11
SOME RECOMMENDATIONS FOR BEST RESULTS WHEN
COOKING RICE
“RICE” FUNCTION
• Measure the rice and rinse it thoroughly under running water in a sieve for
2 minutes (except for risotto rice which should not be rinsed). Then place
the rice in the bowl together with the corresponding quantity of water.
• Make sure that the rice is well distributed around the whole surface of
the bowl, in order to allow even cooking.
• Add salt to your personal taste if required.
• Water may be substituted for stock. If using stock, there is the risk of rice
browning a bit on the bottom of the pan.
• Do not open the lid during cooking as steam will escape and this will
affect the cooking time and the taste.
• When the rice is ready, the “Keep Warm” indicator light will turn on, stir
the rice and then leave it in the multicooker for a few minutes longer in
order to get perfect rice with separate grains.
• Place the appliance on a flat, stable, heat-resistant work surface away
from water splashes and any other sources of heat.
• Pour the required quantity of rice into the bowl using the measuring cup
provided – fig.9. Then fill with cold water up to the corresponding “CUP”
mark printed in the bowl – fig.10.
• Close the lid.
Note: Always add the rice first otherwise you will have too much water.
• Press “Menu” key to select function “Rice”. The screen displays “--”, the light
of “Start” flickers, then press “Start” key. The multicooker enters into “Rice”
cooking status, the light of “Start” lights up, the LED screen displays “-”.
• At the end of cooking, the buzzer will ring twice “beep beep”, the
multicooker will start to simmer and the screen will count down the
simmering time: 14 minutes.
• After simmering, the buzzer will ring several times, the multicooker will enter
keep warm status with the “Keep Warm” indicator turning on and the screen
will display “b” signaling that the appliance is now in keep warm mode.
“RISOTTO” FUNCTION
• Press “Menu” key to select function “Risotto”. The screen displays “--”,
the light of “Start” flickers, then press “Start” key. The multicooker enters
into “Risotto” cooking status. The light of “Start” lights up, and the LED
screen displays “-”.