Download and install JXLCAM. IOS searches for "JXLCAM" download directly

at the Apple App Store. For convenience, please scan the download and installation

of the QR code below.

Note: during installation, all permissions of the JXLCAM APP need to be

allowed, otherwise the APP will not work properly.

1..

Please select APP to download

iPhone selection

1.First confirm that there is a available WIFI near the device, turn on the

device, flash the blue indicator light quickly, and the device is in a state to be

connected. ( Note: WIFI signals supported only in the 2.4G band)

2.You can't successfully distribute the network when the power is insufficient.

3.When wiring, please try to bring the device close to the router. When the

nearby WIFI signal is weak, the image will be stuck if the network is not

successful or the network is successful.

4.Open the APP and follow these steps:

3.

ōSelect to connect your 2.4G band

WIFI, and then click JXLCAM in the

upper left corner to return to the APP.

ľ.Click "..."

ĿClick Ā6ettLngsāŀClick“WLAN”

"ACCQ..." Then click JXLCAM in the

upper left corner to return to APP.

SD card playback file

Networking status Manually record files

4.

Local mode Add the device

View videos/photos in local mode.

When the device fails to con¿gure the network, please check whether the router

and WiFi password are con¿gured correctly (the device does not support WIFI

signals in the 5.8G band). After con¿rming that it is correct, you can press and

hold the reset button until the device indicator Àashes quickly, restore the

factory settings, and recon¿gure network.

If you need to store video content, you need to install an SD card.

˄This machine supports loop video recording˅