Powerfist 9032244 Le manuel du propriétaire

Taper
Le manuel du propriétaire
SPECIFICATIONS
HAZARD DEFINITIONS
INTRODUCTION
SAFETY
WARNING! Read and understand all instructions before
using this tool. The operator must follow basic
precautions to reduce the risk of personal injury
and/or damage to the equipment.
WORK AREA
PERSONAL SAFETY
WARNING! Wear personal protective equipment
approved by the Canadian Standards Association (CSA)
or American National Standards Institute (ANSI).
PERSONAL PROTECTIVE EQUIPMENT
PERSONAL PRECAUTIONS
SPECIFIC SAFETY PRECAUTIONS
WARNING! DO NOT let comfort or familiarity with
product (gained from repeated use) replace strict
adherence to the tool safety rules. If you use this tool
unsafely or incorrectly, you can suffer serious personal
injury.
WARNING! Ensure that the load is secure and centered
on the device. Do not allow the load to move or tilt as
the device may kick out causing injury to the operator
and/or cause the load to fall.
BATTERY PRECAUTIONS
WARNING! The battery contains strong acid. Avoid
contact with skin and eyes. If contact occurs,
immediately wash skin or flush eyes with water for 30
minutes without interruption. Continue flushing while
transporting victim to a medical centre.
WARNING! Do not charge a damaged or frozen battery.
Internal damage may allow the battery contents to
leak, creating a hazardous spill. Contact your local
municipality for proper disposal procedures.
WARNING! Only charge a battery with a charger
designed for that purpose. Do not use modified
chargers or a charger that does not specify the
voltage, amperage or recharge rate. Improper charging
can lead to the battery rupturing.
WARNING! All wiring should be performed by a
qualified electrician.
UNPACKING
WARNING! Do not operate the tool if any part is
missing. Replace the missing part before operating.
Failure to do so could result in a malfunction and
personal injury.
ASSEMBLY & INSTALLATION
INSTALLING THE STEERING
HANDLE
CHARGING THE BATTERY
OPERATION
MOVING THE TRUCK
OPERATING THE LIFT
CARE & MAINTENANCE
WARNING! Only qualified
service personnel should
repair the tool. An
improperly repaired tool may
present a hazard to the user
and/or others.
LUBRICATION
NOTICE! NEVER use a penetrating oil to lubricate the
tool. Penetrating oil may act as a solvent that can
break down the grease and cause the tool to seize up.
DISPOSAL
IMPORTANT! DO NOT pollute the environment by
allowing uncontrolled discharge of waste oil.
TROUBLESHOOTING
Problem(s)
Possible Cause(s)
Suggested
Solution(s)
ELECTRICAL DIAGRAM
PARTS BREAKDOWN
PARTS LIST
DESCRIPTION
QTY
PART ID
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40

Powerfist 9032244 Le manuel du propriétaire

Taper
Le manuel du propriétaire

dans d''autres langues