16
KÜSCHALL CHAMPION
© Küschall AG, Switzerland | 2014-12
Service Manual
BACKREST
Height adjustable integrated push handles
Diculty: Tools: Ã3 8 Ò2
Fit the backrest tube A corresponding to the desired backrest
height (RH) on both sides using the bolts B.
Slide the backrest bands C corresponding to the desired backrest
height (RH) and, if required, the end band D (or the standard
backrest cover) over the backrest tube A.
Slide the push handle F into the backrest tube A on both sides
and secure it at the desired height using the clamp bolt G.
Secure the end band D (or the standard backrest cover) to the
backrest tube A on both sides using the screws E.
Height adjustable rear set push handles
These push handles can only be used in combination with adjustable
backrests, not with standard backrests.
Diculty: Tools: Ã3 8 Ò2
Fit the intermediate tube A on both sides using the bolts B.
Slide the backrest bands C corresponding to the desired backrest
height (RH) onto the intermediate tube A.
Fit the telescopic tube D corresponding to the desired backrest
height (RH) on both sides using the bolt E.
Slide the holder F and the sleeve G onto the telescopic tube D
and secure it using the screws H.
For the minimum backrest height, the holder of the rear set push
handle must be fitted to the intermediate tube A. In this case, the
sleeve G is not required.
Slide the end band I onto the telescopic tube D and secure it on
both sides using the screws J.
Replacing the handle
An adhesive (e.g. hair spray) is used in these instructions. When
applied to the handle, this substance works as a lubricant and as an
adhesive once dry.
After drying, the adhesive used must be able to resist a pull-o
force of 750 N. If in doubt, contact Küschall® AG.
Diculty:
Remove the old handle.
Remove any residue (residual adhesive, grease, dust) from the
push handle tube.
Apply a thin layer of hair spray all over the surface of the push
handle tube onto which the handle is to be slid.
Apply a thin layer of hair spray to the inside of the handle.
Slide the new handle onto the push handle tube.
Move the handle into the correct position (grooves facing
upwards).
i
If a long handle has been fitted and this is to be replaced with a
short one, the push handle tube must be shortened by 35 mm.
The push handle tube must be replaced when switching from a
short to a long handle.
B à 7 Nm
E à 4 Nm
B à 7 Nm
E à 7 Nm
H à 13 Nm
J à 4 Nm