Bhevs WC900A05 Manuel utilisateur

Taper
Manuel utilisateur
Users manual
Wireless charger Unit
BH provides wireless charging unit and
car maker combines wireless charging
unit and frame.
The combined wireless charging unit is
installed the front area of center console.
2. Type 2 : Located in front of arm rest
3. Type 3 : Located in center dashboard
1. Type 1 : Located in arm rest
1
1. Put your phone on wireless charging pad directly and on the center of charging pad.
2. Check the phone if it was charged or not. you can check on the mobile phone screen
If the phone was not charged, please try to put your phone on the charging area again.
Mainly this wireless charging unit can be used for wireless charging mobile phone.
Also can charge all devices meet WPC standards
Users manual
2
FCC, IC Compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the manufacturer (or party responsible) for compliance could void the user’s authority to
operate the equipment
FCC RF Radiation Exposure Statement: This equipment complies with FCC RF Radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with a minimum distance of 4 cm between the radiator and your body.
IC Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 4 cm between the radiator & your body.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED
MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
This device contains licence-exempt transmitter(s)/receiver that comply with Innovation, Science and Economic Development Canada's licence-
exempt RSS(s).
Operation is subject to the following two conditions:
1.This device may not cause interference.
2.This device must accept any interference, including interference that may cause undesired operation of the device.
Avis d’Industrie Canada sur l’exposition aux rayonnements
Cet appareil est conforme aux limites d’exposition aux rayonnements d’Industrie Canada pour un environment non controle. Il doitetreinstalle de
facon a garder une distance minimale de 4 centimetres entre la source de rayonnements et votrecorps.
REMARQUE: LE FABRICANT N'EST PAS RESPONSABLE DES INTERFERENCES RADIOELECTRIQUES CAUSEES PAR DES
MODIFICATIONS NON AUTORISEES APPORTEES A CET APPAREIL. DE TELLES MODIFICATIONS POURRAIT ANNULER
L'AUTORISATION ACCORDEE A L’UTILISATEUR DE FAIRE FONCTIONNER L'APPAREIL.
Cet appareilcontient des emetteurs / recepteursexempts de licence qui sontconformes aux RSS exempts de licence d'Innovation, Sciences et
Developpement economique Canada.
L’exploitation est autorisee aux deuxconditions suivantes:
1.L’appareil ne doit pas produire de brouillage;
2.L’appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d’en compromettre le fonctionnement.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Bhevs WC900A05 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues