FRONT BACK
WH-115.EMv23M IB (English)
Size: 120 x 150 mm
Printing color: Black (1C + 1C)
Material: 85 gsm WF paper
April 4, 2023 draft v6
Model: WH-115
Bluetooth Sing-Along Boombox
INSTALLING THE BATTERIES
Batteries should only be installed by an adult.
The unit comes with batteries already installed. These
batteries are meant for in-store demonstration use only,
and should be replaced with fresh batteries. To replace
the batteries at home:
1. Use a Phillips screwdriver to open the battery
compartment door.
2. Install 3 ‘AA’ LR6 batteries into the compartment.
Make sure the + and - polarities match the diagram
printed inside.
3. Close the battery compartment door and tighten the
door screw. Do not over tighten.
FCC Information
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
• Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B) / NMB-3(B)
ISED statements
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
This device comply with ISED RF exposure requirement, users can obtain Canadian information on RF
exposure and compliance.
Any Changes or modifications not expressly approved by the party respo sible for compliance could void
the user’s authority to operate the equipment.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un
environnement non contrôlé. L’émetteur/récepteur exempt de licence contenu dans le présent appareil
est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
L'appareil est conforme aux exigences d’exposition RF ISED, les utilisateurs peuvent obtenir des informations
canadiennes sur l’exposition aux RF et la conformité.
Tout changement ou modification non expressément approuvé par la partie responsable de la conformité
pourrait annuler le droit de l’utilidateur à utiliser l'équipement.
Questions? Visit www.ekids.com
.
WH-115_040423-A Printed in China
FCC ID: EMO115A
IC: 986B-115A
HVIN: XX-115a
ONE YEAR LIMITED WARRANTY
For product support and warranty please visit: www.ekids.com/support
BLUETOOTH PAIRING
- Press the Power Button to turn the unit ON.
- Press and hold the Bluetooth Mode Button to enter pairing mode.
Select ‘WH-115’ on your Bluetooth-enabled device to connect. Once connected, use the
controls on your device to play/pause and navigate tracks.
USING THE MICROPHONE
Press and hold the button on the microphone to amplify your voice while you sing along!
POWER
PLAY SONG
PLAY INSTRUMENTAL
BLUETOOTH
FRONT OF UNIT BACK OF UNIT
SLIDE TO ‘ON’
TO PLAY
VOLUME
SWITCH