Paxar 6094 Manuel utilisateur

6094
Paxar
Marque
Paxar
Modèle
6094
Taper
Manuel utilisateur

Ce manuel convient également à

6094
TM
Four
Station Charger
TC6094OI Rev. BA 4/02 ©2002 Paxar Corporation. All rights reserved.
Operating Instructions
Each product and program carries a respective written warranty, the
only warranty on which the customer can rely. Monarch reserves the
right to make changes in the product and the programs and their
availability at any time and without notice. Although Monarch has
made every effort to provide complete and accurate information in
this manual, Monarch shall not be liable for any omissions or
inaccuracies. Any update will be incorporated in a later edition of this
manual.
WARNING
This equipment can interfere with radio communication if not
installed and used in accordance with the instruction manual. It
has been tested and found to comply with the limits for a
Class A computing device pursuant to FCC Rules, Part 15,
Subpart B, which provide reasonable protection against such
interference when operated in a commercial environment.
Operation in a residential area is likely to cause interference
which the user must correct at their own expense.
CANADIAN D.O.C. WARNING
This digital apparatus does not exceed the Class A limits for
radio noise emissions from digital apparatus set out in the Radio
Interference Regulations of the Canadian Department of
Communications.
Le présent appareil numérique n’émet pas de bruits
radioélectriques dépassant les limites applicables aux appareils
numériques de la classe A prescrites dans le Réglement sur le
brouillage radioélectrique édicte par le ministère des
Communications du Canada.
Trademarks
Monarch and PATHFINDER are registered trademarks of Monarch Marking Systems,
Inc.
Paxar is a trademark of Paxar Corporation.
6094 is a trademark of Monarch Marking Systems, Inc.
IMPORTANT SAFETY INSTRUCTIONS
Save These Instructions
This manual contains important safety and operating
instructions for the 6094 charger. Before using the 6094
charger, please read all instructions and caution markings on:
✓ the charger.
✓ the battery handle.
✓ the printer.
WARNING
The 6094 charger is for charging PATHFINDER
®
battery
handles only. Other types of battery handles may burst
causing personal injury and damage.
General Safety Precautions
1. Do not expose the charger to rain or snow.
2. When disconnecting the power cord, pull on the plug, not
the cord. Do not operate the charger with a damaged plug
or cord ----replace the power cord immediately if damaged.
i
3. Do not use an extension cord unless absolutely
necessary.
If an extension cord is used, make sure
✓ the wire is 18 gauge or larger.
✓ the pins on the plug of the extension cord are the same
number, size, and shape as those of the plug on the
charger.
✓ the extension cord is properly wired and in good
electrical condition.
4. Do not operate the charger if it is damaged. Call
Monarch
Service.
5. Do not disassemble the charger. Incorrect reassembly
may result in risk of electric shock or fire. Contact
Monarch Service when service or repair is required.
6. To reduce risk of electric shock, unplug charger from outlet
before doing any maintenance or cleaning. Turning the
power off does not reduce this risk.
7. The plug for the charger is equipped with a grounding pin.
The outlet for installation must be installed and grounded in
accordance with all local codes and ordinances.
6094 Operating Instructions
ii
Table of Contents
1. Overview................................................................................1
Charging Time................................................................ 1
Convenience Features................................................... 2
2. Installing the Charger ......................................................... 3
Setting the Power Supply............................................... 3
Wall Mount Installation................................................... 5
Power On Test ............................................................... 6
3. Charging Handles ............................................................... 7
4. Troubleshooting.................................................................. 9
Problems and Solutions ................................................. 9
Replacing Fuses........................................................... 11
Specifications ............................................................... 12
iii
6094 Operating Instructions
iv
1. Overview
The 6094 charger is a "fast charge" accessory for charging and
storing PATHFINDER battery handles. There are four charging
stations on the charger. Each station charges independently,
which means you can attach battery handles at anytime.
Charging Time
Charging time varies depending upon the capacity rating of the
battery handle and its usage. Most battery handles will
recharge in less than 2 hours.
NOTE: Battery handles with a higher capacity rating will take
longer to charge.
With the 6094, you cannot damage the battery handles by
overcharging. The 6094 automatically reduces power to a
"trickle" charge to maintain the charge of the battery handle
until it is removed.
1
Convenience Features
Additional features are:
• switchable power supply which lets you select 100, 120,
220, or 240 VAC for your operating area.
• charging status indicator light for each charging station.
• replaceable fuses.
Familiarize yourself with the different parts of the 6094 charger.
Fuse Box
Power Light
Status
Indicator
Power
Switch
Charging
Station
6094 Operating Instructions
2
2. Installing the Charger
The charger may be mounted to the wall or set on a sturdy
table. Before installing the charger
✓ set the power supply for the voltage in your area.
✓ select a location for wall mounting or table top use.
✓ perform the power on test.
Setting the Power Supply
When you first receive the charger, the power supply is factory
pre-set:
• 6094-01 is 120 VAC with 1A fuses.
• 6094-02 is 220/240 VAC with .5A fuses.
• 6094-03 is 100 VAC with 1A fuses.
To reset the power supply for 100, 120, 220, or 240 VAC:
1. Turn the power OFF.
2. Unplug the power cord.
3. Use the tip of a screwdriver or pen to open the fuse box as
shown. The fuse box is located on the left side of the
charger beside the power switch.
Fuse Box
3
4. Carefully pull the fuse box straight out. Fuses are
attached, so be careful not to drop or jolt the fuses.
CAUTION
Make sure you are using the correct fuses for the voltage
you select.
5. Using a screwdriver, pull the power selector straight out.
6. Rotate the power selector to the setting required.
7. Push the power selector all the way into the slot. Make
sure the selected number is facing you.
8. Change all fuses to the correct fuses for the voltage
selected. See "Replacing Fuses" in Chapter 4.
9. Replace the fuse box, pushing until it snaps closed.
Power
Selector
6094 Operating Instructions
4
Wall Mount Installation
To install the charger, you will need hardware appropriate for
• the wall surface.
• the weight of the charger with 4 handles
(approximately 9.8 lb/4.4 kg).
• screws no larger than No. 10 wood screw.
1. Select a location within 6 feet of an electrical outlet. Use
the bracket of the charger to mark the holes where the unit
is to hang.
2. Attach the necessary hardware to the wall.
3. Place the bracket of the charger over the hardware and let
it slide down.
4. Plug the female end of the power cord into the charger and
the male end into the wall outlet.
Bracket
2. Installing the Charger
5
Power On Test
Whenever you turn the power on, the charger will go through a
self-test cycle which takes a few seconds. During this test,
you’ll see the status indicators flash in the following sequence:
1. GREEN power light is on.
2. Each station, starting with station one, flashes
GREEN to RED.
3. All four stations flash GREEN.
4. All four stations flash RED.
5. Green power light remains on and all station indicators turn
off for several seconds. Any station that has a handle
connected will show a slow flashing green light.
If the lights form a pattern different than described above, the
charger is malfunctioning. Turn the power off and check the
"Troubleshooting" section in Chapter 4, or call Monarch Service.
6094 Operating Instructions
6
3. Charging Handles
To begin charging...
1. Check the power light to make sure the power is on.
2. Slide the battery handle completely into the charging
station.
Power
Light
Charging
Station
Status
Indicator
Power
Switch
7
The status indicator will slowly flash green to indicate the
battery handle is properly installed. During the charging cycle,
the status indicator will change.
Use the color of the status indicator and whether it is solid,
flashing slowly, or flashing quickly to determine the meaning of
the indicator.
Status
Indicator
Solid Slow Flashing Quick Flashing
Green Fully
Charged
Trickle Charging Fast Charging
Red N/A Charging
Problem
or
Defective
Battery Handle
Defective Battery
Handle
Green/Red N/A N/A Charger Problem
6094 Operating Instructions
8
4. Troubleshooting
This chapter includes common problems which may occur and
instructions for replacing the fuses.
Problems and Solutions
This section helps you correct some problems that may
occur. If you cannot fix a problem, please contact Monarch
Service.
U.S. Customers call TOLL FREE 1-800-231-7700
International Customers contact your Pitney Bowes or
Monarch Marking Systems representative.
Problem Corrective Action
Power indicator does not
light up.
Make sure the charger is plugged in.
Make sure the power switch is ON.
Make sure the cord is completely
connected to the charger receptacle.
Check the electrical outlet for power.
Check the fuses and replace if
necessary.
Contact Monarch Service.
9
Problem Corrective Action
Status indicator does not
light up when a battery
handle is attached.
Check the power light to see if the
power switch is ON.
Push the battery handle completely
into the charging station for a good
connection.
Check the fuses and replace if
necessary.
Try a known good battery handle to
see if the problem is in the battery
handle.
Battery handle will not
charge.
Check the status indicator for charging
status.
Check the fuses and replace if
necessary.
Try a known good battery handle to
see if the problem is in the battery
handle.
If the charger is hot, disconnect the
power cord and call Monarch Service.
Charger is warm. Normal. However, if the charger feels
hot, disconnect and call Monarch
Service.
A status indicator is
quickly flashing red and
the rest of the indicators
have no light.
There is a short in the battery handle
in the charging station with the quickly
flashing red light. Remove the
defective battery and turn the charger
off then back on.
All status indicators
quickly flash green/red.
Turn the power off then on.
6094 Operating Instructions
10
Replacing Fuses
If the fuses need replacing, you’ll need:
• 1A fuses for 120V and 100V. ...or...
• .5A fuses for 220 and 240V.
When the charger is facing you, the fuse box is located on the
left side of the charger beside the power switch.
1. Turn the power OFF and unplug the power cord.
2. Use the tip of a screwdriver or pen to open the fuse box.
3. Carefully pull the fuse box straight out. Fuses are
attached, so be careful not to drop or jolt the fuses.
4. Check to see if the fuse(s) are blackened, or if the thin
metal wire inside is broken.
5. Remove the old fuse(s) by pulling them from the casing as
shown.
6. Insert the new fuse(s) into the casing.
7. Replace the fuse box, pushing until it snaps closed.
4. Troubleshooting
11
Specifications
Dimensions:
Height 5.67 inches (14.4 cm)
Width 9.21 inches (23.4 cm)
Depth 3.94 inches (10 cm)
Weight (with cord) 7 lb (3.2 kg)
Power:
Internal switchable power supply
(100, 120, 220, 240 VAC/ 50 Hz. nominal)
Replaceable dual fusing
1A fuses (Monarch part #PB02282108) for 100 and
120 VAC models
.5A fuses (Monarch part #PB02282107) for 220/240
VAC model
High output current - 500 mA (+/- 10%) per charging
station
Low output current - 50 mA (+/- 10%) per charging
station
Operating and Storage Temperatures:
40° - 110°F (4° - 43°C)
Humidity:
5% - 90% non-condensing
6094 Operating Instructions
12
Published by the Technical Communications Department.
Printed in U.S.A.
For supplies, service or assistance call:
TOLL FREE:
1-800-543-6650 (In the U.S.A.)
1-800-263-4650 (In Canada)
www.paxar.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20

Paxar 6094 Manuel utilisateur

6094
Paxar
Marque
Paxar
Modèle
6094
Taper
Manuel utilisateur
Ce manuel convient également à
Télécharger le PDF
rapport

dans d''autres langues

Autres documents