JADEMAR LIGHTING JWP-R Manuel utilisateur

JWP-R
Marque
JADEMAR LIGHTING
Modèle
JWP-R
Taper
Manuel utilisateur
INSTALLATION REQUIREMENTS
WARNING: Risk of electric shock and serious injury. SHUT OFF BREAKER AT PANEL BEFORE INSTALLING.
JWP-R ROTATING WALL PACK
WWW.JADEMAR.COM
Miami, FL USA - info@jademar.com
T: 305.640.0465 - F: 305.640.0468 Revised 04/2023
Page of 1 3
INSTALLATION INSTRUCTIONS
Warning:
1. Can not use the electric generator to test the LED lamp.
2. This luminaire must be installed in accordance with your local electrical codes and requirements;
3. Do not install the luminaire in the rain, to avoid lightning stroke and damage to luminaire.
Installaon Noce:
1. This luminaire must be installed by qualified electrician to avoid electric shock and fire accident;
2. Wear gloves before installaon in order to avoid injury;
3. Turn off the power immediately when there is smoke and fire during installaon; inform professionals to overhaul;
4. This luminaire is suited for outdoor use.
Standard wire:
L/live wire: N/null wire: Black\Brown; White\Blue;
Ground wire: Green\ Yellow-green
Warning: MIN 75 °C SUPPLY CONDUCTOR THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITHTHE AFPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OFTHE PRODUCT AND THE HAZARDS INVOLVED.
Averssement: LES FILS D'ALIMENTATION 75 °C MINCE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D'INSTALLATION PERTINENT, PAR UNE
PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE LES RISQUES INHÉRENTS.
1.0 INSTALLATION STEPS - WIRING FROM THE BOTTOM OF THE LUMINAIRE
1. Cut the holes on the wall according to locang plate. Figure 1-1 2. Fix rubber plugs into holes Figure 1-2
3.Align mounng bracket with hole; ghten screws. Figure 1-3 Make wiring connecon and go through isolaon treatment
Figure 1-4
JWP-R ROTATING WALL PACK
INSTALLATION INSTRUCTIONS
1.0 INSTALLATION STEPS - WIRING FROM THE BOTTOM OF THE LUMINAIRE
5. Fix the luminaire on the bracket and ghten screws on the boom.
Figure 1-5
6. Aer Installaon, ghten the screws. Figure 1-6
1. Cut the holes on the wall according to locang plate. Figure 2-1 2. Fix rubber plugs into holes Figure 2-2
3. Align mounng bracket with hole; ghten screws. Figure 2-3 4. Fix the luminaire on the bracket; make wiring connecon from side
and go through isolaon treatment. Figure 2-4
5. Tighten the pipe on the luminaire; aer installaon, ghten the screws. Figure 2-5
2.0 INSTALLATION STEPS - WIRING FROM THE SIDE OF LUMINAIRE
WWW.JADEMAR.COM
Miami, FL USA - info@jademar.com
T: 305.640.0465 - F: 305.640.0468 Revised 04/2023
Page of 2 3
JWP-R ROTATING WALL PACK
INSTALLATION INSTRUCTIONS
3.0 INSTALLATION STEPS - BRACKET INSTALLATION
1. Cut holes on the wall according to locang plate. Figure 3-1 2. Fix rubber plugs into holes. Figure 3-2
3. Align mounng bracket with hole; ghten screws. Figure 3-3 4. Pass wires through rubber ring and juncon box, align with holes
and lock juncon box. Figure 3-4
5. Make wiring connecon and go through isolaon treatment
Figure 3-5
6. Push the wires into juncon box; aer installaon, ghten the
screws. Figure 3-6
WWW.JADEMAR.COM
Miami, FL USA - info@jademar.com
T: 305.640.0465 - F: 305.640.0468 Revised 04/2023
Page of 3 3
  • Page 1 1
  • Page 2 2
  • Page 3 3

JADEMAR LIGHTING JWP-R Manuel utilisateur

JWP-R
Marque
JADEMAR LIGHTING
Modèle
JWP-R
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents