Headphones B42 Series Wireless Manuel utilisateur

Taper
Manuel utilisateur

Ce manuel convient également à

FRONT BACK
XX-B42 IB (English)
Size: 120 x 150 mm
Printing color: Black (1C + 1C)
Material: 85 gsm wood Free paper
Feb. 07, 2022
FCC ID: EMOB42A
IC: 986B-B42A
HVIN: B42a
CHARGING THE HEADPHONES - MUST ALWAYS BE CONDUCTED BY AN ADULT
Model: B42 Series
Wireless Headphones
CHARGE BEFORE USE
POWER ON/OFF
- Press and hold the Multi-Function Button (MFB) to turn the headphones ON/OFF.
VOLUME SWITCH
- Use the volume switch to select High, Medium, or Low. The unit is factory set to Low,
which is the recommended listening level.
BLUETOOTH PAIRING - MUST ALWAYS BE CONDUCTED BY AN ADULT
- When the headphones are ON, they will automatically enter pairing mode.
- Select ‘KIDdesigns B42’ on your Bluetooth-enabled device to connect.
- A voice prompt will sound to indicate pairing is complete. Headphones will automatically
connect to your Bluetooth device whenever it is in range. To reset Bluetooth, press and
hold the MFB for 10-12 seconds while the unit is OFF.
LISTENING TO AUDIO
- Press the MFB to play/pause audio. Use the controls on your device to navigate tracks.
AUX CABLE
- Use a 3.5mm aux cable (not included) for optional wired listening. Connect one end of the
aux cable to your device, and the other end to the AUX jack on the B42 headphones.
(Please exercise caution and use adult supervision when using an aux cable, greater than
300mm (12 inches) for wired listening.)
LED INDICATORS
- LED flashes blue while in Bluetooth pairing mode, and glows solid blue when connected.
- LED flashes red when battery is low, glows solid red while charging, and turns off when the
headphones are fully charged.
FCC Information
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
• Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B) / NMB-3(B)
ISED statements
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
This device comply with ISED RF exposure requirement, users can obtain Canadian information on RF exposure and compliance.
Any Changes or modifications not expressly approved by the party respo sible for compliance could void the user’s authority
to operate the equipment.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un environnement non contrôlé.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
L'appareil est conforme aux exigences d’exposition RF ISED, les utilisateurs peuvent obtenir des informations canadiennes
sur l’exposition aux RF et la conformité.
Tout changement ou modification non expressément approuvé par la partie responsable de la conformité pourrait annuler le
droit de l’utilidateur à utiliser l'équipement.
B42_020722-A Printed in China
ONE YEAR LIMITED WARRANTY - For product support and warranty please visit: www.kiddesigns.com/support
USB-C
charging cable
(included)
To prevent possible hearing damage, do not listen at high volume levels for long periods.
THIS IS NOT A TOY.
USB-C AC
adaptor
(not included)
LED indicator
Charging Port
AUX jack
MFB
Volume Switch
WARNING: For your safety, do not use headphones if they would prevent you from hearing warning sounds, such as
while riding a bike, crossing the street, etc.
IMPORTANT SAFETY INSTRUCTIONS - Do not use or charge this product near a water source, and clean only with
dry cloth. Do not block any ventilation openings. Keep product away from heat sources. Only use accessories
specified by the manufacturer. Never leave unattended when charging.
GENERAL BATTERY PRECAUTIONS - Never use or charge a battery if it appears to be leaking, or in any way
abnormal. Avoid charging battery when the temperature is not within 5°C - 35° C (41° - 95° Fahrenheit). Never expose
a battery to any liquid, or to excessive heat such as direct sunlight or fire. Always keep batteries out of the reach of
infants and small children. Always charge lithium devices on a non-flammable surface - wooden tables/ carpeted
floors are not recommended charging surfaces.
WARNING/DISPOSAL OF UNIT - Do NOT attempt to change or disassemble the built-in battery. Doing so will void
the warranty and could cause personal injury and damage to your device. Do not dispose of batteries in the
household trash or fire. Always dispose of used batteries/electronics in accordance with the prevailing community
regulations. To find a drop-off location near you, visit www.call2recycle.com
Questions? Visit www.kiddesigns.com
©2022 All Rights Reserved.
  • Page 1 1

Headphones B42 Series Wireless Manuel utilisateur

Taper
Manuel utilisateur
Ce manuel convient également à

dans d''autres langues