Estella 236EMC1 Countertop Display Refrigerator Manuel utilisateur

Marque
Estella
Modèle
236EMC1 Countertop Display Refrigerator
Taper
Manuel utilisateur
11/2021
#236EMC1
COUNTERTOP DISPLAY REFRIGERATORS
USER MANUAL
Please read and keep these instrucons. Indoor use only.
1
DANGER – RISK OF FIRE OR EXPLOSION. FLAMMABLE REFRIGERANT USED. TO BE REPAIRED ONLY BY
TRAINED SERVICE PERSONNEL. DO NOT PUNCTURE REFRIGERANT TUBING.
PELIGRO - RIESGO DE INCENDIO O EXPLOSION. REFRIGERANTE INFLAMABLE UTILIZADO. PARA
SER REPARADO SOLAMENTE POR PERSONAL DE SERVICIO CALIFICADO. NO PINCHAR LA TUBERÍA
REFRIGERANTE.
DANGER – RISQUE DE FEU OU D’EXPLOSION. LE FRIGORIGÈNE EST INFLAMMABLE. CONFIER LES
RÉPARATIONS À UN TECHNICIEN SPÉCIALISÉ. NE PAS PERFORER LA TUBULURE CONTENANT LE
FRIGORIGENE.
CAUTION – RISK OF FIRE OR EXPLOSION. FLAMMABLE REFRIGERANT USED. CONSULT REPAIR
MANUAL/OWNER’S GUIDE BEFORE ATTEMPTING TO SERVICE THIS PRODUCT. ALL SAFETY
PRECAUTIONS MUST BE FOLLOWED.
ATENCION - RIESGO DE INCENDIO O EXPLOSIÓN. REFRIGERANTE INFLAMABLE UTILIZADO. CONSULTE
EL MANUAL DE REPARACIÓN / GUÍA DEL PROPIETARIO ANTES DE INTENTAR DAR SERVICIO A ESTE
PRODUCTO. DEBEN CUMPLIR CON TODAS LAS PRECAUCIONES DE SEGURIDAD.
ATTENTION – RISQUE DE FEU OU D’EXPLOSION. LE FRIGORIGÈNE EST INFLAMMABLE. CONSULTER LE
MANUEL DU PROPRIÉTAIRE/GUIDE DE RÉPARATION AVANT DE TENTER UNE RÉPARATION. TOUTES LE
MESURES DE SÉCURITÉ DOIVENT ÊTRE RESPECTÉES.
CAUTION – RISK OF FIRE OR EXPLOSION DUE TO PUNCTURE OF REFRIGERANT TUBING; FOLLOW
HANDLING INSTRUCTIONS CAREFULLY. FLAMMABLE REFRIGERANT USED.
ATENCION - RIESGO DE INCENDIO O EXPLOSIÓN DEBIDO A LA PERFORACION DE LA TUBERÍA
REFRIGERANTE; SIGA LAS INSTRUCCIONES DE MANIPULACIÓN CON CUIDADO. REFRIGERANTE
INFLAMABLE UTILIZADO.
ATTENTION – RISQUE DE FEU OU D’EXPLOSION SI LA TUBULURE CONTENTANT LE FRIGORIGÈNE
EST PERFORÉE; SUIVRE LES INSTRUCTIONS DE MANUTENTION AVEC SOIN. LE FRIGORIGÈNE EST
INFLAMMABLE.
CAUTION – RISK OF FIRE OR EXPLOSION DUE TO FLAMMABLE REFRIGERANT USED. FOLLOW
HANDLING INSTRUCTIONS CAREFULLY IN COMPLIANCE WITH LOCAL GOVERNMENT REGULATIONS.
ATENCIÓN – RIESGO DE INCENDIO O EXPLOSIÓN DEBIDO A REFRIGERANTE INFLAMABLE UTILIZADO.
SIGA LAS INSTRUCCIONES DE MANIPULACIÓN CON CUIDADO CONFORME A LAS REGLAS DE LA
MUNICIPALIDAD.
ATTENTION – RISQUE DE FEU OU D’EXPLOSION SI LE FRIGORIGÈNE EST INFLAMMABLE. SUIVRE
LES INSTRUCTIONS DE MANUTENTION AVEC SOIN CONFORMÉMENT AUX RÈGLEMENTATION
GOUVERNEMENTALE LOCAUX.
WARNING
NOTE: Save these instructions for future reference.
2
IMPORTANT!!! PLEASE READ BEFORE INSTALLATION
• After unboxing, the unit must be kept upright for a minimum of 24 hours in its final installation
location before being plugged in. Failure to do so may cause damage to the compressor and will
void the warranty.
• Make sure the unit has reached the desired temperature before loading the unit with products.
• Make sure all accessories are installed (shelves, shelf clips, etc…) before plugging in the unit.
• Do not attempt to remove or repair any component of the unit. Consult an authorized service
technician for servicing / repair.
• Do not hang on doors.
• Please read through this manual in its entirety.
CABINET LOCATION GUIDES
• Install the unit on a strong and leveled surface.
- If the surface is uneven, the unit may be noisy.
- The unit may malfunction if the surface is uneven.
• Install the unit in an indoor, well ventilated area.
- For best performance, maintain 6” of clearance on both sides and the back of the unit at all
times.
- Outdoor use may cause decreased efficiency and damage to the unit.
- Avoid direct sunlight.
• Avoid installation in a high humidity and / or dusty area.
- High humidity can cause the unit to rust and may decrease efficiency.
- Dust collected on the condenser coil may cause unit to malfunction.
- Malfunction due to high ambient temperatures, humidity, or improperly maintained
condenser coil will void the warranty.
• Select a location away from heat and moisture-generating equipment.
- High ambient temperatures may cause the compressor to malfunction.
- Malfunction due to high ambient temperatures and humidity will void the warranty.
ELECTRICAL
• Please ensure that the required voltage is being supplied at all times.
• The unit should be plugged into a grounded and properly-sized electrical outlet with
appropriate over-current protection. Please refer to the electrical requirements on the unit’s
nameplate.
• The unit should have its own dedicated outlet.
• Do not use extension cords.
• Ensure the unit is not resting on or against the electrical cord.
• If the unit is not in use for a long period of time, please unplug the unit from the outlet.
• To avoid shock and fire hazards, do not plug in or unplug the unit with wet hands.
• After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do
so could cause damage to the compressor.
INSTALLATION
3
INSTALLATION (CONTINUED)
DEFROST SYSTEM
Refrigeration units contain a manual defrost system. Refrigerator coils are kept below the
freezing point (32 degrees Fahrenheit). During compressor down-time, the evaporator fan
continues to circulate air through the evaporator coil. This air circulation raises the coil
temperature above the freezing point, melting any accumulated frost. Run-off water is
drained into the evaporator pan and evaporated.
TEMPERATURE CONTROLS
Your new refrigerator or freezer is already factory-set to run at optimum temperatures for
food safety and should require no adjustments.
Refrigerators are set to cycle between a minimum temperature of 33 degrees Fahrenheit
and a maximum temperature of 40 degrees Fahrenheit. Freezers are set to cycle between
a minimum temperature of -5 degrees Fahrenheit and a maximum temperature of 2
degrees Fahrenheit. Adjusting the temperature changes the minimum temperature your
unit will run at. Your unit will not run constantly at this setting. To change it, follow these
instructions:
DIGITAL CONTROL UNITS
• Hold “SET” for 1 sec. The display will flash the current minimum temperature.
• Use the arrow buttons to adjust the minimum temperature you want it to run at.
• Press “SET” again to save your settings
Always remember to calculate the differential if you change the minimum temperature
setting. The cabinet temperature will fluctuate up to +7 degrees over your set minimum
temperature as the compressor runs and shuts off. Setting the temperature too high will
result in unsafe maximum temperatures and possible health code violations.
INSTALLING THE MILK TUBE
Clean the compatible milk tube that comes standard with your Estella Caffe Presto, Presto
Deluxe, or Europa machine
• Install the milk tube on the side of your Estella Caffe machine
• Pop out the plug on the side of the milk cooler closest to your machine
• Make sure the path is clear for the tube to pass through without collecting debris
• Place (1) open beverage container of your choice in the refrigerator, and feed the tube
through the hole, dropping it into the beverage container
4
NOTE: We strongly recommend that any servicing be performed by an authorized service
technician.
LOADING PRODUCT
• Do not block the air duct/fan at the back of the unit.
• Do not store flammable and explosive gas or liquids inside the unit.
• Refrigerator display units are meant to maintain already cold product temperature, not
actively cool products.
CLEANING THE CONDENSOR COIL
• For efficient operation, keep the condenser surface free of dust, dirt, and lint.
• We recommend cleaning the condenser coil at least once per month.
• Clean the condenser with a commercial condenser coil cleaner, available from any
kitchen equipment retailer.
CLEANING THE FAN BLADES AND MOTOR
• If necessary, clean the fan blades and motor with a soft cloth.
• If it is necessary to wash the fan blades, cover the fan motor to prevent moisture
damage.
CLEANING THE INTERIOR OF UNIT
• When cleaning the cabinet interior, use a solvent of warm water and mild soap.
• Do not use steel wool, caustic soap, abrasive cleaners, or bleach that may damage the
interior finish.
• Wash door gaskets on a regular basis, preferably weekly. Simply remove the door
gasket from the frame of the door, soak it in warm water and soap for thirty (30)
minutes, then dry with soft cloth and replace.
• Check door gaskets for proper seal aer they are replaced
OPERATION/MAINTENANCE
5
TROUBLE SHOOTING
COMPRESSOR IS NOT RUNNING
COMPRESSOR IS NOT RUNNING
CABINET TEMPERATURE IS TOO WARM
INTERIOR LIGHT IS NOT WORKING
Fuse blown or circuit breaker tripped. Replace fuse or reset circuit breaker.
Power cord unplugged. Plug in power cord
Thermostat set too high. Set thermostat to lower temperature.
Cabinet in defrost cycle. Wait for defrost cycle to nish.
Gasket is not sealing properly. Clean, repair, or replace the gasket as
necessary
Thermostat is set too high. Set thermostat to lower temperature.
Airow is blocked.
Re-arrange products to allow for proper
air ow. Make sure there is at least four
inches of clearance from the fan.
Low refrigerant levels. Contact a service technician to check
refrigerant levels.
Door is slightly ajar. Make sure door is completely closed.
Poor switch connecon. Turn o light switch and turn it back on.
Bulb is not connected. Make sure the bulb is correctly inserted in the
socket.
Bulb has burned out. Replace the bulb.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Estella 236EMC1 Countertop Display Refrigerator Manuel utilisateur

Marque
Estella
Modèle
236EMC1 Countertop Display Refrigerator
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents