www.segway.com
CE.-A
XX
Ninebot KickScooter
Product Manual
EN
The manufacturer reserves the right to make changes to the product, release firmware updates, and update this manual at any
time. Visit www.segway.com or check the Segway-Ninebot app to download the latest user materials. You must install the app,
activate your KickScooter, and obtain the latest updates and safety instructions.
EN
EN The pictures shown are for illustration purposes only. The actual product may vary.
140mm
Diagram
1
EN
Bell
Handlebar Throttle
Snap Hook
Left Direction Indicator
Dashboard & Power Button
Safety Button
Brake Lever
Reflector
Reflector
Headlight
Stem
Folding Mechanism
Quick-release Lever
Front Fork
Front Fender
Drum Brake Hub Motor
Rear Direction
Indicator
Charge Port
Footboard
Buckle
Rear Fender
Tail light
& Brake Light
& Reflector
Insurance
Plate Area
Kickstand
Battery Compartment
Direction Indicator Button
Right Direction Indicator
Power Button: Press the button to power on; press and hold the button for 3 seconds to power off. When the KickScooter is on, press the
button to turn on/off the headlight and the tail light; and press twice to switch between the speed modes.
Speedometer: It displays the current speed of the scooter, as well as error codes.
Left Direction Indicator Icon: When this icon blinks, it indicates that the direction indicators on the left side are turned on.
Right Direction Indicator Icon: When this icon blinks, it indicates that the direction indicators on the right side are turned on.
Walk Mode: Max. speed is 5 km/h (3.1 mph).
F65U: The headlight and tail light keep flashing and can't be turned off.
* How to enable in the Segway-Ninebot app: Settings > Walk Mode.
Speed Mode: There are three modes available. The top speed is as follows:
Error Notification: It indicates that the scooter has detected an error.
Temperature Warning: It indicates that the battery temperature has reached 55°C (131°F) or is below 0°C (32°F).
* At this point, the KickScooter cannot accelerate normally and may not be charged. DO NOT use until the temperature has reverted to the
normal range.
Bluetooth: It indicates that the scooter has been successfully connected to the mobile device.
Battery Level: The total battery level equals 5 bars.
* The battery power is very low when the first battery bar is red. Please charge your KickScooter immediately.
Specications
2
Dashboard & Power Button
Speedometer
Bluetooth
Headlight
Temperature Warning
Speed Mode
Walk Mode
Battery Level
Power Button
Left Direction Indicator Icon Right Direction Indicator Icon
Model
Mode F65U
15 km/h (9.3 mph)
30 km/h (18.6 mph)
30 km/h (18.6 mph)
ECO (Energy-saving mode)
D (Standard mode)
S (Sport mode)
Approx. 30 km/h (18.6 mph)
Approx. 65 km (40.4 miles)
Approx. 20%
-10–40°C (14–104°F)
-10–50°C (14–122°F)
0–40°C (32–104°F)
IPX5
Approx. 5 h
Bicycle lanes, parks, campuses and most of the flat road conditions and
typical Belgian roads
Energy-saving mode, Standard mode and Sport mode
Features
Tire
Approx. 1196 × 569 × 1237 mm (47 × 22.4 × 48.7 in)
Approx. 1196 × 569 × 540 mm (47 × 22.4 × 21.3 in)
Approx. 21.8 kg (48 lbs)
Product
Rider
Machine
Battery
Motor
Charger
Ninebot KickScooter
F65U
Item Parameter
Name
Model
Length × Width × Height
Folded: Length × Width × Height
Net Weight
Payload
Recommended Age
Required Height
Max. Speed
Typical Range[1]
Max. Slope
Traversable Terrain
Operating Temperature
Storage Temperature
Charging Temperature
IP Rating
Duration of Charging
Nominal Voltage
Max. Charging Voltage
Nominal Capacity
Nominal Energy
Battery Management System
Output Power
Input Voltage
Max. Output Voltage
Rated Output
Brake Light
Speed Modes
Tire Pressure 40–45 psi
Tires 10-inch Pneumatic tire
0.16 kW, 160 W
100–240 V ~ 50–60 Hz, 2.0 A MAX.
54.6 V
53.5 V , 3 A
Nominal Power
Max. Power
Model
0.4 kW, 400 W
0.7 kW, 700 W
NBW54D603D0D
Type Built-in
46.8 V
54.6 V
12 Ah
561 Wh
Over-heating, short circuit, over-current, over-discharge and
over-charge protection
30–120 kg (66–265 lbs)
14–60 years
130–200 cm (4’3”–6’6”)
[1] Typical Range: tested while riding with a full battery, 75 kg (165 lbs) load, 25°C (77°F), at the speed of 18 km/h (11.2 mph) on average on pavement.
* Some of the factors that affect range include speed, number of starts and stops, ambient temperature, etc.
Brighter when braking
EN EN
Certications
3
EN
This product is certified to ANSI/CAN/UL-2272 by SGS.
The battery complies with UN 38.3.
The battery complies with ANSI/CAN/UL-2271.
FCC ID: 2ALS8-KS0012
IC ID: 22636-KS0012
EN
Federal Communications Commission (FCC) Compliance Statement for USA
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator & your body.
Cet équipement est conforme aux limites d'exposition aux radiations de la IC dénies pour un environnement non contrôlé.
Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le radiateur et votre corps.
Industry Canada (IC) Compliance Statement for Canada
This device complies with Industry Canada license-exempt RSS standard (s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
CAN ICES-3 (B)/NMB-3(B)
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Neither Segway Inc. nor Ninebot is responsible for any changes or modifications not expressly approved by Segway Inc. or
Ninebot. Such modifications could void the user's authority to operate the equipment.
-
1
-
2
-
3
-
4
