1
2
3
4
5
6
7
Tip
– See the User Manual on how to
connect other equipment to this
system.
– Use the supplied AC power
adaptor only! Using any other
power connection device may
damage your main set!
Setting the clock
1
Connect the AC power adaptor of the system.
1
In standby mode, press and hold PROG/SET TIME on the remote control.
Press VOLUME +/- (or VOL +/- on the remote control) to switch
between 12 hour and 24 hour display.
Press PROG/SET TIME on the remote control again to confirm.
➜ The clock digits flash on the display panel.
Press VOLUME +/- (or VOL +/- on the remote control) to set the hours.
Press PROG/SET TIME on the remote control again.
➜ The clock digits for the minutes flash.
Press VOLUME +/- (or VOL +/- on the remote control) to
set the minutes.
Press PROG/SET TIME on the remote control to confirm the time.
POWERFUL BASSPOWERFUL BASS
DC910_12_QSG_Eng 4/30/08, 12:122