shown

below:

15

4.Install the chimney to the unit and fix it.

o “Please kindly be noted: T-shaped plastic outlet and v-flaps can not be use

datthesametime.Youcanusethemintwoways:1)Addv-flaponexistingo

utlet; 2) Use T-shaped plastic outlet, no add v-flap.”

o “Note: The product is provided with v-flap accessory. This accessory is not

mandatory for installation, operation and use of the product.”

16

38

INSTALLATION (VENT INSIDE)

If you do not have an outlet to the outside, exhaust pipe is not required and

the installation is similar to the one show in section “INSTALLATION (VENT

OUTSIDE)”.

Activated carbon filter can be used to trap odors.

In order to install the activated carbon filter, the grease filter should be

detached first. Press the lock and pull it downward.

Plug the activated carbon filter into the unit and turn it in clockwise direction.

Repeat the same on the other side.

NOTE:

oMake sure the filter is securely locked. Otherwise, it would loosen and

cause dangerous.

oWhen activated carbon filter attached, the suction power will be

lowere

17

DESCRIPTION OF COMPONENTS

OPERATION

On/Off button

It’s used for turning on/off the fan.

Speed plus button

For increasing the speed of the fan

Speed decrease button

For decreasing the speed of the fan.

Light button

Digital display

Fan speed display:"1" for Low speed, "2" for Medium speed,

"3" for High speed.

Quick timer: Press & hold for 1 second, Digital display will

flashing & into 5 minutes count down, after 5 minutes motor & light

will turn off automatic & Buzzer sound for 1 second.

18

La page est en cours de chargement...

ROSIERES RCH6CX-ALG/1 Manuel utilisateur

Ce manuel convient également à

ROSIERES RCH6CX-ALG/1 Manuel utilisateur

dans d''autres langues

Documents connexes

Autres documents