Hui Zhou Gaoshengda Technology WT5LM2001 WIFI+BT Module Manuel utilisateur

Taper
Manuel utilisateur

Ce manuel convient également à

Hui Zhou Gaoshengda Technology Co., LTD WT5LM2001
PAGE 1 OF 4 Version 1.0
WIFI+BT Module
IEEE 802.11 a/b/g/n 2T/2R
Model Number: WT5LM2001
Product Descrition
The WT5LM2001 is a complete dual-band(2.4GHz and 5GHz)WIFI 2×2 MIMO module. This module provides a
high level of integration with a dual-stream IEEE 802.11n MAC/ base band /radio and Bluetooth 5.0.The WLAN
operation supports 20MHz,40MHz channels for data rates up to 300Mbps. It fully complies with IEEE 802.11
a/b/g/n feature rich wireless connectivity at high standards,delivers reliable,cost-effective, throughput from an
extended distance.
Product Features
Product Specification
Model WIF+BT Module
Product Name WT5LM2001
Standard 802.11 a /b/g/n
Interface USB
Data Transfer Rate 1,2,5.5,6,11,12,18,22,24,30,36,48,54,60,90,120 and maximum of 300Mbps
Modulation Method GFSK,π/4-DQPSK,8DPSK(bluetooth)
DQPSK,DBPSK,CCK(802.11b)
QPSK,BPSK,16QAM,64QAM with OFDM (802.11g)
QPSK,BPSK,16QAM,64QAM with OFDM (802.11n)
QPSK,BPSK,16QAM,64QAM with OFDM (802.11a)
Frequency Band BLUETOOTH
2402~2480 MHz
WIFI
2.4G: 2412~2462 MHz
5G: 5150~5250MHz,5725~5850MHz
Operation Mode Infrastructure
Security WEP, TKIP, AES, WPA, WPA2
Operating Voltage 3.3V±10%
Current Consumption 1000mA
Antenna Type PIFA
Operating
Temperature
0 ~ 70°C ambient temperature
Storage Temperature -40 ~ 80°C ambient temperature
Humidity 5 to 95 % maximum (non-condensing)
Complies with IEEE 802.11b/g/n for 2.4GHz and IEEE 802.11a/n 5GHz Wireless LAN.
Bluetooth v5.0
Two transmit and Two receive path(2T2R)
Works with all existing network nfrastructure.
Capable of up to 128-Bit WEP Encryption.
Freedom to roam while staying connected.
UP to 300 Mbps High-Speed Transfer Rate in 802.11n mode of operation.
Operating SystemsLinux,Win7, Win8, Win10,XP
Low power consumption.
Easy to install and configure.
High speed USB 2.0 interface
Hui Zhou Gaoshengda Technology Co., LTD WT5LM2001
PAGE 2 OF 4 Version 1.0
NOTICE:
◆please keep this product and accessories attached to the places which children can't touch;
◆do not splash water or other liquid onto this product, otherwise it may cause damage;
◆do not put this product near the heat source or direct sunlight, otherwise it may cause
deformation or malfunction;
◆please keep this product away from flammable or naked flame;
◆please do not repair this product by yourself. Only qualified personnel can be repaired.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Please notice that if the FCC identification number is not visible when the module is
installed inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. This exterior label
can use wording such as the following: “Contains FCC ID:2AC23-WT5L” any similar wording
that expresses the same meaning may be used.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of
20cm between the radiator & your body. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
The module is limited to OEM installation ONLY.
The OEM integrator is responsible for ensuring that the end-user has no manual instruction
to remove or install module.
Hui Zhou Gaoshengda Technology Co., LTD WT5LM2001
PAGE 3 OF 4 Version 1.0
The module is limited to installation in mobile application.
A separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and difference antenna configurations.
There is requirement that the grantee provide guidance to the host manufacturer for
compliance with Part 15B requirements.
The module complies with FCC Part 15.247 / Part 15.407 and apply for Single module approval.
Trace antenna designs: Not applicable.
Antennas:
2.4G 5G
PIFA antenna & 2 dBi PIFA antenna & 3 dBi
BT Antenna:
BRADE TYPE GAIN
ZTX PIFA antenna 2 dBi
The antenna is permanently attached, can’t be replaced.
Canada Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to
the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre le fonctionnement.
Please notice that if the ISED certification number is not visible when the module is
installed inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. This exterior label
can use wording such as the following: “Contains IC:12290A-WT5L” any similar wording that
expresses the same meaning may be used.
l'appareil hôte doit porter une étiquette donnant le numéro de certification du module
d'Industrie Canada, précédé des mots « Contient un module d'émission », du mot « IC:12290A-
WT5L » ou d'une formulation similaire exprimant le même sens, comme suit
The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems
for devices with detachable antenna(s), the maximum antenna gain permitted for devices in
the band 5725-5850 MHz shall be such that the equipment still complies with the e.i.r.p.
limits as appropriate;
Hui Zhou Gaoshengda Technology Co., LTD WT5LM2001
PAGE 4 OF 4 Version 1.0
Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une
utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux
systèmes de satellites mobiles utilisant les mêmes canaux;
pour les dispositifs munis d'antennes amovibles, le gain maximal d'antenne permis (pour
les dispositifs utilisant la bande de 5 725 à 5 850 MHz) doit être conforme à la limite
de la p.i.r.e. spécifiée, selon le cas;
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Hui Zhou Gaoshengda Technology WT5LM2001 WIFI+BT Module Manuel utilisateur

Taper
Manuel utilisateur
Ce manuel convient également à