GEM GROUP 101518 Manuel utilisateur

Marque
GEM GROUP
Modèle
101518
Taper
Manuel utilisateur
Operation Overview
Indicating status and protection function
1. LED blue light: Standby
2. LED green light: Charging
3. Blue light flashing: device is not correctly placed on the wireless charger,
over temperature protection, or detects metal on the back of the device
1.Only the QC2.0/QC3.0 Standard power adapter can support this product's
fast charging. Adapters are not included with the product.
2.The iPhone 12 mini and iPhone 13 mini cannot be used on this charger.
1. Plug the power adapter into the wall socket (adapter not included)
2. USB-A side connects to the power wall adapter, USB-C side connects to
the wireless charger side, the LED light will illuminate blue which means the
unit is ready to charge your device.
3. Place your device on to the charging stand, the LED light will change from
blue to green which denotes the device is being charged.
USB Adapter
Auden Bamboo Wireless
Charging Pencil Cup
Instruction Manual
IC ID: 21530-101518
FCC ID: 2AGR4-101518
USB Micro Cable
Type-C interface
Indicator
Wireless
charger
Pen/Pencil Holder
Type-c interface
Packing
Auden Bamboo Wireless Charging Pencil Cup
USB-A to USB-C Type Charging Cable
User Manual
Specification
Qi Certified
Input : 5V/2.0A, 9V/2.0A
Output : 5W/7.5W/10W
Charging frequency: 110.3-205 KHz
Transmission Distance: ≤5mm Efficiency: ≥75%
Product size: L152*W82*H135mm
Note
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is
Subject To the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference
that may cause undesired operation. Changes or modifications not
explicitly approved by the party responsible for compliance could
void the user's authority to operate this equipment.
Note: this equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and candidate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communica-tions.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. During the operation of
device a distance of 15 cm surrounding the device and 20 cm
above the top surface of the device must be respected.
ISED Statement
This device complies with Industry Canada’s license-exempt RSSs.
Operation is subject to the following two conditions:
● This device may not cause interference; and
● This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:
● l’appareil ne doit pas produire de brouillage;
● l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
This equipment complies with Canada radiation exposure limits set
forth for an uncontrolled environment.
During the operation of device a distance of 10 cm surrounding the
device and 10 cm above the top surface of the device must be
respected.
Cet équipement est conforme Canada limites d'exposition aux
radiations dans un environnement non contrôlé.
au cours de l'opération de l'appareil sur une distance de 10 cm
autour de l'appareil et de 10 cm
au - dessus de la surface supérieure de l'appareil doit être respecté.
  • Page 1 1

GEM GROUP 101518 Manuel utilisateur

Marque
GEM GROUP
Modèle
101518
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents