Your satisfaction with your Intex kayak is very important to us and we would greatly

appreciate your feedback. Please visit www.intexcorp.com and click on “Boat Satisfaction

Survey” to leave a quick feedback - thank you.

Due to a policy of continuous product improvement, Intex reserves the right to change

specifications and appearance, which may result in updates to the instruction manual,

without notice.

084-*PO-R0-2005

INTRODUCTION......................................................................................................3

MANUFACTURE’S CERTIFICATION......................................................................3

SEAT INSTALLATION...................

..

SEAT BOOSTER PAD INSTALLATION...........................................

FOOTREST ASSEMBLY....................................................................

PADDLE ASSEMBLY.........................................................................

SAFETY AND OPERATION INSTRUCTIONS................................

CARE AND MAINTENANCE....................................................................

................

DISASSEMBLY AND STORAGE.............................................................................9

TROUBLESHOOTING...........................................................

...................................

REPAIRS..................................................................................................................9

If this is your first craft, or you are changing to a type of craft you are not familiar with, for

your own comfort and safety, please ensure that you obtain handling and operating

experience before assuming command of the craft. Your dealer or national sailing federation

or yacht club will be pleased to advise you of local sea school, or competent instructors.

PLEASE KEEP THIS MANUAL IN A SECURE PLACE, AND HAND IT OVER TO THE

NEW OWNER WHEN YOU SELL THE CRAFT. RECORD THE “HULL IDENTIFICATION

NUMBER” (HIN) WHICH IS PRINTED ON THE KAYAK’S HULL IN THE FOLLOWING BOX:

Standardization.

This is not a life saving device. Use only under competent supervision. Never allow

diving into this product. Never leave in or near the water when not in use.

Read the complete Owner’s Manual before use and store this Manual in a safe place

for future reference.

• Follow all the Safety and Operating Instructions on this Manual.

• Inflatable kayaks intended for beach use, short-time and short-distance cruising.

Distribute the weight of passengers, gear, tackle box, and accessories so that the kayak

sits level fore (front) to aft (back) and side-to-side.

• Do not use your kayak if you suspect a puncture or leak.

• Adults should inflate the chambers in numbered sequence.

• Not for white water rafting or any other extreme sports activities.

• Not for commercial or rental use.

• Follow these rules to avoid drowning, paralysis or other serious injuries.

Before starting, locate a clean area free of stones or other sharp objects. Unroll the kayak so

it is laid out flat, and locate your pump.

Use a hand or foot operated air pump to inflate the boat. Do not use high-pressure air

compressors. Adults should inflate the chambers following the numerical sequence marked

on the valves. It is very important to follow the numerical sequence; failure to do so will result

in an improperly inflated boat. Fill each chamber until it is stiff to the touch but NOT hard.

Use the enclosed pressure gauge to check the main chamber for

occurs, you may want to add a little air to the product. However, in hot

weather, the air will expand. You must let some air out to prevent the

product from failing due to overpressure.

1. Slide the end cap over the end of the fishing rod.

2. Insert the end cap into the fishing rod holder.

1. Inflate each seat slowly to about 75% of its capacity.

2. Place the seat on the velcro stripe located on the floor according to the user size. Then

hook the side strap to the D-ring on the side of the hull and adjust the strap length.

1

3. To disassemble, reverse the assembly steps. Note: is not necessary to detach the paddle

blades from the shafts.

1. Unscrew the cap to reveal the stem, push the stem in and

turn 90 degree right to secure it in the down position.

2. Once the deflation is completed, push the stem in and

turn 90 degree left to return it into the inflation position.

3. Replace the cap back.

Take a boating safety course and get hands-on training from your boat dealer or local

boating authorities.

Know all local regulations and hazards related to water activities and boat operation.

Check weather forecast, local currents, tides and wind conditions.

Advise someone on land of the time you plan to be back at your starting point.

Be sure that one of your passengers can operate the boat in case of emergency.

Learn how to determine the distance you can cover, and remember that bad weather

conditions can alter this.

Review all safety requirements regularly.

Check inflation pressure.

One personal flotation device (PFD) per person.

Lights are required if operating after dark.

Always keep control of your boat.

shelter rapidly.

Everyone on board must always wear a personal flotation device (PFD).

Do not drink alcohol or take drugs before or while operating your boat. Maintain passenger sobriety.

Do not exceed the authorized number of persons or weight.

Be especially careful when docking. Arms and legs may be injured if they are outside the boat.

Keep clear of swimmers and divers. Always avoid areas where divers/swimmers are in the water.

Keep a sharp lookout especially when operating near beaches and launch sites. The Alpha flag

indicates proximity of divers. You MUST maintain a safe distance as required by your local boating

laws, which may range from 50 meters (164 feet) to 91 meters (300 feet).