Safety and Regulatory Notices | Poly Studio R30 USB Video Bar Version 1.0.0
Poly 2
Plug Acts as Disconnect Device
The socket outlet to which this apparatus is connected must be installed near the equipment and must
always be readily accessible.
Part 15 FCC Rules
This device is compliant with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
● This device may not cause harmful interference.
● This device must accept any interferences received, including interference that may cause
undesired operation.
Class B Digital Device or Peripheral
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Modifications
In accordance with Part 15 of the FCC Rules, the user is cautioned that any changes or modifications not
expressly approved by Polycom, Inc. could void the user’s authority to operate the equipment.
Radiation Exposure Statement
The antenna used for this transmitter must be installed to provide a separation distance of at least 20
centimeters from all persons and must not be co located or operating in conjunction with any other
antenna or transmitter. This device with its antenna complies with FCC’s RF radiation exposure limits set
forth for an uncontrolled environment. To maintain compliance, this transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.