REOLINK Lumus WiFi Security Camera Outdoor Mode d'emploi

REOLINK
Marque
REOLINK
Modèle
Lumus WiFi Security Camera Outdoor
Taper
Mode d'emploi
Reolink Lumus
Quick Start Guide
December 2020
QSG2_B_EN
58.03.001.0160 @ReolinkTech https://reolink.com
2English
1 English
Contents
EN
What’s in the Box
Camera Introduction
Set up the Camera
Installation Guide
Troubleshooting
Specifications
Notification of Compliance
2
3
4
5
9
10
10
What’s in the Box
Camera Bracket
Pack of Screws
Surveillance Sign
Mounting TemplateReolink Lumus Power Adapter
Quick Start Guide
Reset Needle
4English3 English
Camera Introduction
• On Smartphone
Download and Launch the Reolink App or Client software, and follow the onscreen instructions
to finish initial setup.
Scan to download the Reolink App.
Set up the Camera
• On PC
Download path of the Reolink Client: Go to https://reolink.com > Support > App & Client.
Spotlight
Daylight Sensor
Status LED
Built-in Mic
Reset Button
PIR Motion Sensor
Micro SD Card Slot
Power Cable
Speaker
* Press for more than five seconds to restore the device to default settings.
* Always keep the rubber plug closed firmly.
Lens
Blinking: WiFi Connection failed
On: Camera is starting up/WiFi Connection succeeded
6English5 English
Mount the Camera
Rotate to separate parts from
the bracket.
Drill holes in accordance with the mounting hole
template and screw the base of the bracket onto
the wall. Next, attach the other part of the bracket
onto the base.
Fasten the camera to the bracket by turning the
screw identified in the following chart anticlockwise.
• Install the camera 2-3 meters (7-10 ft) above
the ground. This height maximizes the
detection range of the PIR motion sensor.
• For better motion detection performance,
please install the camera angularly.
NOTE: If a moving object approaches the
PIR sensor vertically, the camera may fail
to detect motion.
Installation Guide
θ
Mounting Height:
2-3 Meters
PIR Detection Distance:
2-7 Meters
AB
Secure the camera by turning the
part on the bracket identified in
the chart clockwise.
NOTE: To adjust the camera angle, please loosen the bracket by turning the upper
part anticlockwise.
8English
7 English
Important Notes on
Reducing False Alarms
!
Adjust the camera angle to get the
best field of view.
• Do not face the camera towards any objects with bright lights, including sunshine,
bright lamp lights, etc.
• Do not place camera near any outlets, including the air conditioner vents, humidifier
outlets, the heat transfer vents of projectors, etc.
• Do not install the camera at places with strong winds.
• Do not face the camera towards a mirror.
• Keep the camera at least 1 meter away from any wireless devices, including WiFi
routers and phones to avoid wireless interference.
Troubleshooting
IP Cameras Is Not Powering on
If your camera is not powering on,
please try the following solutions:
• Plug the camera into another power outlet.
• Use another 5V power adapter to power
up the camera.
If these won't work, please contact Reolink
Support https://support.reolink.com
If the camera failed to scan the QR code
on your phone, please try the following
solutions:
• Remove the protective film from the
camera lens.
• Wipe the camera lens with a dry
paper/towel/tissue.
• Vary the distance (about 30cm) between
your camera and the mobile phone which
enables the camera to focus better.
• Try to scan the QR code under sucient
lighting.
If these won't work, please contact Reolink
Support https://support.reolink.com
If the camera fails to connect to WiFi,
please try the following solutions:
• Please make sure the WiFi band is 2.4GHz,
the camera does not support 5GHz.
• Please ensure you have entered the correct
WiFi password.
• Put your camera close to your router to
ensure a strong WiFi signal.
• Change the encryption method of the WiFi
network to WPA2-PSK/WPA-PSK
(safer encryption) on your router interface.
• Change your WiFi SSID or password and
make sure that SSID is within 31 characters
and password is within 64 characters.
WiFi Connection Failed During
Initial Setup Process
Failed to Scan QR Code on the Phone
10English
9 English
Video Resolution:
1080p HD at 15 frames/sec
Field of View: Horizontal: 100°, Vertical: 54°
Night Vision: Up to 10m (33 ft)
Audio: Two-way audio
