Carrier NEOS 100S Manuel utilisateur

Carrier
Marque
Carrier
Modèle
NEOS 100S
Taper
Manuel utilisateur
UNIT MODEL EVAPORATOR
MODEL
REFRIGERANT
CHARGE CPR SETTING GAS
NEOS 100S MNS 600 1.0 kg #0.1 [2.2 lb] 0.7 bar #0.1 [10.3 psi] R-134A
SHEET
INDEX
REV - -
SHEET 1 2
TRANSICOLD
98-60608
CORPORATION'S WRITTEN CONSENT.
CONTENTS WILL NOT BE DISCLOSED OR US ED WITHOUT CARRIER
AND IS DELIVERED UPON THE EXPRESS CO NDITION THAT THE
THIS DOCUMENT IS THE PROPERTY OF CAR RIER CORPORATION
ACCEPTANCE OF CONTRACT
DOES NOT CONSTITUTE PART PERFORMANCE OR
SUBMISSION OF THESE DRAWINGS OR DOCU MENTS
CARRIER
TECHNOLOGIES
UNITED
REV
DATE DRAWN BY DATE
ENGRG. DATE
APPLICATION
ENGRG.
TITLE DRAWING NO.
INSTRUCTION D'INSTALLATION NEOS 100S
[INSTALLATION INSTRUCTIONS NEOS 100S ]
SYM REVISION RECORD
-
R.C. ROUEN B 410 041 677
76520 BOOS
FRANQUEVILLE SAINT PIERRE
BOITE POSTALE 16
CARRIER TRANSICOLD INDUSTRIES S.A
EUROPEAN
FRANCE
OPERATIONS
TRANSCONTINENTAL
(ETO)
-INITIAL RELEASE 71E0001P10 12-FEB-10 C.S. METRIC FORMAT:
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN MILLIMETERS WITH
IMPERIAL CONVERSIONS IN [INCHES]
FIRST ANGLE
PROJECTION
SHEET 1 OF 2
WARNING
READ ALL NOTES PRIOR TO INSTALLATION
NOTES:
1- TRUCK BODY
1.1- THE TRUCK STRUCTURE MUST BE EVALUATED BY THE TRUCK MANUFACTURER TO DETERMINE
ITS ABILITY TO WITHSTAND THE LOADS IMPOSED BY THE UNIT OVER ITS SERVICE LIFE.
CARRIER TRANSICOLD DOES NOT CONVEY ANY ENDORSEMENT OR WARRANTY FOR THE
TRUCK'S STRUCTURAL INTEGRITY.
1.2 -UNIT MOUNTING SURFACES OF THE TRUCK THAT CONTACT THE UNIT MOUNTING PADS MUST BE
UNI-PLANAR TO WITHIN 3 mm [0.12 ] TO PREVENT DISTORTION OF THE UNIT AND/OR TRUCK.
2- INSTALLATION
2.1- THIS REFRIGERATION UNIT HAS BEEN DESIGNED WITH THE SAFETY OF THE MECANICIAN IN MIND.
DURING NORMAL OPERATION, ALL MOVING PARTS ARE FULLY ENCLOSED TO PREVENTINJURY.
DURING ALL PRE-TRIP INSPECTIONS, DAILY INSPECTIONS AND PROBLEM TROUBLESHOOTING,
YOU MAY BE EXPOSED TO MOVING PARTS.WE ADVISE YOU TO TAKE ALL REQUIRED PRECAUTIONS
GENERAL AND TO WEAR ADEQUATE PROTECTIVE EQUIPMENT (SAFETY GLASSES, GLOVES,
SAFETY SHOES) DURING INSTALLATION AND ALL REPAIRS AND MAINTENANCE SERVICES ON THE UNIT.
2.2- TAKE EVERY SAFETY MEASURE WHEN ACCESING THE UNIT, USE STANDARDS LADDERS, WORKING
PLATEFORM WITH RAILING, SAVETY BELT.
2.3- UNITS ARE DELIVERED UNDER PRESSURE WITH NITROGEN. PLEASE BE SURE THAT THE CIRCUIT IS
STILL UNDER PRESSURE (IT MEANS THAT THERE IS NO LEAK).
2.4- INSTALLATION AND COMMISSIONING PROCEDURE WILL DESCRIBED ON ELECTRONIC TECHNICAL
