Ubiquiti UAP-AC-M Manuel utilisateur
- Catégorie
- Antennes réseau
- Taper
- Manuel utilisateur
Wall Mount Plate
Metal Strap
RF Cables (Qty. 2)
Installation Requirements
UniFi AC Mesh Access Point, model UAP-AC-M
Wall-mounting: drill and 6 mm drill bit
Pole-mounting: 7 mm socket wrench
Phillips screwdriver
Shielded Category 5 (or above) cabling with drain wire should be used for all outdoor
wired Ethernet connections and should be grounded through the AC ground of the
PoE.
We recommend that you protect your networks from harmful outdoor environments
and destructive ESD events with industrial-grade, shielded Ethernet cable from
Ubiquiti. For more details, visit ui.com/toughcable
Surge protection should be used for all outdoor installations. We recommend that
you use two Ethernet Surge Protectors, model ETH-SP-G2, one near the UAP-AC-M
and the other at the entry point to the building. The ETH-SP-G2 will absorb power
surges and safely discharge them into the ground.
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD
Specifications
UMA-D
Dimensions 201.3 x 128.0 x 32.5 mm
(7.93 x 5.04 x 1.28")
Weight
With Mount 480 g (16.93 oz)
Without Mount 400 g (14.11 oz)
Enclosure Outdoor UV Stabilized Plastic
Supported Frequency Range 2.4 - 2.5 GHz
5.1 - 5.9 GHz
HPOL Beamwidth
2.4 GHz 90°
5 GHz 45°
VPOL Beamwidth
2.4 GHz 90°
5 GHz 45°
Elevation Beamwidth
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD
UMA-D
2.4 GHz 90°
5 GHz 45°
Maximum VSWR 2.5:1
Polarization Dual-Linear
Cross-Pol Isolation
2.4 GHz 25 dB
5 GHz 30 dB
Antenna Gain
2.4 GHz 10 dBi
5 GHz 15 dBi
Mounting Wall/Pole (Kits Included)
Safety Notices
1. Read, follow, and keep these instructions.
2. Heed all warnings.
3. Only use attachments/accessories specified by the manufacturer.
WARNING: Do not use this product in location that can be submerged by water.
WARNING: Avoid using this product during an electrical storm. There may be a remote
risk of electric shock from lightning.
Electrical Safety Information
1. Compliance is required with respect to voltage, frequency, and current requirements indicated
on the manufacturer’s label. Connection to a different power source than those specified may
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD
result in improper operation, damage to the equipment or pose a fire hazard if the limitations are
not followed.
2. There are no operator serviceable parts inside this equipment. Service should be provided only
by a qualified service technician.
Limited Warranty
ui.com/support/warranty
The limited warranty requires the use of arbitration to resolve disputes on an individual basis, and,
where applicable, specify arbitration instead of jury trials or class actions.
Compliance
RF Exposure Warning
The antenna and transmitter must be installed to provide a separation distance from all persons
and must not be located or operating in conjunction with any other antenna or transmitter. For the
specific separation distance, refer to the Quick Start Guide for your Rocket device (transmitter).
L’antenne et l’émetteur doit être installé pour fournir une distance de séparation de toute les
personnes et ne doit pas être situé ou opérant en conjonction avec une autre antenne ou un autre
émetteur. Pour la distance spécifique de séparation, se référer au Guide de démarrage rapide pour
votre appareil Rocket (l’émetteur).
WEEE Compliance Statement
Declaration of Conformity
Online Resources
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD
La page charge ...
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
Ubiquiti UAP-AC-M Manuel utilisateur
- Catégorie
- Antennes réseau
- Taper
- Manuel utilisateur
dans d''autres langues
- English: Ubiquiti UAP-AC-M User manual
Documents connexes
-
Ubiquiti LTU-Lite Manuel utilisateur
-
-
-
-
-
Ubiquiti UniFi UAP-AC-LR Guide de démarrage rapide
-
Ubiquiti UAP Manuel utilisateur
-
-
Ubiquiti UAP-AC-IW Guide de démarrage rapide
-
Ubiquiti ULED-AT Guide de démarrage rapide