JBL ON STAGE 200ID Manuel utilisateur

Marque: JBL

Modèle: ON STAGE 200ID

Catégorie: Haut-parleurs d'amarrage

Taper: Manuel utilisateur

JBL ON STAGE

™*

200ID

SPEAKER DOCK FOR iPod AND iPhone

USER GUIDE

English............................... 2

Français ............................ 6

Deutsch........................... 10

Italiano ............................ 14

Español ........................... 18

Nederlands..................... 22

㘆#ສ

............................... 26

Dansk .............................. 30

Japanese ........................ 34

Ё᭛................................. 38

Русский

.......................... 42

Svenska .......................... 46

Suomi .............................. 50

Norsk ............................... 54

iPod not included/iPod non inclus.

0068CSK - JBL OnStage 200iD UG v3.indd 10068CSK - JBL OnStage 200iD UG v3.indd 1 29/09/08 10:16:4129/09/08 10:16:41

JBL ON STAGE 200

ID USER GUIDE

Read these instructions, heed all warnings and keep for future reference.

•

Do not use this apparatus near water.

•

Clean only with a dry cloth.

•

Do not block any ventilation openings; a minimum distance of 10mm around the entire apparatus is required for sufﬁ cient ventilation.

•

No naked ﬂ ame sources, such as lighted candles, should be placed on or near the apparatus.

•

Attention should be drawn to the environmental aspects of battery disposal.

•

The apparatus is to be used in moderate climates only.

•

Do not install near any heat sources such as radiators, heat registers, stoves or other apparatuses (including ampliﬁ ers) that produce heat.

•

Do not defeat the safety purpose of the polarized or grounding-type plug. A polarizing plug has two blades with one wider than the other. A grounding-type plug has

•

two blades and a third grounding prong. The wide blade or third prong is provided for safety. If the provided plug does

not ﬁ t into your outlet, consult an electrician for replacement of the obsolete outlet.

Protect the power cord from being walked on or pinched, particularly at the plugs and convenience receptacles, and at the point where they exit from the

•

apparatus.

Only use attachments/accessories speciﬁ ed by the manufacturer.

•

Unplug this apparatus during lightning storms or when unused for long periods of time.

•

Refer all servicing to qualiﬁ ed service personnel. Servicing is required when the apparatus has been damaged in any way, such as the power supply

•

cord or plug is

damaged, liquid has been spilled or objects have fallen into the apparatus, or the apparatus has been exposed to rain or moisture, does not operate normally, or has

been dropped.

To be completely disconnected from the power input, the main plug of the AC/DC adapter shall be disconnected from the main.

•

The main plug of the AC/DC adapter should not be obstructed OR should be easily accessed during intended use.

•

The marking information is located at the bottom of the apparatus.

•

The battery shall not be exposed to excessive heat such as sunshine, ﬁ re or the like.

•

The apparatus and AC/DC adapter shall not be exposed to dripping or splashing, and no objects ﬁ lled with liquids, such as vases, shall be placed on the apparatus

•

and AC/DC adapter.

TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). THERE ARE NO USER-SERVICEABLE PARTS INSIDE THIS UNIT. PLEASE

•

REFER SERVICING TO QUALIFIED HARMAN CONSUMER GROUP, INC., SERVICE PERSONNEL.

Never remove grille covers in order to service the speaker system. The speaker system does not contain any user-serviceable parts.

•

IMPORTANT NOTE FOR ALL ELECTRONIC PRODUCTS:

Before inserting or unplugging audio cables from the source device’s headphones or line-level output jacks, it is good practice to turn off the device

ﬁ rst. This will prolong the life of your unit, help protect your device from static electricity and prevent potential damage.

