EN
16
TRANSPORTATION AND CHANGING OF
INSTALLATION POSITION
Transportation and Changing of Installation Position
The original packages and foamed polystyrene (PS) can
be retained if required.
During transportation, the appliance should be secured
with a wide string or a strong rope. The instructions written
on the corrugated bo
must be followed while transporting.
Before transporting or changing the installation position,
all the moving objects (ie,shelves,crisper…) should be
taken out or
ed with bands in order to prevent them from
getting damaged.
Repositioning the door
It is not possible to change the opening direction of your
refrigerator door, if the door handle on your refrigerator is
installed from the front surface of the door.
It is possible to change the opening direction of the door
on models without any handles.
If the door opening direction of your refrigerator may
be changed, you should contact the nearest Authorised
Service Agent to have the opening direction changed.
ELECTRICAL CONNECTION FOR GREAT BRITAIN AND IRELAND ONLY
Warning – this appliance must be earthed.
Fuse replacement
If the mains lead of this appliance is
with a BS 1363A 13amp fused
plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to
BS 1362 type and proceed as follows:
1. Remove the fuse cover (A) and fuse (B).
2. Fit replacement 13A fuse into fuse cover.
3.
both into plug.
Important:
The fuse cover must be
when changing a fuse and if the fuse cover
is lost the plug must not be used until a correct replacement is
Correct replacement are by the colour insert or the colour
embossed in words on the base of the plug.
Replacement fuse covers are available from your local electrical store.
For the Republic of Ireland only
The information given in respect of Great Britain will frequently apply, but a third type of plug and
socket is also used, the 2-pin, side earth type.
Socket outlet / plug (valid for both countries)
If the
plug is not suitable for your socket outlet, please contact After-sales Service for further
instruction.
Please do not attempt to change plug yourself. This procedure needs to be carried out by a
technician in compliance with
the manufactures instructions and current standard safety regulations.