MANUAL "MODULE INSTALLATION" AVAILABLE FROM WEBSITES.
3- SERVICE
3.1- IT IS IMPORTANT FOR THE SAFETY AND UPKEEP OF THE REFRIGERATION UNIT THAT SERVICING IS
PERIODICALLY PERFORMED ACCORDING TO THE FREQUENCY INDICATED BY THE MANUFACTURED
(SEE SERVICE MANUAL), SERVICE OPERATIONS AND REPAIRSMUST BE CARRIED OUT BY APPROVED
CARRIER SERVICE STATION.
3.2- [ETO ONLY]
GOLDEN COLD SERVICE CONTRACTS : THE PROOF OF OUR COMMITMENT TO YOUR PROFITABILITY
WITH A CHOISE OF CONTRACTS : FULL SERVICE / ROUTINE MAINTENANCE / EXTENDED WARRANTY.
NEOS 100S
MONTAGE TOIT
[ROOF TOP]
MONTAGE CAPUCINE
[ROOF CUT MOUNTING]
MONTAGE FACADE
[NOSE MOUNT]
478
214
226
864
225
550
370
620
130
165
607
530
383
405
75
38
548
583
151
550
225
370
22
157
NEOS 100S WEIGHT
Kg [lb]
CONDENSER UNIT 48 [106]
EVAPORATOR 15 [33]
TRANSICOLD
98-60608
CORPORATION'S WRITTEN CONSENT.
CONTENTS WILL NOT BE DISCLOSED OR US ED WITHOUT CARRIER
AND IS DELIVERED UPON THE EXPRESS CO NDITION THAT THE
THIS DOCUMENT IS THE PROPERTY OF CAR RIER CORPORATION
ACCEPTANCE OF CONTRACT
DOES NOT CONSTITUTE PART PERFORMANCE OR
SUBMISSION OF THESE DRAWINGS OR DOCU MENTS
CARRIER
TECHNOLOGIES
UNITED
REV
DATE DRAWN BY DATE
ENGRG. DATE
APPLICATION
ENGRG.
TITLE DRAWING NO.
INSTRUCTION D'INSTALLATION NEOS 100S
[INSTALLATION INSTRUCTION NEOS 100S ]
SYM REVISION RECORD
-
R.C. ROUEN B 410 041 677
76520 BOOS
FRANQUEVILLE SAINT PIERRE
BOITE POSTALE 16
CARRIER TRANSICOLD INDUSTRIES S.A
EUROPEAN
FRANCE
OPERATIONS
TRANSCONTINENTAL
(ETO)
-INITIAL RELEASE 71E0001P10 22 FEB 10 C.S. METRIC FORMAT:
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN MILLIMETERS WITH
IMPERIAL CONVERSIONS IN [INCHES]
FIRST ANGLE
PROJECTION
SHEET 2 OF 2
A
B
BOTTOM PANEL
ROOFMOUNT PREPARATION
ELINGUE P/N 07-60086-00
[LIFTING DEVICE 07-60086-00]
VUE SUIVANT B FIXATION DU CONDENSEUR PAR L'ARRIERE
[VIEW FOLLOWING B CONDENSER FIXATION BY THE REARSIDE]
VUE SUIVANT A FIXATION DU CONDENSEUR PAR LE DESSOUS
[VIEW FOLLOWING A CONDENSER FIXATION BY THE BOTTOM]
AVANT DE PERCER S'ASSURER QUE LES TROUS SERONT REALISES DANS LE BON SENS
POUR CELA UTILISER LES FLECHES D'ORIENTATION DE VUES A ET B ET LES VUE S
ASSOCIEES POUR SE REPERER
[BEFORE DRILLING MAKE SURE HOLES WILL BE REALIZED IN THE GOOD SIDE, FOR THIS
USED ARROWS A AND B AND VIEWS ASSOCIATED FOR ORIENTATION]
OPTION TOIT
[ROOFTOP OPTION]
OPTION CAPUCINE
ROOF CUT
PERCAGE DIA. 33 POUR MONTAGE TOIT
[DRILL 1.3 FOR ROOF MOUNT]
  • Page 1 1
  • Page 2 2

Carrier NEOS 100S Manuel utilisateur

Carrier
Marque
Carrier
Modèle
NEOS 100S
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents