George Kovacs GKST1002-467 Manuel utilisateur

Marque
George Kovacs
Modèle
GKST1002-467
Taper
Manuel utilisateur

Ce manuel convient également à

FLEX TRACK MOUNTING ROD
INSTALLATION INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
CONSIGNES DE SÉCURITÉ IMPORTANTES
1. Read all of these installation instructions before installing the track system. / Lisez toutes ces instructions
d'installation avant d'installer le système de voie.
2. Do not install this lighting system in a damp or wet location. / Ne pas installer cet ensemble d’éclairage dans un
endroit humide ou mouillé.
3. Do not install any part of this system (TRACK) less than 7 feet (2.2m) above floor./ N’installer aucune des pièces de
ce système d’éclairage (sur rail) à moins de 2,2 m (7 pi) du sol.
4. For use with EC series line voltage flexible track system only./ Pour l'usage avec l'EC les séries rayent les systèmes
de rail flexibles seulement.
5. Disconnect electrical power before adding to or changing the configuration of the track./ Débrancher le courant
électrique avant d’apporter des ajouts ou des modifications à la configuration de ce rail.
6. Save these instructions and refer to them when additions to or changes in the track configuration are made./
Conserver ces instructions pour vous y référer au cas où des ajouts ou des modifications seraient apportés à la
configuration du rail.
READ AND SAVE THESE INSTRUCTIONS
CONSIGNES DE SÉCURITÉ IMPORTANTES
HOW TO INSTALL:
IMPORTANT: BEFORE INSTALLATION PLEASE TURN OFF THE POWER TO THE ITEMS YOU WOULD
TOUCH DURING THE INSTALLATION: / IMPORTANTES: AVANT QUE L'INSTALLATION COUPENT SVP
LE COURANT AUX ARTICLES VOUS TOUCHERIEZ PENDANT L'INSTALLATION:
1. Unpacking the packing card, loose the stanchion from the support stem. Please make sure all the parts shown in the
diagram is included, you can buy more than one mounting rods to installing as your needed.
2. Lay out your track design and mark the position for each stanchion. Evenly space stanchions so that they form
desired pattern.
3. Drill holes on the ceiling at the marked location by electrical drill. (Note: Please use diameter 6mm drill bit)
4. Hammer the screw anchors into drilled holes.
5. Secure the stanchion to the ceiling by screwing the mounting screw into the anchor.
6. Clockwise rotate the support stem to the stanchions and secure.
INSTALL TRACK:
NOTE: The track is sold separately.
1. Remove the retaining cap.
2. Open the adapter cover, then slide the track through the slot of adapter.
3. Close the adapter cover and replace the retaining cap to secure the adapter.
Screw anchor
Stanchion
Stanchion mounting Screw
Support stem
Retaining cap
Flex track
Adapter
  • Page 1 1

George Kovacs GKST1002-467 Manuel utilisateur

Marque
George Kovacs
Modèle
GKST1002-467
Taper
Manuel utilisateur
Ce manuel convient également à
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents