Sony TCM 4TR Mode d'emploi

Marque: Sony

Modèle: TCM 4TR

Catégorie: Lecteurs de cassettes

Taper: Mode d'emploi

Ce manuel convient également à

TCM-4TR

1998 by Sony Corporation Printed in China

3-862-269-14 (1)

Cassette-Corder

Operating Instructions

Mode d‘emploi

TCM-4TR

For the customers in the U.S.A.

Owner’s Record

The model number is located at the bottom and the serial number is

located inside the tape holder. Record the serial number in the space

provided below. Refer to whenever you call upon your Sony dealer

regarding this product.

Model No. TCM-4TR Serial No.

INFORMATION

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions:

(1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may

cause undesired operation.

You are cautioned that any changes or modifications not expressly

approved in this manual could void your authority to operate this

equipment.

Table of Contents

Welcome!...................................................................... 4

Getting Started

Preparing a Power Source ......................................... 6

Dry Batteries .......................................................... 6

House Current .................................................... 11

Operating the Unit

Playing a Tape ........................................................... 12

Playing a 4-track Tape ....................................... 12

Playing a 2-track Tape ....................................... 16

Adjusting the Playback Speed (DPC Function) ... 17

Recording ................................................................... 20

Recording Cue Marks .............................................. 26

Recording from Various Sound Sources ............... 28

Recording with an External Microphone ........ 28

Recording from Another Equipment............... 29

Additional Information

Precautions ................................................................ 30

Maintenance .............................................................. 32

Troubleshooting ........................................................ 33

Specifications ............................................................. 36

Location of parts and controls ................................ 38

Index ........................................................................... 40

LIMITED WARRANTY ........................................... 41

Welcome!

Thank you for purchasing the Sony Cassette-

Corder.

This Cassette-Corder is a product which Sony

Corporation developed specially for visually

impaired people. You can play back a tape

recorded on 4 tracks at 2.4 cm/s.

Some features are:

•You can play back a 4-track tape as well as a

normal 2-track tape.

•You can play back and record with two tape

speeds (4.8cm/s and 2.4cm/s).

•DPC (Digital Pitch control) allows you to increase

or decrease the speed of the playback sound

(page 17). If you change the playback tape speed,

the pitch will be automatically adjusted.

•The CUE MARKER function locates a specific

point on a recording (page 26).

•Built-in flat microphone for clear recording of

speaker’s voice.

•When the batteries are running out of power, a

beep sounds (page 9).

•The BATT/REC lamps indicate the remaining

battery power in two steps. A beep sounds and

the i lamp shows when to replace the batteries

(page 9).

•Automatic shut-off mechanism at the end of the

tape (in the recording/playback mode only).

•Stop-pause-release function —The pause switch

is released automatically when the p STOP

button is depressed, so that you won’t miss a

recording chance (pages 15, 22).

Notes

•Recording can be made with 2 speeds but only

on 2 tracks. Note that 4-track recording cannot

be made.

•A tape recorded in stereo cannot be played

back properly.

•A tape recorded with 2.4cm/s tape speed

using this unit cannot be played back on a

normal tape recorder.

}

]

z Getting Started

Preparing a Power Source

Choose either one of the following power sources:

dry batteries (see below) or house current (see

page 11).

Dry Batteries

Make sure that nothing is connected to the DC IN

3 V jack.

1 Open the battery compartment lid.

2 Insert two R6 (size AA) batteries (not

supplied) with correct polarity and close the

lid.

DC IN 3V jack

}

]

}

]

Notes

•Do not charge a dry battery.

•Do not use a new battery with an old one.

•Do not use different types of batteries.

•When you do not use the unit for a long time, remove

the batteries to avoid any damage caused by battery

leakage and subsequent corrosion.

•Dry batteries will not be expended when another

power source is connected.

To take out the batteries

To attach the battery compartment lid

if it is accidentally detached

Attach it as illustrated.

Continued

Preparing a Power Source (continued)

Battery life (Approximate hours) (EIAJ*)

Sony alkaline Sony

LR6(SG) R6P(SR)

Recording (4.8cm/s) 6.5 1.0

Recording (2.4cm/s) 7.0 1.5

Playback (4.8cm/s) 6.5 1.0

Playback (2.4cm/s) 7.0 1.5

* Measured value by the standard of EIAJ (Electronic

Industries Association of Japan)(Using a Sony HF-

series cassette tape)

We recommend to use long-life alkaline batteries.

Note

The battery life may shorten depending on the

operation of the unit.

When to replace the batteries

When the batteries are running out of power, a

beep sounds and the BATT/REC lamps go off and

the i lamp flashes. When this happens, replace

the batteries with new ones.

The BATT/REC lamps change as illustrated.

When batteries

are new

When batteries

become weak

light

flash

Replace batteries

light

Continued

(A beep sounds.)

Preparing a Power Source (continued)

Notes

•During recording, you will hear the beep through the

earphone. During playback, you will hear the beep

through the earphone and the speaker.

•During FF (CUE) or REW (REVIEW), the i lamp may

flash with a beep. Only when the tape does not run

properly, replace the batteries.

•In some cases when the unit is used with rechargeable

batteries, only one BATT/REC lamp will light even

though the batteries have been fully charged.

•After the batteries have been used for a while, the

BATT/REC lamp(s) may flash with the playback

sound when you turn up the volume; however, this

does not mean that you need to replace the batteries.

•The unit will play back normally for a while even after

i lamp flashes with a beep. However, replace the

batteries as soon as you can. If you do not, a loud

noise may be emitted by the built-in speaker or

subsequent recording will not be done correctly.

•When the tape starts running or at the end of the tape

the i lamp may momentarily light with a short beep.

If the lamp goes off, you do not need to replace the

batteries.

House Current

Connect the AC power adaptor to DC IN 3V and

to the wall outlet. Use a commercially-available

AC power adaptor (rated output voltage/current:

3 V DC/700 mA). Do not use any other AC power

adaptor.

DC IN 3V

to the wall outlet

Polarity of the plug

Notes

•The voltage of power supply is different depending on

the country. Please buy an AC power adaptor in the

country where the product is to be used.

•Depending on the AC power adaptor, noise may be

heard while using the unit. Refer to the operating

instructions of the AC power adaptor.

AC power adaptor (not supplied)

z Operating the Unit

Playing a Tape

Playing a 4-track Tape

1 Open the cassette compartment lid.

2 Insert a cassette with the side to start

playing facing the lid.

3 Close the cassette compartment lid.

4 Set TAPE SPEED to 2.4 (cm/s) .

( PLAY

TAPE TRACK

TAPE SPEED

5 Set TAPE TRACK to 1-2 or 3-4 and start

playback.

To play the tape from the beginning, follow the

procedure below. Make sure that side A is

facing the lid.

1 Set TAPE TRACK to 1-2 and press ( PLAY.

Track 1 will be played. At the end of the

tape, playback stops automatically.

2 Take out the cassette and reinsert the cassette

with side B facing the lid.

3 Leaving TAPE TRACK at 1-2, press

( PLAY. Track 2 will be played.

4 Take out the cassette and reinsert the cassette

with side A facing the lid.

5 Set TAPE TRACK to 3-4 and press ( PLAY.

Track 3 will be played.

6 Take out the cassette and reinsert the cassette

with side B facing the lid.

7 Leaving TAPE TRACK at 3-4, press

( PLAY. Track 4 will be played.

When the tape comes to an end

Playback stops and the unit turns off automatically

(Automatic shut-off mechanism).

After fast forward or rewind, press p STOP, as the unit

does not automatically enter the stop mode at the end of

the tape.

Continued

VOL

p STOP

) FF/CUE

0 REW/

REVIEW

( PLAY

TAPE TRACK

Playing a Tape (continued)

TAPE SPEED

PAUSE c

EAR jack

Adjust the volume

Stop playback/stop

fast forward or

rewind

Pause playback

Fast forward**

Rewind**

Do this

Turn VOL.

Press p STOP.

Slide PAUSE c.

To release pause playback, release

PAUSE c*.

Press ) FF/CUE during stop.

Press 0 REW/REVIEW during

stop.

Do this

Press and hold ) FF/CUE and

release it at the point you want.

Press and hold 0 REW/REVIEW

and release it at the point you

want.

Press p STOP and open the

cassette compartment lid by hand.

* PAUSE c will be also automatically released when

p STOP is pressed (stop-pause-release function).

**If you leave the unit after the tape has been wound or

rewound, noise will be heard. Be sure to depress

p STOP. Otherwise, the batteries will be consumed

rapidly.

Search forward

during playback

(CUE)

Search backward

during playback

(REVIEW)

Take out a cassette

To listen through the earphones

Connect the supplied earphones to the EAR jack.

Continued

Playing a Tape (continued)

Playing a 2-track Tape

1 Proceed with steps 1 to 3 on page 12.

2 Set TAPE SPEED to 2.4 (cm/s) or 4.8 (cm/s) to

match the tape speed used for recording.

3 Set TAPE TRACK to 1-2.

4 Press ( PLAY.

Other operations are the same as those of playing a

4-track tape described on pages 14 and 15.

Note

If the recording is made in stereo, only the L channel is

heard.

Adjusting the Playback

Speed (DPC Function)

The DPC (Digital Pitch Control) function allows

you to increase or decrease the playback speed.

When playing back a tape with 2.4cm/s tape speed

such as a 4-track tape, the playback speed will be

adjusted from approximately +100% to 0%.

When playing back a tape with 4.8cm/s tape

speed, the playback speed will be adjusted from

approximately +100% to –50%.

If you change the playback tape speed, the pitch

will be automatically adjusted.

Continued

Adjust DPC as follows:

To play back Set DPC to

faster (2.4 cm/s tape) FAST

(4.8 cm/s tape) FAST

at normal speed Center

slower (2.4 cm/s tape ) Not available

(4.8 cm/s tape) SLOW

DPC

Adjusting the Playback Speed (DPC Function)

(continued)

Notes

•When playing back a tape with 2.4cm/s tape speed,

the playback speed will be normal even if you set DPC

to SLOW.

•Even though you use DPC, you cannot acquire the

same pitch as the original. The tone will be somewhat

different from the original.

•When the power of the batteries is weak, the DPC may

make noise if you turn it fast. In that case turn it

slowly or change the batteries.

•When DPC is turned or the volume is adjusted during

playback, BATT/REC lamps may flicker.

Recording

You can record the sound easily with the built-in

microphone. Use a normal (TYPE I) tape.

Make sure that nothing is connected to the MIC

jack.

1 Open the cassette compartment lid.

2 Take out any slack in the tape and insert the

cassette with the side to start recording

facing the lid.

3 Close the cassette compartment lid.

La page charge ...

Sony TCM 4TR Mode d'emploi

Marque: Sony

Modèle: TCM 4TR

Catégorie: Lecteurs de cassettes

Taper: Mode d'emploi

Ce manuel convient également à

TCM-4TR

Télécharger le PDF

rapport

dans d''autres langues

English: Sony TCM 4TR User guide

Documents connexes

Autres documents

Nakamichi NA3625-W6 Manuel utilisateur