IMPORTANT SAFETY INSTRUCTIONS

PLEASE READ THE FOLLOWING PRECAUTIONS BEFORE USE:

0068CSK - JBL OnStage 200iD UG v3.indd 20068CSK - JBL OnStage 200iD UG v3.indd 2 29/09/08 10:16:4429/09/08 10:16:44

CAUTION

RISK OF ELECTRIC

SHOCK — DO NOT OPEN

THE EXCLAMATION

POINT WITHIN

THE TRIANGLE IS

A WARNING SIGN

ALERTING YOU

TO IMPORTANT

INSTRUCTIONS

ACCOMPANYING

THE PRODUCT.

CAUTION: TO REDUCE

THE RISK OF SHOCK, DO

NOT REMOVE COVER. NO

USER-SERVICEABLE PARTS

INSIDE. REFER SERVICING

TO QUALIFIED SERVICE

PERSONNEL.

THE LIGHTNING

FLASH AND

ARROWHEAD

WITHIN THE

TRIANGLE IS A

WARNING SIGN

ALERTING YOU

TO DANGEROUS

VOLTAGE INSIDE

THE PRODUCT.

WARNING: TO PREVENT FIRE OR

ELECTRICAL SHOCK HAZARD, DO NOT EXPOSE

THIS PRODUCT TO RAIN OR MOISTURE.

WARNING: THE APPARATUS SHOULD

NOT BE EXPOSED TO DRIPPING OR SPLASHING

AND NO OBJECTS FILLED WITH LIQUID, SUCH AS

VASES, SHOULD BE PLACED ON THE APPARATUS.

IMPORTANT:

THE APPROPRIATE ADAPTER MUST BE INSTALLED BEFORE

INSERTING YOUR iPod/iPhone INTO THE JBL

PRODUCT.

MAKE SURE THAT THE CONNECTOR FOR THE iPod/iPhone IS

PROPERLY ALIGNED WITH THE JBL PRODUCT’S CONNECTOR

WHEN INSTALLING YOUR iPod/iPhone. FAILURE TO DO SO

MAY CAUSE PERMANENT DAMAGE TO THE CONNECTOR FOR

THE iPod/iPhone, RENDERING THE iPod/iPhone INOPERABLE.

WWW.JBL.COM

FCC STATEMENT AND WARNINGFCC STATEMENT AND WARNING

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and

2) this device must accept any interference received, including interference that may cause undesired operation.2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:following measures:

Reorient the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

•

Any special accessories needed for compliance must be speciﬁ ed in the instruction manual.Any special accessories needed for compliance must be speciﬁ ed in the instruction manual.

MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT UNDER FCC RULES. MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT UNDER FCC RULES.

English

0068CSK - JBL OnStage 200iD UG v3.indd 30068CSK - JBL OnStage 200iD UG v3.indd 3 29/09/08 10:16:4429/09/08 10:16:44

JBL

AUX IN

DC 12V

Power

AUX IN

DC 12V

Power

Auxiliary port

Power switch

Power jack

JBL ON STAGE 200

ID USER GUIDE

UNPACKING YOUR JBL ON STAGE

™

200ID

Power supply

Adapters for

iPod/iPhone

IR remote

Audio cable

Find the correct adapter for your iPod/iPhone, then ﬁ rmly place it into the docking area shown. Next,

place your iPod/iPhone into the dock, making sure your iPod/iPhone is ﬁ rmly seated. Adjust the

volume, using (+) to increase and (–) to decrease. Press both to mute the JBL On Stage 200ID system.

Press either button to unmute.

QUICK SETUP INSTRUCTIONS

Plug the barrel end of the power supply cord into the power jack and plug the other end into the wall.

•

Next, push the power switch; a green LED will light up, indicating that the unit is powered.

•

Auxiliary port (for other portable audio devices): Connect the included audio cable from this port into the headphone jack of your portable audio device.

•

REAR VIEW

JBL On Stage

™*

200ID

0068CSK - JBL OnStage 200iD UG v3.indd 40068CSK - JBL OnStage 200iD UG v3.indd 4 29/09/08 10:16:4429/09/08 10:16:44

WWW.JBL.COM

Symptom Possible Problem Solution

No sound from the

JBL On Stage 200ID

speaker system.

No power to the system.

Power adapter plug is not inserted

correctly.

Ensure that the power supply is connected to a live power

source and is properly connected to JBL On Stage

™*

200ID.

(Note: When the JBL On Stage 200ID system is powered,

a green power LED should light up.)

No volume or low volume.

Input source is low.

Touch the volume “Up” (+) pad on the volume control

to unmute and/or increase the system volume level.

(Note: Touching the volume “Down” [–] pad lowers the

system volume; touching both the [+] and [–] volume

control pads at the same time will mute the system.)

Increase the volume level on the audio source device.

iPod/iPhone paused. Press the Play button on the iPod/iPhone or remote control.

No power; green LED

is not on.

Wall adapter is not plugged into

the JBL On Stage 200ID system

correctly.

Wall adapter is not receiving

AC power.

Check the connection of the wall adapter.

Place the wall adapter in a known powered outlet;

test the outlet with a lamp or other device.

Connect the JBL On Stage 200ID system to a known audio

source; test the audio source with headphones.

Error message: “Device is

not iPhone Compatible” is

displayed on iPhone after

docking on the unit.

iPhone has an old ﬁ rmware

version.

Upgrade iPhone ﬁ rmware to latest version.

Undock & re-dock iPhone in unit.

SPECIFICATIONS TROUBLESHOOTING

JBL ON STAGE

™*

200ID

Frequency Response: 40Hz – 20kHz

Power Consumption: 20W maximum

Power Input: 12V/1.25A

JBL On Stage 200ID Transducer: 1-3/8

" (35mm) x 2

(full range per channel)

Dimensions: 14-1/8

" x 4-5/16" x 2-1/2"

(W x D x H) (359mm x 110mm x 64mm)

Weight: 1.5 lb (0.7kg)

English

0068CSK - JBL OnStage 200iD UG v3.indd 50068CSK - JBL OnStage 200iD UG v3.indd 5 29/09/08 10:16:4629/09/08 10:16:46

JBL is a trademark of Harman International Industries, Incorporated, registered in the United States and/or other countries.

* The trademark On Stage is used with permission of OSA International, Inc.

iPod and iTunes are trademarks of Apple Inc., registered in the U.S. and other countries. iPhone is a trademark of Apple Inc. iPod and iPhone not included. “Made

for iPod” means that an electronic accessory has been designed to connect speciﬁ cally to iPod and has been certiﬁ ed by the developer to meet Apple performance

standards. “Works with iPhone” means that an electronic accessory has been designed to connect speciﬁ cally to iPhone and has been certiﬁ ed by the developer to meet

Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.

JBL est une marque commerciale de Harman International Industries, Incorporated, déposée aux États-Unis et/ou dans d’autres pays.

* La marque commerciale On Stage est employée avec la permission d’OSA International, Inc.

iPod et iTunes sont des marques commerciales de Apple Inc., déposées aux États-Unis et dans d’autres pays. iPhone est une marque commerciale de Apple Inc. iPod

et iPhone non inclus. « Made for iPod » signiﬁ e qu’un accessoire électronique a été conçu pour ce connecter spéciﬁ quement à l’iPod et que sa conformité aux normes

de performances Apple a été certiﬁ ée par son constructeur. « Works with iPhone » signiﬁ e que le dispositif électronique a été spécialement conçu pour se connecter à

l’iPhone et qu’il est certiﬁ é par le développeur comme conforme aux normes de performance Apple. Apple n’est pas responsable du fonctionnement de ce dispositif ou

de sa conformité avec les normes de sécurité ou réglementaires.

Harman Consumer Group, Inc.

8500 Balboa Boulevard, Northridge, CA 91329 USA

516.255.4525 (USA only)

www.jbl.com

Document Number: 950-0231-001 Rev. C

0068CSK - JBL OnStage 200iD UG v3.indd 580068CSK - JBL OnStage 200iD UG v3.indd 58 29/09/08 10:17:0629/09/08 10:17:06