• Set your password with only characters on
the keyboard.
If these won't work, please contact Reolink
Support https://support.reolink.com
Mode: Motion Detection + PIR Detection
PIR Detection Angle: 100° horizontal
Audio Alert:
Customized voice-recordable alerts
Other Alerts:
Instant email alerts and push notifications
Video & Audio
Smart Alarm
Power: 5V/2A
WiFi Frequency: 2.4 GHz
Operating Temperature:
-10°C to 55°C (14°F to 131°F)
Weather Resistance:
IP65 certified weatherproof
Size: 99 x 91 x 60 mm
Weight: 185g (6.5 oz)
General
Specifications
Notification of
Compliance
FCC Compliance Statement
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
• this device may not cause harmful
interference, and
• this device must accept any interference
received, including interference that may
cause undesired operation.
11 English
Reolink declares that this device is in
compliance with the essential requirements
and other relevant provisions of Directive
2014/53/EU.
Simplified EU Declaration of
Conformity
This device contains licence-exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two
conditions:
(1) This device may not cause interference.
Use of the product is subject to your agreement
to the Terms of Service and Privacy Policy at
reolink.com. Keep out of the reach of children.
By using the Product Software that is
embedded on the Reolink product, you agree
to the terms of this End User License
Agreement (“EULA”) between you and Reolink.
Learn more: https://reolink.com/eula/.
This product comes with a 2-year limited
warranty that is valid only if purchased from
Reolink Ocial Store or a Reolink authorized
reseller. Learn more:
https://reolink.com/warranty-and-return/.
Correct Disposal of This Product
Limited Warranty
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment shall be installed
and operated with minimum distance 20cm
between the radiator & body.
FCC RF Exposure Warning Statements
Terms and Privacy
End User License Agreement
ISED Statements
This marking indicates that this product should
not be disposed wit h other household wastes
throughout the EU. To prevent possible harm
to the environment or human health from
uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse
of material resources. To return your used
device, please use the return and collection
systems or contact the retailer where the
product was purchased. They can take this
product for environment safe recycling.
12English
NOTE: We hope that you enjoy the new
purchase. But if you are not satisfied with the
product and plan to return, we strongly
suggest that you reset the camera to factory
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment o and on, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
default settings and take out the inserted SD
card before returning.
OPERATING FREQUENCY
If you need any technical help, please visit our
ocial support site and contact our support
team before returning the products,
https://support.reolink.com
Technical Support
The device has been evaluated to meet
general RF exposure requirements. The device
can be used in mobile exposure conditions.
The min separation distance is 20cm.
Déclaration d'exposition aux radiofréquences
Radio Frequency Exposure Statement for IC
(2) This device must accept any interference,
including interference that may cause
undesired operation of the device.
L’émetteur/récepteur exempt de licence
contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et
Développement économique Canada
applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux
conditions suivantes:
(1) L'appareil ne doit pas produire de
brouillage;
(2) L'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d' en compromettre le
fonctionnement
13 English
pour IC L'appareil a été évalué pour répondre
aux exigences générales en matière
d'exposition aux RF. L'appareil peut être utilisé
dans des conditions d'exposition mobiles. La
distance de séparation minimale est de 20cm.
2412-2462MHz/2422-2452MHz
(Maximum Conducted Peak Output Power)
(17.23dBm)
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

REOLINK Lumus WiFi Security Camera Outdoor Mode d'emploi

REOLINK
Marque
REOLINK
Modèle
Lumus WiFi Security Camera Outdoor
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents