AudioSource Preamp 5.1 Le manuel du propriétaire
- Catégorie
- Égaliseurs audio
- Taper
- Le manuel du propriétaire
Basic Guidelines
The preamplifier is the control unit of your audio system. The Preamp 5.1 is a dual channel preamplifier. In the
modular chassis, the Preamp 5.1 links the modular amplifiers and/or equalizers to your source component, such
as a CD or DVD player.
Using The Controls
Power
Press this switch to turn the unit on or off. The red LED in the switch will light to show power is on.
Level
Turn this knob clockwise to increase the overall system volume. Be careful not to set the level so high as to
cause distortion, which could damage the speakers.
Bass & Treble
Turn these knobs clockwise to increase the amount of bass (low frequencies) or treble (high frequencies).
The 12:00 position indicates a flat response, equal levels of bass, treble and midrange.
Balance
Turn this knob clockwise or counterclockwise to change the proportion of the signal output to either channel.
The 12:00 position indicates equal output to each channel.
Line
This button refers to the inputs on the back of the Preamp 5.1. If you are using XLR or balanced inputs (line 2),
depress this button. If you are using RCA or unbalanced inputs (line 1), leave this button in the out position.
Tone
This button corresponds to the bass and treble knobs. To engage the bass and treble knobs, depress this button. To bypass the bass and treble knobs, so
that they do not affect your sound, leave this button in the out position.
Hooking It Up
When connecting the Preamp
5.1, turn off or unplug your
components. This prevents
loud “pops” that might
damage your speakers
while you connect the cables.
The diagram at right shows
the Preamp 5.1 in conjunction
with other components from
AudioSource’s modular separates
line. The equalizer is optional, and
you can substitute any amplifier
or equalizer; the setup is the same.
Also, XLR/balanced connections
follow the same paths as the
RCA/unbalanced connections
described below.
1. Connect the source component
(e.g. DVD player, CD player, cassette deck, microphone) to the Preamp 5.1 input.
2. If you are using a graphic equalizer, connect the two output channels of the Preamp 5.1 to the equalizer inputs. In this diagram, Channel 1 is left and
Channel 2 is right. Connect the Channel 1 and 2 outputs from the equalizer to the amplifier inputs. Please note that the Amp 5.1 is a single-channel
monoblock amplifier, so two are shown here. Rather than two monoblocks, you could use a single stereo amplifier, such as an Amp 6.2 or 6.3.
3. If you are not using a graphic equalizer, connect the two output channels of the Preamp 5.1 to the amplifier inputs.
6
5
4
3
2
1
InOut21
Line Tone
Power
Preamp 5.1
Dual Channel Preamplifier
Level
Bass Balance Treble
Owner’s Manual
EQ 25.1
Balanced Input
Speaker Output
+
–
Unbalanced
Line In
Line Out/
Thru
120 VAC 60 Hz 200 Watts
Amp 5.1
Balanced Input
Speaker Output
+
–
Unbalanced
Line In
Line Out/
Thru
120 VAC 60 Hz 200 Watts
Amp 5.1
Ch. 1 In Ch. 2 In
Ch. 1 Out
Line 2
Line 2
Ch. 2 Out
120 VAC 60 Hz 12 Watts
InCh. 1 Ch. 2 OutCh. 1 Ch. 2
Line 1
Preamp 5.1
DVD Player,
CD Player or
Other Source
L
Audio Out
R
L
Audio In
R
Ch. 1 In
Line 2
Ch. 2 In
Ch. 1 Out
Line 2
Ch. 2 Out
120 VAC 60 Hz 12 Watts
InCh. 1 Ch. 2 OutCh. 1 Ch. 2
Line 1
EQ 25.1
Modular Dual Channel Preamplifier
Preamp 5.1
This manual provides detailed instructions for setting up your equipment. We also offer friendly, toll-free assistance.
1.800.HELP.115
9300 North Decatur
Portland, OR 97203
Tel. 503.286.9300
Fax 503.978.3302
audiosour[email protected]
www.audiosource.net © 2000 AudioSource, Inc.
