HP LaserJet 1320 Printer series Guide de démarrage rapide

Start

Démarrage

Start

Avvio

Inicio

HP LaserJet 1320nw

Wireless

lea esto primero

HP LaserJet 1320nw Printer

Wireless

Getting Started Guide

English

Copyright and License

Development Company, L.P.

Reproduction, adaptation, or translation

without prior written permission is

prohibited, except as allowed under the

copyright laws.

The only warranties for HP products and

services are set forth in the express

warranty statements accompanying such

products and services. Nothing herein

should be construed as constituting an

additional warranty. HP shall not be liable

for technical or editorial errors or omissions

contained herein.

The information contained herein is subject

to change without notice.

FCC Regulations

This equipment has been tested and found

to comply with the limits for a Class B

digital device, pursuant to Part 15 of the

FCC rules. These limits are designed to

provide reasonable protection against

interference when the equipment is

operated in a residential installation. This

equipment generates, uses, and can

radiate radio frequency energy and, if it is

not installed and used in accordance with

the instructions, it may cause harmful

interference to radio communications.

However, there is no guarantee that

interference will not occur in a particular

installation. If this equipment does cause

harmful interference to radio or television

reception, which can be determined by

turning the equipment off and on, the user

is encouraged to try to correct the

interference by one or more of the following

measures:

Reorient or relocate the receiving antenna.

Increase separation between the

equipment and receiver.

Connect equipment into an outlet on a

circuit different from that to which the

receiver is connected.

Consult your dealer or an experienced

radio/TV technician.

Any changes or modifications to the printer

that are not expressly approved by HP

could void the user's authority to operate

the equipment.

Use of a shielded interface cable is

required to comply with the Class B limits

of Part 15 of FCC rules.

This device complies with Part 15 of FCC

Rules. Operation is subject to the following

two conditions: (1) this device may not

cause harmful interference, and (2) this

device must accept any interference

received, including interference that may

cause undesired operation.

Trademark Credits

Microsoft®, Windows®, and Windows NT®

are U.S. registered trademarks of Microsoft

Corporation.

All other devices mentioned herein may be

trademarks of their respective companies.

Edition 1, 5/2005

Part number: Q5929-90916

Table of contents

1 Introduction

Device overview .......................................................................................................................2

Preparing the location ..............................................................................................................3

Package contents ....................................................................................................................4

Locating the device parts .........................................................................................................5

2 Setting up the printer

Remove the tape ......................................................................................................................8

Prepare the print cartridge .......................................................................................................9

Load Tray 2 ............................................................................................................................12

Select a connection method ...................................................................................................13

Connect the printer to a wired network ..................................................................................14

Connect the printer to a wireless network ..............................................................................16

Network components and procedure for Windows infrastructure network

installation (recommended) ..........................................................................................16

Network components and procedure for Windows ad hoc (peer-to-peer) network

installation (for advanced users) ..................................................................................19

Procedure for connecting to a Macintosh wireless network ............................................22

Direct connect using the USB port .........................................................................................24

ENWW Table of contents iii

English

iv ENWW

Introduction

This chapter contains the following sections:

●

Device overview

●

Preparing the location

●

Package contents

●

Locating the device parts

ENWW 1

English

Device overview

NOTE

The HP LaserJet 1320nw printer is part of the HP LaserJet 1160 and HP LaserJet 1320

series printer family. For information about using the printers in this series, see the

HP LaserJet 1160 and HP LaserJet 1320 User Guide located on the CD-ROM.

The HP LaserJet 1320nw printer contains all the features of the HP LaserJet 1320 printer. In

addition, the HP LaserJet 1320nw printer includes integrated 802.11b/g wireless connectivity

and an internal HP Jetdirect network port, instead of an IEEE-1284B parallel port.

2 Chapter 1 Introduction ENWW

Preparing the location

Place the printer on a sturdy, level surface in a well-ventilated area. Make sure there is

enough space around the printer to allow air to flow through the vents.

Do not place the printer in direct sunlight or in an area that has abrupt temperature and

humidity changes. The recommended temperature range is 10°C to 32.5°C (50°F to 90.5°F).

ENWW Preparing the location 3

English

Package contents

The printer package contains the following hardware, software, and documentation.

1 HP LaserJet 1320nw printer

2 Documentation (this manual)

3 CD-ROM containing the installation software (provided with the printer)

4 CD-ROM containing the HP LaserJet 1320nw printer Wireless User Guide (provided with the

printer)

5 Power cord

6 Network cable

4 Chapter 1 Introduction ENWW

Locating the device parts

1 Wireless light

2 Toner light

3 Attention light

4 Ready light

5 G

O

button and light

6 C

ANCEL

button

7 Output bin

8 Media support

9 Print cartridge door

10 Single-sheet priority input slot (Tray 1)

11 Main input tray (Tray 2)

12 On/off switch

1 Straight-through output door

2 Power receptacle

3 Automatic two-sided printing media-size selector

4 USB port

5 Network reset button

6 Internal HP Jetdirect network port

7 Rear automatic two-sided path door

8 Jam clearing levers

ENWW Locating the device parts 5

English

6 Chapter 1 Introduction ENWW

Setting up the printer

This chapter contains the following sections:

●

Remove the tape

●

Prepare the print cartridge

●

Load Tray 2

●

Select a connection method

●

Connect the printer to a wired network

●

Connect the printer to a wireless network

●

Direct connect using the USB port

ENWW 7

English

Remove the tape

1. Remove the orange tape from the front of the printer.

8 Chapter 2 Setting up the printer ENWW

Prepare the print cartridge

1. Open the print cartridge door.

2. Flip the paper back.

3. Remove the foam packaging.

4. Remove the print cartridge.

5. Remove the orange clip on the print cartridge.

ENWW Prepare the print cartridge 9

English

6. Grasp both sides of the cartridge and gently rock the cartridge forward and backward

five times. This action distributes the toner.

5x

7. Remove the inside sealing tape by breaking the tab on the end of the cartridge and

pulling the tape completely out.

8. Remove the paper and the orange transfer roller spacer. (They should be connected.)

10 Chapter 2 Setting up the printer ENWW

9. Insert the print cartridge.

NOTE

To prevent damage to the print cartridge, minimize its exposure to direct light.

10. Close the print cartridge door.

ENWW Prepare the print cartridge 11

English

Load Tray 2

1. Open the tray and move the media guides to the correct media size settings.

2. Insert the paper with the top forward and the side to be printed facing down.

3. Close the tray.

12 Chapter 2 Setting up the printer ENWW

Select a connection method

Select one of the following methods for connecting the printer:

● Wired network: To connect to a wired network, see

Connect the printer to a wired

network

-or-

● Wireless network: To connect to a wireless network, see

Connect the printer to a

wireless network

-or-

● USB: To perform a USB direct connect, see

Direct connect using the USB port

The following sections contain additional information about each of the connection options.

ENWW Select a connection method 13

English

Connect the printer to a wired network

1. Plug the power cord into the printer and then plug the cord into the power outlet.

2. Connect the Ethernet cable between the HP Jetdirect network port on the printer and the

network hub.

3. Turn the printer on.

14 Chapter 2 Setting up the printer ENWW

La page charge ...

HP LaserJet 1320 Printer series Guide de démarrage rapide

HP LaserJet 1320 Printer series Guide de démarrage rapide

dans d''autres langues

Documents connexes

Autres documents