8
Warning –Batteries
•When insertingbatteries, note the correct polarity (+ and
-markings) and insert the batteries accordingly.Failure to
do so could result in the batteries leaking or exploding.
•Only use batteries that match thespecied type. Keep the
instructionsfor the correct choice of batteries included with
the operating instructions of devices safe for futurereference.
•Beforeyou insert the batteries, clean the batterycontacts
and thepolarity contacts.
•Do not allow children to change batteries without supervision.
•Replace allthe batteries in aset at the same time.
•Do not mix old and new batteries, or batteriesofdifferent
types or from different manufacturers.
•Remove the batteries from products that arenot beingused
foranextended period (unless these arebeing kept ready
for an emergency).
•Do not short-circuit batteries.
•Do not charge batteries.
•Do not burn batteries or heat them up.
•Never open, damage or swallow batteries or allow
them to enter the environment. They cancontain toxic,
environmentally harmful heavy metals.
•Remove spent batteries from the product and dispose of
them without delay.
•Avoid storing, charging and using in extreme temperatures
and at extremely low atmospheric pressures
(such as at high altitudes).
•Ensurethat batteries with damaged housings
do not come into contact with water.
•Keep batteries out of the reach of children.
4. Getting started
Note
Beforeuse, make surethat you insert the batteries in the
measuring station rst and then in the base station.
5. Installation
Note –Installation
•We recommend initially placing the base station and
measuring station(s) in the intended locations without installing
them and making all the settings describedin6. Operation.
•Only installthe stations once the appropriate settings have
been made and astable wireless connection is established.
Note
•The wireless transmission range between the measuring
and base stations is up to 50 minopen spaces.
•Beforeinstallation, ensurethat wireless transmission
willnot be disrupted by interference or obstacles like
buildings, trees,vehicles,high-voltage lines, etc.
•Beforethe nal installation, ensurethat thereissucient
reception between the intended installation locations.
•When installing the measuring station, ensurethat it is
protected from direct sunlight and rain.
•The international standardheight formeasuring air
temperatureis1.25 m(4ft) above ground.
Warning
•Buy special or suitable installation material from a
specialised dealer for wall-mounting.
•Ensurethatnofaulty or damaged parts areinstalled.
•Never apply force during installation. This coulddamage
the product.
•Beforeinstallation, ensure that the chosen wallis
suitable for the weight to be mounted,and make sure
that thereare no electrical wires, water,gas or other
lines at the installation site on the wall.
•Do not mount theproduct above locations where
persons mightlinger.
•We recommend installingthe measuring station securely
on an outdoor wallusing the opening (19).
6. Operation
6.1 Connection to the measuring station
After you have inserted the batteries, the base station
automatically searches for aconnection to the three
measuring stations and performs initial setup.
Note
•Remember that each of the three measuring stations
must use adifferent channel.
•Initial setup takes approximately 3minutes.
•During the connection attempt,the measuring station
radio symbol will ash.