Read Instructions
All the safety and operating instructions should be read before the appliance
is operated.
Retain Instructions
The safety and operating instructions should be adhered to.
Heed Warnings
All warnings on the appliance and in the operating instructions should be
adhered to.
Follow Instructions
All operating and use instructions should be followed.
Water and Moisture
The appliance should not be used near water. For example, near a bathtub,
washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming
pool, etc.
Ventilation
The appliance should be situated so that its location or position does not
interfere with its proper ventilation. For example, the appliance should not be
situated on a bed, sofa, rug, or similar surface that may block the ventilation
openings; or, placed in a built-in situation, such as a bookcase or cabinet that
may impede the flow of air through the ventilation openings.
Heat
The appliance should be situated away from heat sources such as radiators, heat
registers, stoves, or other appliances (including amplifiers) that produce heat.
Power Sources
The appliance should be connected to a power supply only of the type
described in the operating instructions or as marked on the appliance.
Grounding or Polarization
Precautions should be taken so that the grounding or polarization means of
an appliance is not defeated.
Power Cord Protection
Power supply cords should be routed so that they are not likely to be walked
on or pinched by items placed on or against them, paying particular attention
to cords at plugs, convenience receptacles, and the point where they exit from
the appliance.
Cleaning
The unit should be cleaned only as recommended by the manufacturer.
Power Lines
An outdoor antenna should be located away from power lines.
Non-Use Periods
The power cord of the appliance should be unplugged from the outlet when
left unused for a long period of time.
Object and Liquid Entry
Care should be taken so that objects do not fall and liquids are not spilled
into the enclosure through openings.
Damage Requiring Service
The appliance should be serviced by qualified service personnel when: a) The
power supply cord or the plug has been damaged; b) Objects have fallen, or
liquid has been spilled into the appliance; c) The appliance has been exposed
to rain; d) The appliance does not appear to operate normally or exhibits a
marked change in performance; or e) The appliance has been dropped, or the
enclosure damaged.
Servicing
The user should not attempt to service the appliance beyond that described in
the operating instructions. All other servicing should be referred to qualified
service personnel.
Product Servicing
In the event your Preamp 5.1 fails to operated properly, please contact the
dealer where you purchased the unit. Or you may contact AudioSource
directly for further assistance.
Safety Instructions
Warning: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
Caution: To reduce the risk of electric shock, do not remove cover (or back); no user serviceable parts inside. Refer servicing to qualified service personnel.
Caution: To prevent electric shock, match wide blade of plug to wide slot, fully insert.
Attention: Pour eviter les chocs electriques, introduire la lame la plus large de la fiche dans la borne correspondante de la prise et pousser jusqu'au fond.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the prod-
uct's enclosure that may be of sufficient magnitude to constitute a risk of electrical shock to persons. The exclamation point within an equilateral triangle is intended to
alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
Total Harmonic Distortion . . . . . . . . . . . . . . . . . . . . .<0.008%
Frequency Response . . . . . . . . . . . .10Hz to 100kHz, ±0.5dB
Signal to Noise Ratio . . . . . . . . . . . . . . . . . . . . .110 dB (line)
Input Sensitivity . . . . . . . .250 MV input for 1 V output (line)
Input Impedance . . . . . . . . . . . . . . . . . . . . . . . .47 K Ω (line)
Inputs . . . . . . .Line 1 (RCA/Unbalanced), Line 2 (XLR/Balanced)
Outputs . . . . .Line 1 (RCA/Unbalanced), Line 2 (XLR/Balanced)
Power Consumption . . . . . . . . . . . . . . . . . . . . . .6 Watts
Dimensions . . . . . . . . . . . . . 7.125" x 2.25" x 16.5", 3.25 lbs.
Preamp 5.1 Specifications
Design and specifications are subject to change without notice.
Note: If any part of this product is damaged or missing, do not contact your AudioSource dealer. Please call us directly at 800-435-7115.
-
1
-
2
AudioSource Preamp 5.1 Le manuel du propriétaire
- Catégorie
- Égaliseurs audio
- Taper
- Le manuel du propriétaire
