Powerfist 9032228 Le manuel du propriétaire

Powerfist
Marque
Powerfist
Modèle
9032228
Taper
Le manuel du propriétaire
SPECIFICATIONS
HAZARD DEFINITIONS
INTRODUCTION
SAFETY
WARNING! Read and understand all instructions before
using this tool. The operator must follow basic
precautions to reduce the risk of personal injury
and/or damage to the equipment.
WORK AREA
PERSONAL SAFETY
WARNING! Wear personal protective equipment
approved by the Canadian Standards Association (CSA)
or American National Standards Institute (ANSI).
PERSONAL PROTECTIVE EQUIPMENT
PERSONAL PRECAUTIONS
SPECIFIC SAFETY PRECAUTIONS
WARNING! DO NOT let comfort or familiarity with
product (gained from repeated use) replace strict
adherence to the tool safety rules. If you use this tool
unsafely or incorrectly, you can suffer serious personal
injury.
AIR TOOL SAFETY
AIR SUPPLY SAFTEY
WARNING! Compressed air can be dangerous. Ensure
that you are farmilair with all precautions relating to
the use of compressors and compressed air supply.
Failure to do so could result in serious injury.
UNPACKING
WARNING! Do not operate the tool if any part is
missing. Replace the missing part before operating.
Failure to do so could result in a malfunction and
personal injury.
IDENTIFICATION KEY
ACCESSORIES
ASSEMBLY & INSTALLATION
WARNING! Only use qualified cutting blade that has an
RPM rating equal to or greater than the tool itself.
Failure to do so could result in seroius injury.
WARNING! Make sure that a mark of the rotation
direction arrow is visible on the cutting blade surface
and that the cutting blade should be placed with the
rotation direction being the same as that of the tool.
Failure to do so could result in seroius injury.
NOTICE! Place 2-3 drops of air tool
oil (not provided) into the air inlet (C)
before each use.
OPERATION
WARNING! Always ensure that the
tool has come to a complete stop
before putting it down after use.
Failure to do so could result in
seroius injury.
WARNING! When stopping your work,
turn the water flow regulator (E)
clockwise to the off position and do
not have water flow through the
water tubing (H) and the circular
water distribution hose (L). Failure to
do so could result in seroius injury.
NOTICE! Start the wet air cutter (A)
and have it run at lower speed before
applying the tool to the workpiece.
NOTICE! The maximum tool speed can be obtained by
fully depressing the trigger (B).
CARE & MAINTENANCE
WARNING! Only qualified service personnel should
repair the tool. An improperly repaired tool may
present a hazard to the user and/or others.
LUBRICATION
NOTICE! Do not use detergent oil. Air tool oil is
available at major tool hardware stores. SAE #10
weight oil, sewing machine lubricant or any other high
grade turbine oil containing moisture absorbent, rust
inhibitors, metal wetting agents and an EP (extreme
pressure) additive may be used as a substitute.
DISPOSAL
IMPORTANT! DO NOT pollute the environment by
allowing uncontrolled discharge of waste oil.
TROUBLESHOOTING
Problem(s)
Possible Cause(s)
Suggested Solution(s)
PARTS BREAKDOWN
PARTS LIST
#
QTY
PARTS LIST (AIR SYSTEM)
#
DESCRIPTION
SPÉCIFICATIONS
DÉFINITIONS DE DANGER
INTRODUCTION
SÉCURITÉ
AVERTISSEMENT ! Veuillez lire et comprendre toutes
les instructions avant d'utiliser cet outil. L'utilisateur
doit respecter les précautions de base lorsqu'il utilise
cet outil afin de réduire le risque de blessure ou de
dommage à l'équipement.
AIRE DE TRAVAIL
SÉCURITÉ PERSONNELLE
AVERTISSEMENT ! Portez de l'équipement de
protection personnelle homologué par l'Association
canadienne de normalisation (CSA) ou l'American
National Standards Institute (ANSI).
ÉQUIPEMENT DE PROTECTION PERSONNELLE
PRÉCAUTIONS PERSONNELLES
La page charge ...
La page charge ...
La page charge ...
La page charge ...
La page charge ...
La page charge ...
La page charge ...
La page charge ...
La page charge ...
La page charge ...
La page charge ...
La page charge ...
La page charge ...
La page charge ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34

Powerfist 9032228 Le manuel du propriétaire

Powerfist
Marque
Powerfist
Modèle
9032228
Taper
Le manuel du propriétaire
Télécharger le PDF
rapport

dans d''autres langues

Autres documents