Hughes 4510 Mode d'emploi

4510
Hughes
Marque
Hughes
Modèle
4510
Catégorie
Composants de dispositif de sécurité
Taper
Mode d'emploi
Regulatory and safety information is provided in the user manual which can be downloaded from the website http://echostarmobile.com 3004405-0001 Rev.B
Des renseignements sur la réglementation et la sécurité sont fournis dans le manuel d’utilisation qui peut être téléchargé à partir du site Web http://echostarmobile.com
The intent of this guide is to acquaint the user with the Hughes 4510 terminal
and power it up.
1. Unpack the box. Without tearing the plastic over the 4510, lift it out of the box,
unfold the flaps, and slide it out of the sleeve. Save the box and packing
material should you need to ship the 4510 at a later time.
2. Satellite and Cellular SIMs
a) Remove the SIM door
b) Insert the satellite SIM card supplied by your service provider in the SAT SIM
slot
c) Most users will be using the integrated eSIM, so no further action
Note: If using a third-party cellular service, the insertable cellular SIM should
be used
- Insert the cellular SIM card supplied by your service provider in the CELL
SIM holder provided
- Insert the CELL SIM holder into the CELL SIM slot. These slots can be seen
in the graphic below
3. Connect a Hughes cable (3501314-000x) from the barrel connector to
power and Ethernet using the cable pinout table below.
3. Ensure that the red wire is connected to always-on 12VDC and that the
white wire is connected to switched power (e.g., vehicle ignition) to
power the 4510 on and off automatically, there is no power button on
the terminal.
Note: The power supply must be rated for a maximum peak current of
3.5 A at 12V.
5. After powering up the 4510 will attempt to establish a Cellular
connection with the integrated Echostar Mobile eSIM. The LED states
are provided in the table below.
6. Connect the 4510 to your computer via Ethernet or the USB port under
the SIM door. Open a web browser and enter the address
192.168.128.100 (Ethernet) or 169.254.1.1 (USB) to access the home
page of the UT Web User Interface.
7. The many configuration options are documented in the 4510 User
Guide which can be downloaded from http://echostarmobile.com.
State LED
Powering up Solid GREEN
Network acquisition GREEN flashing
Registered and IP context active Solid GREEN
Hardware fault Solid RED
Hughes 4510 Quick Start Guide
Hughes Terminal
Connector
Hughes Terminal
SIM slots
  • Page 1 1

Hughes 4510 Mode d'emploi

4510
Hughes
Marque
Hughes
Modèle
4510
Catégorie
Composants de dispositif de sécurité
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents