MAXHUB SI07 Manuel utilisateur

Taper
Manuel utilisateur
All pictures in this manual are for reference only, the actual product shall prevail
WiFi Module
User Manual
Table of Contents
1. Special Statement ......................................................................................................................... 1
2. Safety Warning ............................................................................................................................... 1
3. Federal Communication Commission Interference Statement ..................................... 2
4. FCC Caution ..................................................................................................................................... 3
5. Non-modification Statement ...................................................................................................3
6. IC Radiation Exposure Statement for Canada ..................................................................... 4
7. Declaration of Toxic and Hazardous Substances in Electronic Information
Products ................................................................................................................................................ 6
8. Installation Steps ........................................................................................................................... 8
9. Software Settings .......................................................................................................................... 9
10. Key Specifications .................................................................................................................... 10
1
1. Special Statement
Intellectual property statement: the hardware design and software programs of
this product are copyright protected. Anyone copying the contents of this
product and instructions without the authorization of this company will bear
the corresponding legal responsibilities.
This manual is for reference only. The actual final functions are subject to the
actual ordering of the customer and the actual functions of the product
received.
The pictures are for reference only, please refer to the actual product. The
company reserves the right to make improvements on and changes to the
product appearance and design without prior notice.
2. Safety Warning
Before operating this equipment, please read and observe the following
precautions carefully to prevent improper operation.
Do not use the device in dusty and humid places to avoid causing internal
circuit failures.
Do not place the device near heating objects such as electric heaters.
This device and accessories may contain some small parts, please keep them
out of the reach of children to avoid danger.
The device is not waterproof, please keep it dry.
2
The working temperature of this equipment is 0~40, and the working
humidity is 10~90%RH.
Please contact professional maintenance personnel for all maintenance
services.
Do not insert any sharp objects into the device.
Do not drop or hit the device to avoid damage to the device.
3. Federal Communication Commission Interference
Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
3
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
4. FCC Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Caution: The user is cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to
operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20cm between the radiator and any part of your body.
4
5. IC Radiation Exposure Statement for Canada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canadas licence-exempt RSS(s).
Operation is subject to the following two conditions:
1.This device may not cause interference.
2.This device must accept any interference, including interference that may cause
undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR dInnovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. Lexploitation est autorisée aux
deux conditions suivantes :
1.Lappareil ne doit pas produire de brouillage;
2.Lappareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible den compromettre le fonctionnement.
This equipment complies with ISED RSS-102 radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20cm between the radiator and any part of your body.
Pour se conformer aux exigences de conformité CNR 102 RF exposition, une
distance de séparation d'au moins 20 cm doit être maintenue entre l'antenne de
cet appareil ettoutes les personnes.
The device for operation in the band 51505250 MHz is only for indoor use to
reduce the potential for harmful interference to co-channel mobile satellite systems
5
Les dispositifs fonctionnant dans la bande de 5 150 à 5 250 MHz sont réservés
uniquement pour une utilisation à lintérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes
canaux.
Hereby, Guangzhou Shirui Electronics Co., Ltd. declares that the radio
equipment type SI06 is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the
following internet address: www.seewo.com.
This symbol, affixed to the product or its packaging, indicates that the
product must not be processed with househlod waste. It must be brought to an
electric and electronic waste collection point for recycling and disposal. By the
appropriate disposal of this product you also help in preventing potentially
negative consequences for the environment and human health. The recycling of
materials helps preserve our natural resources. For further information regarding
the recycling of this product, please contact your municipality, local waste disposal
centre or the store where the product was purchased.
6
6. Declaration of Toxic and Hazardous Substances in
Electronic Information Products
Part Name
Toxic and harmful substances or elements
Pb
Hg
Cd
Cr(VI)
PBB
PBDE
Metal shell
Circuit board
×
Wire
Structure
7
8
7. Installation Steps
WarningBe sure to disconnect the power cord of the conference panel
before installation.
1) Removal wireless model board of the conference panel bottom,screw should
be keep.
2) Insert the wireless module fully into the slot at the bottom of the conference
panel.
9
3) After installing the wireless module, attach the screws to both sides of the
wireless module.
NoteThis wireless module must be inserted into the upper slot to work for the
conference panel.
8. Software Settings
After the installation is completed, turn on the conference panel and the wireless
module will run automatically.
1) Click on the sidebar menu " Settings".
2) Set the menu to select the"Network"- "Wireless Hotspot" menu.
3) Click on“ ”icon, can turn on/off the wireless hotspot function.
10
9. Key Specifications
1Wi-Fi
Wi-Fi Operating Mode: AP+STA
Wi-Fi Support Version: 802.11 a/b/g/n/ac
Wi-Fi Working Frequency: 2.4G&5G
Wi-Fi Working Distance: 0~12 Meters
2Bluetooth
Bluetooth Support Version4.2
Bluetooth Working Frequency2.4GHz
Bluetooth Working Distance0~10 Meters
NotePlease refer to the rear nameplate for the model approval code identification
of this equipment.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

MAXHUB SI07 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues