FCC Warning
This equipment has been tested and found to comply with the limits for
a Class B digital device,pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Changes or modifications not expressly approved by the
manufacturer (or party responsible)
for compliance could void the user’s authority to operate the equipment.
Part 15.19
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
When using RF-851 holding in hand, keep separation distance of at
least 20 cm from the user's body.
IC Warning
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions : (1)
This
device may not cause interference; and (2) This device must accept
any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
When using RF-851 holding in hand, keep separation distance of at
least 20 cm from the user's body.
Lorsque vous utilisez le RF-851 en tenant en main, maintenez une
distance de séparation d'au moins 20 cm du corps de l'utilisateur.