Installation & User manual

1.Put your phone on wireless charging pad directly and on the center of charging pad.

2. Check the phone if it was charged or not. you can check on the mobile phone screen

If the phone was not charged, please try to put your phone on the charging area again.

•Mainly this wireless charging unit can be used for wireless charging mobile phone.

•Also can charge all devices meet WPC(Qi) standards

FCC, IC Compliance statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

IC Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be

installed and operated with minimum distance 15 cm between the radiator & your body.

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS

EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

This device contains licence-exempt transmitter(s)/receiver that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s).

Operation is subject to the following two conditions:

Avis d’Industrie Canada sur l’exposition aux rayonnements

Cet appareil est conforme aux limites d’exposition aux rayonnements d’Industrie Canada pour un environment non controle. Il doitetre installe de facon a garder

L’exploitation est autorisee aux deuxconditions suivantes:

(1) L’appareil ne doit pas produire de brouillage;

(2) L’appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d’en compromettre le fonctionnement