BH WC900 Manuel utilisateur

Taper
Manuel utilisateur
WC900 Wireless charger
Unit
BH provides WC900 wireless charging unit and
car maker combines WC900 wireless charging unit
and frame
The combined WC900 is installed the front
area of center console.
Installation instruction
Use cases
1. Mainly this WC900 can be used for mobile phone wireless charging.
2. Also can charge all devices meet WPC/PMA/A4WP standards
FCC, IC Compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the manufacturer (or party responsible) for compliance could void the user’s authority to
operate the equipment
FCC RF Radiation Exposure Statement: This equipment complies with FCC RF Radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with a minimum distance of 8 cm between the radiator and your body.
IC Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 8 cm between the radiator & your body.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED
MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
This device contains licence-exempt transmitter(s)/receiver that comply with Innovation, Science and Economic Development Canada's licence-
exempt RSS(s).
Operation is subject to the following two conditions:
1.This device may not cause interference.
2.This device must accept any interference, including interference that may cause undesired operation of the device.
Avis d’Industrie Canada sur l’exposition aux rayonnements
Cet appareil est conforme aux limites d’exposition aux rayonnements d’Industrie Canada pour un environment non controle. Il doit etre installe de
facon a garder une distance minimale de 8 centimetres entre la source de rayonnements et votre corps.
REMARQUE: LE FABRICANT N'EST PAS RESPONSABLE DES INTERFERENCES RADIOELECTRIQUES CAUSEES PAR DES
MODIFICATIONS NON AUTORISEES APPORTEES A CET APPAREIL. DE TELLES MODIFICATIONS POURRAIT ANNULER
L'AUTORISATION ACCORDEE A L’UTILISATEUR DE FAIRE FONCTIONNER L'APPAREIL.
Cet appareil contient des emetteurs / recepteurs exempts de licence qui sont conformes aux RSS exempts de licence d'Innovation, Sciences et
Developpement economique Canada.
L’exploitation est autorisee aux deux conditions suivantes :
1.L’appareil ne doit pas produire de brouillage;
2.L’appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d’en compromettre le fonctionnement.
  • Page 1 1
  • Page 2 2
  • Page 3 3

BH WC900 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues