GE Lighting BR30-DMEN Manuel utilisateur

Taper
Manuel utilisateur
CYNC Entertainment Full Color BR30 CLEDR309CDEN, input 120Vac, frequency
was 60Hz, high efficiency, safety & stability output. Use Bluetooth 4.2 and Wi-Fi
2.4G Hz chip technology to realize the far distance control. Through the APP to
control the PWM signal to dim and even control the switch on & off of the bulb.
Product features:
1. Controlled by Bluetooth 4.2 and 2.4G Wi-Fi to realize the far distance control.
2. CCT is 2200K to 7000K.
3. With advanced chips to make sure the bulb with high efficiency, low consumption
and stability.
4. Internal constant current output to make sure the high power conversion efficiency
and stability output.
Product Name
LED LAMP
Brand Name
GE
Model No.
CLEDR309CDEN
Working Voltage
120Vac
Bluetooth Specification
Version 4.2
Wi-Fi Specification
2.4G Hz
Frequency Range
WIFI:2412- 2462MHz
BLE:2402~2480MHz
Channel Number
Bluetooth
40
Channel Separation
Bluetooth
2MHz
Type of Modulation
Bluetooth
GFSK
Data Rate Bluetooth
1Mbps(GFSK)
Channel Number Wi-Fi
11
Channel Separation Wi-Fi
5MHz
Data Rate Wi-Fi
802.11b:11, 5.5,2,1 Mbps
802.11g: 54,48,36,24,18,12,9,6 Mbps
802.11n: MCS0~7
Antenna Type
Chip Monopole Antenna
Peak Antenna Gain
Bluetooth
1.13dBi
Peak Antenna Gain Wi-Fi
1.13dBi
For additional help, regulatory and safety Information, please go to:
Federal Communications Commission (FCC) Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
The grantee is not responsible for any changes or modifications not expressly
approved by the party responsible for compliance. Such modifications could void the
user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance of 20 cm between the radiator and your body.
CAUTION:
- DO NOT USE WITH STANDARD DIMMERS, SEE
INSTRUCTIONS
-NOT FOR USE IN TOTALLY ENCLOSED LUMINAIRES
-SUITABLE FOR DAMP LOCATIONS
-THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY
EXITS
Only use the control provided with or specified by these instructions to control this
lamp. This lamp will not operate properly when connected to a standard (incandescent)
dimmer or dimming control.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator & your body.
claration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies
pour un environnement non contrô. Cet équipement doit être installé et utilisé avec
un minimum de 20 cm de distance entre la source de rayonnement et votre corps.
  • Page 1 1
  • Page 2 2
  • Page 3 3

GE Lighting BR30-DMEN Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues