In Common With Variania Manuel utilisateur

Catégorie
Accessoires de moto
Taper
Manuel utilisateur
Part A
Backplate
Part E
G9 LED Bulb
Part J
Variania Ceramic Shade
Part B
Canopy Cover
Part C
Hex Key
Part D
Wago Clips (x3)
Part F
Orb 4 Diuser
Part G
Mounting Screws (x2)
Part H
Glass Holder
Part I
Set Screws (x2)
Variania Orb Surface Mount
Assembly Guide incommonwith.com1 of 3
Contents
How to Install Your New Light
Please check that you received all of the components pictured in
this guide. Reach out to us if anything is missing. It’s very rare, but it
happens. Don’t forget to turn o the electrical power source.
Tools you will need that aren’t included: standard wire stripper,
Phillips head screwdriver.
CAUTION
Electrical shock risk. Turn o electrical power at the main fuse box
or circuit panel before beginning installation, servicing the light,
or installing accessories. We recommend working with a qualified
electrician familiar with the type of work youd like done.
ATTENTION
Risque de choc électrique. Coupez l’alimentation électrique au
niveau de la boîte à fusibles principale ou du panneau de circuits
avant de commencer l’installation, l’entretien de la lumière ou
l’installation daccessoires. Nous vous recommandons de travailler
avec un électricien qualifié familier avec le type de travail que vous
souhaitez eectuer.
Variania Orb Surface Mount
Assembly Guide incommonwith.com2 of 3
Step 2: Mount the backplate (A) to the junction box using a phillips head
screwdriver to tighten the mounting screws (G).
!
Step 1: Turn o electrical power at the main fuse box or circuit panel
before beginning installation.
Step 3: Use the wago clips (D) to connect the fixture’s wires to the
corresponding wires from the junction box in the wall or ceiling. White
is neutral; Black is live; Green/ Yellow is ground. One ground wire will be
attached to the backplate (A), the other ground wire should come from the
junction box. If needed use a wire stripper to remove 3/8” of the insulation
from each wire before inserting them into the corresponding wago clip.
Step 4: Align the holes of the backplate (A) with the holes of the canopy
cover (B) and secure the set screws (I) by tightening using the included
L-shaped hex key (C).
A
G
D
B
A
I
C
B
Variania Orb Surface Mount
Step 5: Carefully slide the shade (J) up the socket. Attach shade (J) to
backplate (B) by rotating glass holder (H) until components are fixed in
place.
Assembly Guide incommonwith.com3 of 3
Step 6: Insert lightbulb (E) into the socket of the shade assembly.
Step 7: Screw the diuser (F) into the glass holder (H). Turn the power
back on at the main fuse box or circuit panel you disabled before
installation.
B
J
H
E
F
H
  • Page 1 1
  • Page 2 2
  • Page 3 3

In Common With Variania Manuel utilisateur

Catégorie
Accessoires de moto
Taper
Manuel utilisateur

dans d''autres langues