iHome B16 Series Manuel utilisateur

iHome
Marque
iHome
Modèle
B16 Series
Catégorie
Casques mobiles
Taper
Manuel utilisateur
FRONT BACK
XX-B16 IB (English)
Size: 120 x 150 mm
Printing color: Black (1C + 1C)
Material: 85 gsm WF paper
Dec. 06, 2021
CHARGING THE EARBUDS
Model: B16 Series
True Wireless Earbuds
CHARGE BEFORE USE
POWER ON/OFF
- Press and hold either Multi-Function Button (MFB) for 3 seconds to turn the earbuds ON.
- Press and hold either Multi-Function Button for 5 seconds to turn the earbuds OFF.
BLUETOOTH PAIRING
- When the earbuds are ON, they will automatically enter pairing mode.
- Select ‘ekids B16’ on your Bluetooth-enabled device to connect.
- A voice prompt will sound to indicate pairing is complete. Earbuds will automatically
connect to your Bluetooth device whenever it is in range. To manually pair, press the MFB
on each earbud 2 times. To reset Bluetooth, press the MFB on both earbuds 3 times.
MULTI-FUNCTION BUTTON
Speakerphone
Answer Call
Reject Call
Double press MFB
Bluetooth Audio
Play/Pause Short press MFB
Case ChargingEarbud Charging
Charging Flashing White LED
Fully charged LED OFF
Charging
Fully charged 4 Solid LED
FCC Information
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
• Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B) / NMB-3(B)
ISED statements
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
This device comply with ISED RF exposure requirement, users can obtain Canadian information on RF
exposure and compliance.
Any Changes or modifications not expressly approved by the party respo sible for compliance could void
the user’s authority to operate the equipment.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un
environnement non contrôlé. L’émetteur/récepteur exempt de licence contenu dans le présent appareil
est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
L'appareil est conforme aux exigences d’exposition RF ISED, les utilisateurs peuvent obtenir des informations
canadiennes sur l’exposition aux RF et la conformité.
Tout changement ou modification non expressément approuvé par la partie responsable de la conformité
pourrait annuler le droit de l’utilidateur à utiliser l'équipement.
Questions? Visit www.ekids.com
©2022 SDI Technologies, Inc. All Rights Reserved.
iHome is a registered trademark of SDI Technologies Inc., used under license.
B16_120621-A Printed in China
FCC ID: EMOB16A
IC: 986B-B16A
HVIN: B16a
LED INDICATORS
ONE YEAR LIMITED WARRANTY For product support and warranty please visit: www.ekids.com/support
USB-C
charging cable
(included)
Double press MFB
Volume Up
Volume Down
Next Track
Previous
Track
Press LEFT MFB for 2 sec
Press RIGHT MFB for 2 sec
Quick double press LEFT MFB
Quick double press RIGHT MFB
Voice Assistant
ON/OFF Press MFB 3x WARNING: Earbuds and case may present a choking hazard or cause other injury to small children. Keep
away from small children. For your safety, do not use earbuds if they would prevent you from hearing
warning sounds, such as while riding a bike, crossing the street, etc.
To prevent possible hearing damage, do not listen at high volume levels for long periods.
THIS IS NOT A TOY.
End Call
Press MFB for 2 sec
1 LED= 25% / 2 LED= 50% / 3 LED= 75%
Left
Right
USB-C AC
adaptor
(not included)
LED
indicator Microphone
(on both ear buds)
Charging case
Charging
Port
MFB
MFB
  • Page 1 1

iHome B16 Series Manuel utilisateur

iHome
Marque
iHome
Modèle
B16 Series
Catégorie
Casques mobiles
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents